RCA 25250RE1 Support Question
RCA 25250RE1 Support Question
Find answers below for this question about RCA 25250RE1 - ViSYS Cordless Phone.Need a RCA 25250RE1 manual? We have 1 online manual for this item!
Question posted by danmowen on April 19th, 2011
Switching Phone Over To My Cell
I need to know how to switch my RCA 25250RE1A phone ring to my cell and how to swith it back
Current Answers
Related RCA 25250RE1 Manual Pages
User Guide - Page 4
... 20 centimeters between the radiator and your body. Important Information
Notice: The changes or modifications not expressly approved by UTAM. For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with the belt clip supplied with a minimum distance of other antenna or transmitter."
User Guide - Page 5
... the Phone 11
Switching Between the Speakerphone,
Installing the Handset Battery 11
Handset, and Headset Mode 26
Base Station 12
Base 26
Programming the Phone 14
Cordless Handset ... 3
Set Work Hours 22
Licensing 4
Set After Hours 22
Hearing Aid Compatibility 4
Ring Delay 23
FCC RF Radiation Exposure Statement....... 4
Message Length 23
Information for base).....
...
User Guide - Page 6
...restored to Phone Book Memory ...Phone Book (Directory) Memory 33 Adding Phone Book Entries 33
Storing Record...Phone Book Records 34 Editing a Phone Book Record 34 Copying a Phonebook Record 35 Deleting a Phone Book Record 35 Deleting All Phone Book Records............35 Dialing a Phone Book Record 36 Dial a phone book record while in Talk mode 36 Dial a phone... does not ring 41 You ...
User Guide - Page 7
IMPORTANT: Because cordless phones operate on electricity, you will be followed.
Wall plate Modular
telephone line jack
Line cords
Handset battery pack
For Model 25250RE2 there will need an RJ11C (for a single line) or a RJ14C (for future reference.
If you don't have at least one phone in your home that should have either modular jack...
User Guide - Page 8
...cordless...cause or receive interference with each other cordless telephones or personal computers. •..., multi-handset cordless telephone systems, and some long-range cordless telephone systems.
....
• Avoid areas of the cordless telephone should not be placed near or...; Avoid other and/or your phone line. INSTALLATION NOTE: Some cordless telephones operate at the network interface...
User Guide - Page 11
.... CAUTION: To reduce the risk of the handset. 3.
NOTE: To ensure proper battery installation, the connector is compatible with this unit.
1. Connections & Setup
Installing the Phone Installing the Handset Battery
NOTE: You must connect the handset battery before use only the Thomson Inc. Plug the battery pack cord into position.
11...
User Guide - Page 12
... installed in the user's guide. Connections & Setup
Base Station
The phone may be purchased from the wall jack to the Line 1 + 2 jack on the back of the phone as a desktop or tabletop, or you may look similar to the... can use only the 5-2757 (base) power adaptor listed in your cordless telephone on a level surface, such as shown below.
CAUTION: To reduce risk of the telephone.
User Guide - Page 14
...illuminates, verifying the battery is compromised.
NOTE: If the model you don't properly charge the phone, battery performance is charging.
Please go to give you may program the following items: Date/Time...clock. The base displays the current date, time and the soft keys.
Programming the Phone Standby Screen
The handset displays the handset name and number, date, time, and battery ...
User Guide - Page 15
... base menu, handset Date/ Time should update automatically after it is set Date/Time. From the Phone Setting Menu: 1. Press SELECT soft key. Time "12:00A" shows in the display. 3....call without pressing the Talk/Spk/L1/L2 button. Press the VOL (- Date/Time From the Phone Setting Menu: 1. Programming the Telephone
Area Code (base only), Registration (handset only), De-...
User Guide - Page 16
.... Press the VOL (- Press the VOL (- From the Phone Setting Menu: 1. From the Phone setting Menu: 1. Press SAVE soft key to 10 cordless handsets can be set in the
display. Up to save ...display. Press the VOL (-
Use the VOL (- Press SELECT soft key to handset) A cordless handset will show "PRESS "REG" TO INITIATE REGISTRATION" once the handset has been activated. Press...
User Guide - Page 17
...de-registration. Press YES soft key to your selection. 3. Programming the Telephone
Register From the Phone Setting Menu: 1. If the registration is now in the display. 3. The list of ... the handset is failed (i.e. If the registration is re-registered. for base) From the Phone Setting Menu: 1. WARNING: It is not recommended that a handset be deregistered unless absolutely necessary...
User Guide - Page 18
... More than one character at a time. 4. Press the 7 key 4 times for handset)
From the Phone Setting Menu: 1. Display Setting 1. Press VOL (- Press the 5 key 3 times for base) This function... the 6 key once for the letter L. press the 8 key for the letter H. From the Phone Setting Menu: 1.
Press the VOL (- press the 4 key twice for the letter T; Programming the...
User Guide - Page 19
..." contrast scale shows on BS to go to confirm and you may program the following
items in base and handset: Ring Tone, Ring Volume and Key Tone. or +) button to save your phone is OFF (not in the display.
19
The default setting is English. 4. or +) button to the Contrast. 2. or +) button to...
User Guide - Page 24
...Press SELECT soft key to Restore Setting. 3. Press the VOL (- Telephone Operation Making Calls with the Cordless Handset
1. If both 2 lines.
24 The timer serves for you. -OR- From the Answering... System Menu: 1. Default is required for a dial tone then dial the phone number. 3. Press YES soft key to let unit reset to the original default settings.
Press the ...
User Guide - Page 25
...over
your mouth. 4. Press Headset button (on base) or End button (on top of
the cordless handset. 2. Pre-dialing 1. When finished, press END button.
25 Press the LINE 1 or ...ear. 3. Wait for a dial tone then dial the phone number. 4. Press the Speaker button to speakerphone mode. 3. Press the Speaker button to switch to activate the speakerphone on base only), Speaker button, ...
User Guide - Page 36
..., pressing the button will answer incoming calls or routed calls after X rings (pickup delay set to access the phone book.
3. The number dials automatically. Answering System Operation
There are two... select which mailbox is used to switch this function On or Off with the voice prompt. Answering System Operation
Dialing a Phone Book Record
Dial a phone book record while in the system....
User Guide - Page 41
...phones on your wiring or local service. • The handset may be caused by power failure. If it doesn't work • Did you are subscribed to is connected to the base and the wall jack. • Connect another
household appliance. If no communication between the base and cordless...out of range of phone service you follow proper dialing sequence? Handset does not ring • Make ...
User Guide - Page 42
...keep your local telephone company to a non-switched electrical outlet. Doing so will damage the finish. • Retain the original packaging in case you may need to the standard Name/Number Caller ID service...
from the base and reconnect it. No Caller ID • You must be subscribed to ship the phone at a later date....
User Guide - Page 48
...conference call (Line 1 +
Line 2 + 2 extension)
29
Accessory Information
47
Adding Phone Book Entries
33
Answering a Call
25
Answering an Intercom Call
30
Answering System
20
...Cordless Handset
26
D
Date/Time
15
Deleting a CID Record
32
Deleting a Phone Book Record 35
Deleting All Call Records
32
De-Register
17
Dial a phone book record while in
Talk mode
35
Dial a phone...
User Guide - Page 49
...Cordless
Handset
24
Making Calls with the Optional
Headset
25
Memo Record
37
Memo Recording
37
Memory Full
39
Memory Log and Phone...Phone Book Records 34
Reviewing the Redial Numbers 27
Ring Delay
23
Ring Volume
20
Ringer On/Off and Ringer Volume 28
Index
S
Saving a CID Record to Phone... Record in
Phone Book
28
Storing Record in One-Touch
Dialing
34
Switching Between the
...
RCA Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Troubleshooting the LF-30S Transmitter System
...the same frequency (i.e. Make sure the receiver and transmitter's power adapter cords are both switched on both set to the same channel. Make sure that is on the LF-30S...use connected to stop working what can I do? cordless phone, wireless network, microwave, baby monitor, etc.). For more information on , turn it off switches on both the receiver and transmitter are firmly inserted ... -
Operating and Troubleshooting the RCA WSP150 Wireless Speakers
...the sound cut off automatically in the correct polarity as cordless phones, cell phones and baby monitors are connecting to the audio output jacks... can cause interference . The volume control knob on the speaker is switched off, the ALC will go . Locate the audio input cord... , if necessary. But for my RCA WSP150 You may need to leak. The green LED indicator light will then turn... -
Find Answers
model number tv antennas MP3 will not charge SECURITY CODE FOR CELL PHONES switch password vm9022 dvd player will not load number Customer or Technical Support - I need help Troubleshooting the Jensen VM9311TS Multi Media Receiver Troubleshooting the Jensen VM9312 DVD with LCD Monitor Troubleshooting the Jensen VM9314 Multi Media Receiver
Similar Questions
Cordless Phone Says Out Of Range
I have the RCA 2 line phone and the cordless phone says its out of range , I have a new battery but ...
I have the RCA 2 line phone and the cordless phone says its out of range , I have a new battery but ...
(Posted by towgirl561 8 years ago)
Does This Phone Have The Announcement Only Option?
Does this phone have the Announcement Only option?
Does this phone have the Announcement Only option?
(Posted by mybirdkiwi 8 years ago)
Rca Visys Headset Manual
Help I can't get the system to work. It is plugged in with phone and electricity
Help I can't get the system to work. It is plugged in with phone and electricity
(Posted by Lastonkus 9 years ago)
Manual For Rca 25250re Cordless Phone
Help to get a manual for RCA 25250RE1_A cordless phone please
Help to get a manual for RCA 25250RE1_A cordless phone please
(Posted by aliciajmj 12 years ago)
250250re1-a Speaker Phone
This previously worked and stopped with no plausible explanation. There is no dial tone when attempt...
This previously worked and stopped with no plausible explanation. There is no dial tone when attempt...
(Posted by sandymturner 14 years ago)