Panasonic KX-TGA520 Support Question
Panasonic KX-TGA520 Support Question
Find answers below for this question about Panasonic KX-TGA520 - 5.8 GHz FHSS Cordless Expansion Handset.Need a Panasonic KX-TGA520 manual? We have 2 online manuals for this item!
Question posted by jagert on July 15th, 2013
Phone Says No Link To Base Will Work Sometimes But Dies Changed Battery
How to reset phone for above question no link to base move closer and try again, phone is very close to base receives calls but dies when trying to talk,battery is fully charged locater for phone works Call from base have tried disconnecting both wires and reconnecting no luck is there something I am missing in the menu?
Current Answers
Related Panasonic KX-TGA520 Manual Pages
KXTG5230 User Guide - Page 1
... caller's name and phone number, you must subscribe to Caller ID service.
Charge the battery for customers in the USA or Puerto Rico KX-TG5230
Pulse-or-tone dialing capability
The unit is Caller ID compatible. Panasonic World Wide Web address: http://www.panasonic.com for 6 hours before initial use.
5.8 GHz Expandable Cordless Phone System
Operating Instructions...
KXTG5230 User Guide - Page 3
... 1. Expanding Your Phone
KX-TG5230 includes one handset and one base unit. To order, contact your dealer or call 1-800-211-PANA(7262) to the base unit. (Please read the accessory handset's Installation Manual.)
For assistance, please call: 1-800-211-PANA(7262)
3 A charger is included with each to locate a dealer.
A maximum of the accessory handsets are KX-TGA520 and KX-TGA523.
The...
KXTG5230 User Guide - Page 12
...) 4
CHARGE Indicator
Battery strength Fully charged Medium Low
Needs to the right. Replace the old battery with a new one (p. 13).
Battery strength
You can confirm the battery strength on the cover firmly and slide it snaps into the compartment (2). Battery strength is displayed if there are no new calls in the chart to be recharged.
Battery Charge
Place the handset on the base...
KXTG5230 User Guide - Page 13
... is in Standby mode.
• Clean the charge contacts of continuous talk time, or keep the battery fully charged at the telephone number shown on the
base unit when the handset is displayed and/or "3" flashes. "3" flashes, or - Continue charging. "Recharge battery" is subject to 11 days (if no
phone calls are displayed, the battery may be
shortened. Please order a new...
KXTG5230 User Guide - Page 15
... p. 56 Set line mode p. 17
Set base unit
Registration Change language p. 16
Ringer tone Incoming call : 1-800-211-PANA(7262)
15 Room monitor Talk Caller ID
p. 20 p. 57 p. 49 ...handset. For assistance, please call .
Main menu
Sub-menu I
Sub-menu II
Ringer setting
Voice enhancer p. 24 Copy phone book Talk Caller ID p. 28 Initial setting
Ringer volume p. 18 Ringer tone p. 19 Incoming call...
KXTG5230 User Guide - Page 42
...
Intercom calls can be made between a handset and the base unit, and between Handset 1 & Base unit
Intercom 00-00-05 D01
From Base Unit
Using this feature, you can also locate a misplaced handset.
1 Press [LOCATOR/INTERCOM/TRANSFER].
• The LOCATOR/INTERCOM/TRANSFER and SP-PHONE indicators light.
2 To page all handsets (Voice Paging, p. 44).
Press extension# to the receiver, press...
KXTG5230 User Guide - Page 43
...-PANA(7262)
43 if using the base unit, press [SP-PHONE] twice. Base calling
Call from HS[2]
2 To disconnect the intercom, press [OFF].
• If the Auto Talk feature is being received, you can also answer a page by simply lifting the handset off (p. 18, 19), the handset and the base unit will flash rapidly. Handset 2 calling
Call from Base
Ex. The display shows the...
KXTG5230 User Guide - Page 48
... pressing the soft key ( CONF ) on the handset or [CONF] on the base unit.
• One more extension can join the conversation and establish a conference call .
• To leave the conference, press [OFF] on the handset or press [SP-PHONE] on (p. 54). Internal communications between extensions are talking with an outside party can take part in...
KXTG5230 User Guide - Page 53
... access number (p. 51) in speakerphone mode.
• If the base unit beeps 3 times, a voice mail access number is not in use.
For assistance, please call: 1-800-211-PANA(7262)
53 To listen to your message(s), " V M " stops flashing but remains on (p. 21) and the handset is not stored. To store the number, see page...
KXTG5230 User Guide - Page 61
... cord. For assistance, please call: 1-800-211-PANA(7262)
61
Preparation
Wall Mounting
4 Adjust the adaptor to hold the base unit, then push it in the direction of
the arrow until it down.
• Raise the antennas. Telephone System Answering System Useful Information
6 To charge the handset battery:
Place the handset on the base unit.
• The...
KXTG5230 User Guide - Page 66
... previous base unit, see page 3. If you tried to [4] ( ) that base unit's memory. For the KX-TG5230 base unit: (1) Press and hold [LOCATOR/ INTERCOM/TRANSFER] for 3 seconds, and (2) Press and hold [LOCATOR/INTERCOM/TRANSFER] for this base unit are not being used. Canceling Registration/Re-registration
Make sure the base unit and the other handsets are KX-TGA520 and KX-TGA523...
KXTG5230 User Guide - Page 67
....
Fully charge the battery (p. 12).
Try again later.
• Another handset tried to send phone book items to register or deregister the handset, the handset and base unit could not link for 6 HRS • The battery has been discharged. System is using the handset and/ or base unit, such as interference from electrical appliances.
Walk closer to the base unit, and try...
KXTG5230 User Guide - Page 69
... Your Display..." (p. 67-69) for KX-TG6500 base unit. Move closer to
base and try again. • The handset has not been registered to manual
Cause & Remedy
• This handset is not for this base unit. Re-register the handset (p. 65, 66). Register the handset (p. 66, steps 5 and 6). • Re-install the battery (p. 12) and fully charge it . Interference from other electrical units...
KXTG5230 User Guide - Page 70
... more than one other user is blank, fully charge the battery (p. 12). Troubleshooting
Problem
Cause & Remedy
The handset display is blank. • If the handset display is using the handset and/or base unit, you may not be able to make a call. If another number has been dialed first, it and try again. • Other electrical appliances connected to...
KXTG5230 User Guide - Page 71
... try again. • You need to press [C] or [s] after the battery has been charged. and "Inc.". • Caller ID supports names of abbreviations, such as "Co." The handset and/or base unit does not announce the displayed caller's name properly. The handset display exits the Caller List or phone book. "Charge for over 60 seconds while searching. • Fully charge...
KXTG5230 User Guide - Page 75
... may not be connected to make changes in the format US:ACJ-----. For...have questions about what will be certain of the number of devices that temporary discontinuance of this phone. ...wiring and telephone network must accept any interference received, including interference that may not cause harmful ... EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS: 1) Remain on the...
KXTG5230 User Guide - Page 78
...handset 3 Answering calls, base unit 26 Answering calls, handset 26 Auto talk 17, 26, 43
B Backlit LCD 24 Base unit location 6 Battery charge 6, 12
− Battery information 13
Battery replacement 12, 13 Battery strength 12 Belt clip 59
− Booster 24
C Call share 48 Call Waiting Caller ID display. . . . 55 Call...(Conference 48 Conference calls 48
− Copy phone book 39
D ...
H/s For Tg52xx Serie - Page 1
...-5368. KX-TGA520
Installation Manual
PLEASE READ BEFORE USE AND SAVE. Please read the base unit operating instructions for use .)
Install the battery
Insert the battery (1), and press it down until it snaps into the compartment (2). HHR-P104
A Belt Clip one
Order No. This handset is normal for the adaptor to start up the handset. 5.8 GHz Expandable Cordless Handset
Model...
H/s For Tg52xx Serie - Page 2
... fully charged, you place the handset on the charger.
Charge Contacts CHARGE Indicator
• If the battery has been discharged, the handset will not work unless the
battery is displayed on the handset, - Continue charging. Otherwise the battery may not charge properly. B A
- 2 -
Belt Clip
You can expect the following performance:
Operation
Operating time
While in use (TALK...
H/s For Tg52xx Serie - Page 3
... Charge the battery fully. Have both the handset and base unit nearby during registration.
*LOCATOR Button
1[-]
Press LOCATOR
on the base unit. • If you try to register this handset are not being used. Then press OKL
BACK PLAY O K
1 Base unit: Press and hold the *LOCATOR button for this handset to the KX-TG6500 base unit, "Wrong handset Refer
to a KX-TG5200/KX-TG5202/KX-TG5210/ KX...
Similar Questions
We Boughta New Cordless Panasonic Kx-tgc220 My Problem Is That I Can Get Phone C
(Posted by Anonymous-163468 6 years ago)
Phone Line Won't Disconnect--
i unplugged the line and the electrical source for two minutes. there are two lines in the base but ...
i unplugged the line and the electrical source for two minutes. there are two lines in the base but ...
(Posted by susanbrown77 9 years ago)
Screen Does Not Show Any Text. I Get Dial Tone.
The model is: Panasonic telephone KX TGA 520CM 5.8 GHz The Ni-Mh 830Mah Ne battery was replaced on D...
The model is: Panasonic telephone KX TGA 520CM 5.8 GHz The Ni-Mh 830Mah Ne battery was replaced on D...
(Posted by bgoldsmith 12 years ago)
