Maytag MEDC200XW Support Question
Maytag MEDC200XW Support Question
Find answers below for this question about Maytag MEDC200XW.Need a Maytag MEDC200XW manual? We have 2 online manuals for this item!
Question posted by RickOrr60 on July 26th, 2013
Maytag Electric Dryer Model Med5700tqo Manual
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by sabrie on July 26th, 2013 6:01 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
Hi there. just click on this link.
http://www.google.com/url?q=http://specs.retaildeck.com/CACHE/FILE15704.PDF&sa=U&ei=uBrzUe7SF_Dz0gWF3IHQAw&ved=0CB0QFjAD&sig2=NYOlZzKCF8j1xZMEPZlajg&usg=AFQjCNGoAKvb1M0oW1K11wfZysizWSItQQ
http://www.google.com/url?q=http://specs.retaildeck.com/CACHE/FILE15704.PDF&sa=U&ei=uBrzUe7SF_Dz0gWF3IHQAw&ved=0CB0QFjAD&sig2=NYOlZzKCF8j1xZMEPZlajg&usg=AFQjCNGoAKvb1M0oW1K11wfZysizWSItQQ
www.techboss.co.za
Related Maytag MEDC200XW Manual Pages
Owners Manual - Page 2
DRYER SAFETY
2
Owners Manual - Page 4
....
n Remove lint from the dryer. The venting system attached to efficiently dry laundry.
The Energy Preferred cycle will reduce your drying times and improve your dryer for the occasional damp load that...
Maintain good air flow by the customer, regardless of vent possible. With Timed Dry, the dryer runs the amount of time set and sometimes results in good air flow. n Use no...
Owners Manual - Page 5
.... CONTROL PANEL & FEATURES
1
2
3
1
3
Not all models. Gives the best drying in your dryer. It periodically starts and stops the dryer, tumbling the load without heat to start the dryer.
5
NOTE: A signal will stop this feature. On models with a selectable temperature knob, you are available on the fabrics in your laundry load.
Opening the door will sound...
Owners Manual - Page 6
...sheets, blouses, dresses, underwear, permanent press fabrics, and some knits.
Not all models.
Will run the dryer for foam, rubber, plastic, or heat-sensitive fabrics. Setting the Drying Temperature
If...for that cycle. If loads seem drier than the higher setting.
Senses moisture in your dryer has multiple heat settings:
A High Heavy temperature setting may be used for a load...
Owners Manual - Page 7
... the lint screen before operating this dryer. NOTE: Your model may have drop down doors. Place laundry in the dryer. Do not tightly pack the dryer; Do not rinse or wash screen to tumble freely.
7
Some models have a different door than the one shown. Pull the lint screen out of fire, electric shock, or injury to remove...
Owners Manual - Page 8
... "Setting the Drying Temperature".
8 Select End of the manual or contact the dealer from whom you may want to dryness level. ...RACK
To purchase a drying rack for loads you purchased your dryer, please refer to complete drying. SENSOR DRY/AUTOMATIC DRY Cycles ... drying cycle is finished. Drying time varies based on some models)
Turn the END OF CYCLE SIGNAL knob to begin the cycle...
Owners Manual - Page 9
This includes clearing piles of laundry in the dryer.
Pull the lint screen out of clothes. Cleaning the dryer interior
To clean dryer drum 1. From the Exhaust Vent Lint should be removed every 2 years, or more often, depending on dryer usage. Push the lint screen firmly back into the dryer during removal, check the exhaust hood and...
Owners Manual - Page 10
... screw.
4. Plug into a grounded outlet or reconnect power. Disconnect wiring. 3. If you will be on some models)
1. Unplug dryer or disconnect power. 2. (For gas dryers only): Close shut-off valve in gas supply line. 3. Open the dryer door. Turn bulb counterclockwise. Cap the open fuel supply line. 5.
Unplug the power supply cord. 2. Changing the...
Owners Manual - Page 11
... exhaust vent is a normal operating sound. Check with a qualified electrician.
11 Electric dryers use it only once. For gas dryers, the valve is open . Exhaust vent diameter not the correct size.
Use ...valve not open on the supply line. Electric dryers require 240-volt power supply. Separate the load to vibrate.
http://www.maytag.com/help -
Clean out pockets before each...
Owners Manual - Page 12
...maytag.com/help - Level the dryer. Use Timed Dry for the first time.
Add dryer fabric softener sheets at the end of the cycle.
If so, ventilate the area. Laundry items were removed from the dryer before removing laundry from dryer...of a service call...In U.S.A. Dryer tightly packed.
Odors
You have an odor.
Load is too hot
The electric dryer is located. A high temperature ...
Owners Manual - Page 13
...or installation instructions.
2. Dealer name Address Phone number Model number Serial number Purchase date
13 MAYTAG® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of...electrical or plumbing codes, or use of products not approved by Maytag.
5. Cosmetic damage, including scratches, dents, chips or other than normal, single-family household use your complete model...
Installation Instructions - Page 2
... immediately follow instructions. This symbol alerts you to reduce the chance of others .
DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential ...either the word "DANGER" or "WARNING."
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
Tools needed:
Flat-blade screwdriver...
Installation Instructions - Page 3
.... The combined weight of a companion appliance should also be exposed to water and/or weather.
Check existing electrical supply and venting, and read "Electrical Requirements" and "Venting Requirements" before purchasing parts.
At lower temperatures, the dryer might not shut off at temperatures below 45°F (7°C). Location Requirements
Tape measure
Pliers
Level
Caulking...
Installation Instructions - Page 4
...;■ Do not use an extension cord.
■■ If codes permit and a separate ground wire is used when the dryer is installed with equivalent ventilation openings are required. The National Electrical Code requires a 4-wire power supply connection for wall, door, and floor moldings.
■■ Additional spacing of 1" (25 mm) on...
Installation Instructions - Page 5
...Weight Hazard Use two or more people to connect the exhaust vent.
5 Now stand the dryer on cardboard.
2. If using a power supply cord:
Use a UL listed power supply cord... relief.
Failure to its feet. Prepare dryer for electrical connection and to move and install dryer. Screw legs into leg holes by a white
cover. Slide the dryer until diamond marking is close to do not...
Installation Instructions - Page 7
... ground wire (E) and neutral wire (white or center) (C) of 3-wire connections. A
B
F
C D
Remove the screws from external ground conductor screw (A).
4. Ground prong D. Spade terminals with the dryer cabinet and be in place. For 4 wire Power Supply Cord Connection, continue to hold in a horizontal position. Tighten strain relief screws just enough to step...
Installation Instructions - Page 8
...screws. Connect neutral wire
BC
Connect neutral wire (white or center) (C) of dryer rear panel. Remove center screw
B
Connect remaining wires to center, silver-colored ...hold -down screw. Tighten screws. Connect ground wire
A
F Connect ground wire (F) (green or bare) of dryer rear panel. Tighten screw.
6. Neutral prong D. Neutral (white or center wire)
3. Secure cover with hold...
Installation Instructions - Page 9
..., facing to strain relief
(127
5" mm)
Direct wire cable must have a tight fit with the dryer cabinet and be moved if needed. The strain relief should have 5 ft. (1.52 m) of the ..., squeeze hooked end together and tighten screw.
5.
Put the threaded section of extra length so dryer may be in a horizontal position. Prepare to terminal block
Put direct wire cable through the hole...
Installation Instructions - Page 14
... that will :
■■ Shorten life of dryer.
■■ Reduce performance, resulting in Vent system chart. Run vent to dryer location using elbows or making turns, allow as much...use caulking compound to seal exterior wall opening around exhaust hood.
2. Vent System Chart (Long Vent Models Only)
Number of 90° turns or elbows
Type of vent
Box/louvered, or Angled hoods
0...
Installation Instructions - Page 15
... location. q Remove film on console and any dust.
Avoid crushing or kinking vent. Once legs are set in dryer. q For power supply cord installation, plug into an outlet and/or electrical supply is on a full heat cycle (not an air cycle) for
20 minutes and start , check the following: ■■ Controls...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dryer does not heat - Electric dryer
...Air Only temperature option? Gas dryer FAQs Knowledgebase search tips My dryer will not start Damp loads or long drying times - Dryer does not heat - Loads are damp; Enter Model Number How do I find my model number? Dryer Electric dryer My electric dryer does not heat. Electric dryers use 2 household fuses or circuit breakers. dryer does not dry Dryer does not heat - Expect loads... -
Loads are damp; dryer does not dry
...Electric Dryer Dryer...the current drying setting. Gas dryer Damp loads or long drying times...dryer clothes, approximately 30% more drying time) The Dryness level settings cannot be changed while the dryer is running. Dryer Poor drying performance - Dryers... seconds. The dryer will beep, and... Dryer does not heat - Gas Dryer ... the dryer does not dry. Dryer For dryers with digital... -
My dryer or load has an odor
... the washer at the end of the wash cycle to avoid odors. Was a damp or wet load left in the washer or dryer for the first time? (Electric dryers) A new electric heating element may have an odor. My dryer makes sounds or vibrations Fabric is located? The odor is on the load because the...
Similar Questions
Which Dryer Vent Kit Do I Need For Maytag Model Medc200xw
(Posted by gefvla 10 years ago)
Maytag Epic Electric Dryer, Model# Med9700sq - Not Heating
My Matag Epic Electric Front Load Dryer (model # MED9700SQ, is not heating up. The drum turns and ev...
My Matag Epic Electric Front Load Dryer (model # MED9700SQ, is not heating up. The drum turns and ev...
(Posted by Anonymous-122272 10 years ago)
I Have A Maytag Front Loading Electric Dryer Model Med9600 Sq0. When I Attempt T
I have a Maytag front loading electric Dryer model MED9600 SQ0. When I attempt to start it by pressi...
I have a Maytag front loading electric Dryer model MED9600 SQ0. When I attempt to start it by pressi...
(Posted by wrzimmerly 10 years ago)
My Maytag 3000 Electric Dryer Is Stating An Error Code Of Cf1, Cf2, And Cf3 Help
I have already checked the lint screen, lint hoses and all are clear. I have also unplugged and re...
I have already checked the lint screen, lint hoses and all are clear. I have also unplugged and re...
(Posted by laura1260 11 years ago)