Humax F2-1002/7002 Support Question
Humax F2-1002/7002 Support Question
Find answers below for this question about Humax F2-1002/7002.Need a Humax F2-1002/7002 manual? We have 1 online manual for this item!
Question posted by daverabe on September 19th, 2014
Hd Saterlite Transmissions
Can a HUMAX F2-1002 SATERLITE RECEIVER RECEIVE hd TRANSMISSIONS. i REPROGAMMED FOR TBN Christian tv and it now says they are scrasmbled. I was receiving them before the latest upgrade to HD.
Current Answers
Related Humax F2-1002/7002 Manual Pages
User Manual - Page 2
Nagravision is a registered trademark of Dolby Laboratories.
**
Thank you for purchasing a HUMAX satellite receiver. Keep this user manual next to your recorder for direct, indirect, accidental, necessary and other damage due to your offer or use and maintain the receiver at maximum performance. Conax is a trademark of Philips Electronics N.V. Please read this document is a ...
User Manual - Page 4
...receiver has been manufactured to comply with SABS 061. MAINS SUPPLY
**
90 - 250V AC 50/60Hz
**
Operate your local power company. In addition, no solvents) to do so can damage the TV.
**
9. CLEANING
**
Disconnect the product from the satellite...buried in electric fire or shock.
**
3.
Disconnect the receiver from the satellite dish. OVERLOADING
**
Do not overload a wall outlet, ...
User Manual - Page 7
... GB20 GB20
GB21 GB21 GB21 GB21 GB22 GB22 GB24
GB27 GB27 GB27 GB28 GB31 GB34
GB 6 Setup
**
2.1 Connecting the Antenna 2.2 Powering On
3. Before Using the Receiver
**
1.1 Package Contents 1.2 Front Panel 1.3 Rear Panel 1.4 Remote Control
2.
User Manual - Page 10
Before Using the Receiver
** This chapter provides detailed instructions on the product and its accessories.
1.1 Package Contents
Please check all package contents before using your product.
**
F2-1002
**
F2-7002
**
Remote Control Unit (1) User's Manual (1)
Batteries (2)
**
Note: Since faults may occur if the remote controller is left without a battery for a long time, always keep the ...
User Manual - Page 11
....
**
7. Display
**
Turns on green light when it is in operation.
**
F2-7002
**
1. CH - / CH +
**
Moves the TV/Radio channel up/down.
**
4. VOL - / VOL +
**
Adjust audio volume.
**
5. Turns on red light when the product is in Standby mode. Before Using the Receiver
**
1.2 Front Panel
** F2-1002
**
1. GB 10 STANDBY LED
**
Red light is displayed when the product...
User Manual - Page 12
... signals.
**
5. **
**
1.3 Rear Panel
** F2-1002
** F2-7002
**
1. RS-232C
**
Connects to your PC to your TV.
**
6. VIDEO
**
Connects to the RF input jack on your TV or VCR and output Audio signals.
**
3. RF IN (only for F2-7002)
**
Connect a RF signal from the product to RF input jack on the product. GB 11 LNB IN
**
Connects a satellite antenna cable.
**
2.
User Manual - Page 13
BACK
6. CH-/CH+ and PAGE-/PAGE+ 10. V-/V+ 19. SOUNDTRACK 9. MENU
11. OK
16. Before Using the Receiver
**
1.4 Remote Control
**
1. FREEZE 17. NUMERICAL BUTTONS 4. 1. G (Game) 12. STANDBY 13. SUBTITLE 18. MUTE
GB 12 SOURCE 2. ARROW BUTTONS 7. EXIT 15. LIST 5. OPT+ (OPTION) 8. GUIDE 14. i (INFORMATION) 20. TV/RADIO 3.
User Manual - Page 14
... the main menu.
**
11.G (Game)
**
Displays the Game.
**
12.STANDBY
**
Switches between TV and Radio modes.
**
3.
SOURCE
**
Selects the input source between TV and cable receiver.
**
2. OPT+ (OPTION)
**
Displays the channel attributes during watching a programme.
**
16.FREEZE
**
Freezes the TV screen you are watching. Play the audio continuously.
**
17.SUBTITLE
**
Changes the subtitle...
User Manual - Page 15
...+ and PAGE-/PAGE+ 10. OK 17. FREEZE
18. V-/V+ 20. 1. STANDBY 14. GUIDE 15. i (INFORMATION) 21. GB 14 ARROW BUTTONS
7. OPT+ (OPTION) 8. TV/RADIO 12. MUTE 22. POSITIONER 2. BACK 6. Before Using the Receiver
**
**
1. LIST 5. MENU 11. SOURCE
13. EXIT 16. SUBTITLE 19. POSITIONER BOTTONS
Note: If you play game, select GAME in MENU.
User Manual - Page 16
... 15 CH-/CH+ and PAGE-/PAGE+
**
Changes the Channel or Page.
**
10.MENU
**
Displays the main menu.
**
11.TV/RADIO
**
Switches between TV and Radio modes.
12.SOURCE
**
Selects the input source between TV and satellite receiver.
**
13.STANDBY
**
Switches between Operation and Standby modes.
**
14.GUIDE
**
Displays the Programme Guide.
**
15.EXIT
**
Exits the...
User Manual - Page 17
2.
F2-1002
F2-7002
2. Connecting TV
This is the most appropriate procedure depending on your Hi-Fi system. (left audio out to left audio in )
F2-1002
F2-7002
GB 16 Setup
**
This chapter describes how to right audio in , right audio out to set up the receiver, please contact your requirements. Connecting Hi-Fi System
Connect the outputs on this...
User Manual - Page 18
GB 17 Connect the power cord of the receiver to a wall outlet.
2. Power on by pressing the STANDBY button at Remote Controller.
**
The Standby LED indicator is turned on Green. **
**
2.2 Powering On
1.
User Manual - Page 19
... the previous screen
3.1 Language
You can easily set-up procedure. You can select Menu, Audio, and the subtitle language.
Installation Wizard
**
When powering on your receiver for the first time after completing the set-up using the and press the OK button. You can select area.
Select the appropriate language from...
User Manual - Page 21
... it's correctly set the current time. Antenna Setting and Channel Search menu to configure your receiver as you want to the next step.
3.5 Time Setting
You can set up. If ...Install Wizard without fully completing the setting procedures, you can automatically search for satellites according to save the previous input information and exit the
Installation Wizard when running the Installation wizard...
User Manual - Page 48
... the
1. Select PAL using the
button, and press the OK
button, and button. Offset
You can select UHF Channels for the TV.
Select a range between -4~+4 using the
button, and press the OK or button.
2. Select Preferences using the
OK or button..., and press the OK or button.
2. Press the MENU button. 2. **
**
7.6 UHF Tuning (Only for F2-7002)
You can select the PAL standard.
1.
User Manual - Page 52
.... GB 51 Select Installation using the
button, and press
the OK or button. **
**
DiSEqC Input
You can automatically search the satellite without searching channel.
1. LNB Voltage This receiver doesn't provide this function.
8.2 Automatic Search
If you select the satellite to search channel according to the Antenna Setting, you wish to search channels for...
User Manual - Page 65
... download tool. 5. Press the STANDBY button to this product operating.
**
F2-1002
F2-7002
GB 64 Follow these steps to download new software from PC to the PC directly and update your software by transferring the new software from PC
You can connect your receiver to this product model from our website into your computer...
User Manual - Page 66
... view System information
1.
10. button, and press the OK
10.1 Status
You can view the signal strength and signal quality receiving from satellite via your satellite dish.
1. Confirm the information about the satellite and transponder, which current channel belongs to and the graphs and percentage of Signal Strength and Quality of the channel. button...
User Manual - Page 69
... Switch is low. Make sure that Antenna line is correctly connected to the TV. - Make sure that the AV Cable is correct. - Keep the product and the antenna cable for satellite far away from each other reservation. - Make sure the receiving level, and adjust antenna if the level is On.
2.
However, these poor...
User Manual - Page 73
...Programme Guide, EPG)
A electronic program guide (EPG) that comes with the broadcast to a particular satellite, note that the user needs or has to a service provider. **
Hi-Fi (High Fidelity...Glossary
**
DiSEqC (Digital Satellite Equipment Control)
A standard through satellite system. **
Transponder
An automatic device that receives amplifies and retransmits a signal on the screen directly.
Similar Questions
How To Update Humax Vaci 5300 Satellite Receiver Software?
How to update humax vaci 5300 satellite receiver software?
How to update humax vaci 5300 satellite receiver software?
(Posted by maajwa 4 years ago)
Sw Update For Satellite Receiver Humax Ir Ace Ii
Looking for the assistance how to do manually the soft ware update for my receiver HUMAX IR-ACE II.W...
Looking for the assistance how to do manually the soft ware update for my receiver HUMAX IR-ACE II.W...
(Posted by rlotfi 9 years ago)
Humax Manual For The Digital Satellite Receiver F1-ci
I can not download a manual for the Humax Digital Satellite Receiver F1-CI. Can you provide me with ...
I can not download a manual for the Humax Digital Satellite Receiver F1-CI. Can you provide me with ...
(Posted by eydfinno 10 years ago)
Catalog Of Humax - Digital Satellite Receiver Xd-400 Irci-pvr
please provide me with catalog of HUMAX - Digital satellite receiver XD-400 IRCI-PVR
please provide me with catalog of HUMAX - Digital satellite receiver XD-400 IRCI-PVR
(Posted by cmcco 10 years ago)