Memorex MA4203BK Support Question
Memorex MA4203BK Support Question
Find answers below for this question about Memorex MA4203BK.Need a Memorex MA4203BK manual? We have 1 online manual for this item!
Question posted by alexisweintraub on February 25th, 2012
Clock Does Not Keep Time
Hi, I purchased this alarm clock but the clock does not keep on time. It loses a minute every couple days making it not useful as an alarm clock.
i would like to return this clock for a refund. I did not save the box/receipt.
Can you please tell me how I can return this product?
THank you!
Lexi
Current Answers
Related Memorex MA4203BK Manual Pages
User Guide - Page 2
... BACK). ATTENTION:
The exclamation point within an equilateral triangle is made. The user could lose the authority to persons. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE ... lightning flash with arrowhead symbol within the product's enclosure that may generate or use radio frequency energy. FCC WARNING: This equipment may be of sufficient magnitude to constitute a ...
User Guide - Page 3
... adapter should be determined by turning the equipment off and on the product.
2
Do not expose the product to
which can radiate radio frequency energy and, if not installed and used in a particular installation. SURGE PROTECTORS: It is located at the bottom of the following measures: • Reorient or relocate the receiving...
User Guide - Page 4
Follow all servicing to qualified service personnel. Do not install near water. 6. type plug. Only use caution when moving the cart/ apparatus combination to rain or moisture. Install in any of time. 14. Do not defeat the safety purpose of the obsolete outlet. 10. Servicing is required when the apparatus has been damaged...
User Guide - Page 5
Play/Pause (®p)/ RECALL
STATION Button 3. TUNING/Skip/Search Up
(n) Button 5. ALARM 1/2 Button 10. SOURCE Button 2. SET Button 9. iPod/iPhone Compartment
with Connector
4 Power/ALARM RESET Button 4. SNOOZE/DIMMER Button 7. VOLUME Up (+) Button 11. iPod Dock Close Button
(rear of compartment) 14. VOLUME Down (-) Button 13. Display
8. Dock Release Button ...
User Guide - Page 6
... Antenna
*Consumer Replaceable Part (See page 21 to disconnect the AC
adapter when not in use.
• Use only the supplied AC adapter which has the following specs:
DC 5V Z
• If there is a power failure, the clock will be reset.
5 AC Adapter, DC 5V Z
NOTES:
To DC IN Jack
• Remove both...
User Guide - Page 8
...
will appear in the display. You can operate the iPod/iPhone using its own controls, as per its owner's manual, or you can use the controls on your iPod/iPhone. CONTINUED ON THE NEXT PAGE ...track, previous or next track. To skip forward or backward on by pressing the Power/ALARM RESET button 1. OPERATION
USING AN iPod/iPhone WITH THIS UNIT
1
12
2
With an iPod/iPhone connected (see previous...
User Guide - Page 9
...the call for the iPhone, the music will resume playing. USING THE FM RADIO - With the power off , press the Power/ALARM RESET button. • While there is an incoming call ,... selected prior to confirm.
• R1: USA • R2: Europe, Austria • R3: Japan
RADIO REGIONS - SETTING THE RADIO REGION
1
1
23
This unit allows you to increase or
decrease the volume. FM Region 1: USA
87....
User Guide - Page 10
... appear in the
display.
312
Repeatedly press the TUNING/ Skip/Search Down o 1 or Up n 2 button to select the FM Radio
mode; OPERATION (CONTINUED)
USING THE FM RADIO
1
2
Turn this unit off, press the
Power/ALARM RESET button.
FM Antenna: Unravel and extend the FM wire antenna for how
to scan, and then release. For...
User Guide - Page 11
...
2
1
Follow Steps 1-3 on the previous page to select and tune in the desired Preset (1-6).
10 RETRIEVING THE SIX RADIO PRESETS
1
2
Follow Steps 1-2 on and select the FM Radio mode. the Preset Number will be saved into memory. While the Preset Number is blinking, press the VOLUME Up (+) 1 or Down (-) 2 button to turn the...
User Guide - Page 12
... • To turn this unit's speakers. will be heard through this unit off, press the Power/ALARM RESET button. • If you wish to listen to the iPod/iPhone in the iPod compartment,
repeatedly... the AUX mode; Repeatedly press the SOURCE button 2 to select iPod/iPhone mode;
OPERATION (CONTINUED)
USING AN EXTERNAL UNIT
1
2
12
Insert one end of the audio cable (not included) into the ...
User Guide - Page 13
... current minute. CONTINUED ON THE NEXT PAGE 12 NOTE: If set to 12 hour in the previous step, be sure to observe the AM or PM indicators to set the current year. Within ten seconds, press the TUNING/Skip/ Search Down o 2 or Up n 3 button to make sure you have set the time with...
User Guide - Page 14
... SET button 1;
the month will blink. ten seconds) and the time and date will be set automatically.
7
NOTE: If there is a power failure, the clock
will also be reset. the date will blink. NOTE: When the date is set, the correct day of the week will be set .
13 Within ten seconds, press...
User Guide - Page 15
.../iPhone as shown on your device is updated to your current time zone. We recommend that the system clock on page 7.
NOTES: • This unit can automatically sync the time
with the iPod/iPhone at the first time.
the minutes will blink. The time and day of the week will then be docked onto the unit before...
User Guide - Page 16
... or Up n 2 button to set the alarm minute. Press the SET button 3;
the volume level will blink. the day will blink.
OPERATION (CONTINUED)
3 12
...3
4 12
3
Within ten seconds, press the TUNING/Skip/Search Down o 1 or Up n 2 button to set the
source (iPod/iPhone, FM Radio or Buzzer). the Source
will then be set the
maximum alarm...
User Guide - Page 17
... off the iPod/iPhone.
NOTES: • When the alarm time is sounding, if the other alarm reaches the alarm time, the first alarm will stop . If set to the frequency that you selected, and will play for 60 minutes then turn off . The unit will just playback the remaining time of the playlist and then stop sounding and...
User Guide - Page 18
.... Press once again to cancel the alarms,
and both alarms; will be set
for the next day. will
appear in the display. OPERATION (CONTINUED)
TO SHUT THE ALARM OFF
1
Press the Power/ALARM RESET button to turn off.
17
Press the
ALARM 1/2 button a third time to activate Alarm
2;
TO ACTIVATE/DEACTIVATE AN ALARM
1
With the power off, press the...
User Guide - Page 19
....
The SNOOZE function will turn back on automatically ten minutes later. The alarm will remain active for a total of the SNOOZE time is sounding, press the SNOOZE/DIMMER button; NOTE: To cancel the SNOOZE function (the alarm will not turn back on ), press the Power/ALARM RESET button (the SNOOZE indicator will appear in the...
User Guide - Page 20
... the Sleep function, press the Power/ALARM RESET button to turn off , repeatedly press the SNOOZE/DIMMER button to decrease the display brightness to the desired level. There are five levels of brightness to select the desired Sleep time (10, 20, 30, 40, 50, 60, or 90 minutes). Repeatedly press the TUNING/Skip...
User Guide - Page 21
... before calling for service. Volume is not on pages 14-17. Clock is set . Volume is not set to minimum. Time reset to turn the power on . Press the Power/ALARM button to "12:00" Power outage occured.
Station is not extended. FM Radio, poor sound.
Not in iPod/iPhone mode. Press SOURCE button...
User Guide - Page 22
... FULFILLMENT CENTER AT 1-800-379-8439.
21 SPECIFICATIONS
GENERAL: Power Source DC 5V Adapter (Center Positive) Speaker 4 ohms Output Power 2W Weight 0.8 lbs Dimensions 2.6 (L) x 3.2 (W) x 4.9 (H) inches RADIO SECTION: Frequency Range (FM) Region 1 (USA 87.5MHz to 108MHz Region 2 (Europe, Austria 87.5MHz to 108MHz Region 3 (Japan 76MHz to 108MHz
Specifications are subject...
Similar Questions
Memorex Mi4390blk Clock Radio For Ipod How To Set Time
(Posted by DownlElen 10 years ago)
How Do I Turn The Alarm Off On My 4203bk Memorex Clock Radio
(Posted by wendyzippi 12 years ago)
My Clock Will Not Keep The Correct Time Once It's Set, Loses About 30 Min/hr.
My MC7101 works perfectly except once the time/clock is set for the current hour and minutes, it con...
My MC7101 works perfectly except once the time/clock is set for the current hour and minutes, it con...
(Posted by czitzloff 12 years ago)