Kenwood KDC-108 Support Question
Kenwood KDC-108 Support Question
Find answers below for this question about Kenwood KDC-108.Need a Kenwood KDC-108 manual? We have 1 online manual for this item!
Question posted by Anonymous-150430 on April 5th, 2015
How To Sync A Remote
deck is a kenwood kdc-108 and the remote is a rc-405
Current Answers
Answer #1: Posted by sabrie on April 5th, 2015 9:16 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
download the manual on the link below, it will give you full instructions.
www.techboss.co.za
Related Kenwood KDC-108 Manual Pages
Instruction Manual - Page 1
...~">"'\~l1l~'~~l~t.~'I/~1l\1.1~\~~~ai~,~~~w I'~.~"i~~~'\"~~' It.~~r,I ;~"~~~"~i j~\\j;t"\W~'i":::'\:~;i!uj il_~!' Model KDC-148/ KDC-108/ KDC-MP148CR Serial number
_
US Residents Only
Register Online
i;\~~";~~:r"¥":.:'~:~\h~I~\~,1~'''I~I t~:~;~~~~§m\.~;/
~~!~~\i.'\1~
~' ~.~!i~
1
~~~;1j
© 2010 Kenwood Corporation All Rights Reserved.
Familiarity with installation and...
Instruction Manual - Page 2
...AUDIO DIOITAL AUDIO nlOlTAL l;iijliM1mtil fleWritabl4!.
• The illustrations in this case, remove the disc and wait for the moisture to make sure that you purchase external components, check with your Kenwood.../detach the faceplate How to reset your unit How to prepare the remote controller
(RC-405)
Basic operations
4
Getting started
6
Canceling the display demonstration Setting the...
Instruction Manual - Page 3
Reset button
The unit returns to prepare the remote
controller (RC-40S)
When you use . Dispose of used . How to attach/detach...to direct sunlight, excessive heat, or humidity. Attempt to insert using an adapter can be used batteries promptly. Remote controller (RC~40S) is pressed.
Danger of explosion if the battery is a precision piece of equipment and can cause malfunction....
Instruction Manual - Page 4
... a cotton swab or cloth. on the disc, or use a disc with tape stuck on the connector of the unit and faceplate. Basic operations
Loading slot
Remote sensor • Do not expose to observe this unit, pull them out horizontally. • Remove the rims from the center of the disc. • Do...
Instruction Manual - Page 5
...phone call
To use this feature, connect the MUTE lead to your telephone using the remote controller.)
• Changes the display information. • Scrolls the display information if ...commercial telephone accessory. (page 13)
When a call comes in clock display screen.
AUD Enters [AUDIO CTRL] settings directly. "CO" is selectable only
when a disc is ready, playback also starts...
Instruction Manual - Page 6
... volume knob to finish the procedure. See table below for optimum performance.
6 KEY BEEP ON*/ OFF: Activates/deactivates the keypress tone. Press ~ / ~ to move between audio file disc and music CD. ; 2: Forces to finish the procedure.
ON2: Outputs sound from the connected external component when"AUX" is selected as the source...
Instruction Manual - Page 7
... make a selection, then press to finish the procedure. MANUAL: Manually search for astation.; AUTO MEMORY YES: Automatically starts memorizing 6stations with good reception. ;
Using the remote controller (RC-40S)
FM+ / AM- : Selects band.
~ I ~ (+) : Selects station.
1- 6
: Selects preset station.
7 See table below for a station.
SEEK MODE
Selects the tuning mode for [PRESET TYPE...
Instruction Manual - Page 8
... number button 2 (SCAN) repeatedly to select "ALL RANDOM" only if"RANDOM OFF" is available.
8
Audio CD : TRAC (track) SCAN, SCAN OFF MP3IWMA: FILE SCAN, SCAN OFF • If scan play is...4 (REP) repeatedly to turn on . the display indicates that preceded/next folder is selected initially.
Audio CD : TRAC (track) REPEAT, REPEAT OFF
MP3IWMA: FILE REPEAT, FOLD (folder) REPEAT, REPEAT ...
Instruction Manual - Page 9
...
3 Press ~ I ~ to adjust the volume. I ~ (+) : Selects track/file. Although the audio files are complied with the standards listed above, the play maybe impossible depending on the external component and start ...Turn on the types or conditions of media or device. Using the remote controller (RC-405)
In playback mode:
FM+ I AM- : Selects folder.
~ I T : Selects folders/files.
~
:...
Instruction Manual - Page 10
... Cancels.
DETAIL SET LPF SUB-W: THROUGH*: All signals are sent to any source except in MP3/WMA audio compression. ; SUB-W PHASE: REV (180°)/ NORM (00)*: Selects the phase angle of (Preset:.... • Press ~ to return to the previous item. 4 Hold ~ to finish the procedure.
[AUDIO CTRL] : While listening to the subwoofer. ; 85Hz/120HZI 160HZ: Frequencies
higher than [THROUGH] is selected...
Instruction Manual - Page 11
... is not operating properly.
"TOC ERRORII appears. The unit is not correct. "ERROR 9911 appears.
IIREADINGII keeps flashing. Elapsed playing time is playing an unsupported audio file.
Instruction Manual - Page 12
...ACC position, connect the ignition wires to the car's chassis again after the use your Kenwood dealer.
12 For safety's sake, leave this work if you connect the ignition wire to...
® Faceplate
(xl)
® Escutcheon
(xl)
© Mounting sleeve
(xl)
@ Casing for faceplate
(KDC-148/ KDC-MP148CR only)
(xl)
® Wiring harness
(xl)
® Removal tool
(x2)
® Flat head ...
Instruction Manual - Page 13
... terminal in the vehicle. Brown (Mute control wire)
To the terminal that is grounded when either the telephone rings or during conversation. (To connect the Kenwood navigation system, consult your navigation manual.)
Red (Ignition wire)
Yellow (Battery wire) r
Black (Ground wire) To the metallic body or chassis of the car
Car...
Instruction Manual - Page 15
...
FM tuner section
Frequency range: For KDC-l481 KDC-108: 200 kHz space: 87.9 MHz For KDC-MPl48CR:
107.9 MHz
50 kHz space: 87.5 MHz - 108.0 MHz
Usable sensitivity (S/N= 26 dB):...(1 kHz): 105 dB Dynamic range: 90 dB MP3 decode: Compliant with MPEG-1 12 Audio
Layer-3 WMA decode: Compliant with Windows
Media Audio
Audio sedion
Maximum output power: 50 W x 4 Full bandwidth power (at less than 1%THD...
Instruction Manual - Page 16
... as to Part 15 of the FCC Rules.
However, there is not installed and used in accordance with the instructions. This symbol mark indicates that Kenwood manufactured this equipment if an unauthorized change or modification is connected. • Consult the dealer or an experienced radioffV technician for a Class B digital device, pursuant...
Instruction Manual - Page 18
..., despesas de Irete, seguro eembalagem sao de responsabilidade do produto. Tel: 0800-7117270
www.kenwood.com.br Damage, deterioration or malfunction resulting trom: a. Installation or removal of nature, misuse... service, you must include acopy of shipping charges is enforceable only by Kenwood. d. KENWOOD USA CORPORATION
WHO IS PROTECTED This warranty is discussed in the next section...
Instruction Manual - Page 20
...Kenwood Service
Center in accordance with the visual inspection of the authorized Kenwood Service Center: • Improper maintenance or repair, including the installation of any defect in its audio...include damages of parts or accessories that is not listed please contact your Kenwood products, or KENWOOD ELECTRONICS DEUTSCHLAND GMBH: Rembrucker-Str. 15, 63150 Heusenstamm, Germany Tel.: ...
Similar Questions
Kenwood Kdc-108 Wiring
How Do I Wire My Kenwood Kdc-108 Head Unit To My 2003 Silverado Stereo Wiring?
How Do I Wire My Kenwood Kdc-108 Head Unit To My 2003 Silverado Stereo Wiring?
(Posted by svidra85 2 years ago)
