Garmin echo 150 Support Question
Garmin echo 150 Support Question
Find answers below for this question about Garmin echo 150.Need a Garmin echo 150 manual? We have 2 online manuals for this item!
Question posted by Wendygpaulk on April 6th, 2013
Depth Finder Not Working.
Depth finder not work inking everything else ok
Current Answers
Related Garmin echo 150 Manual Pages
Installation Instructions - Page 1
... transom of the propeller on your echo 100/150/200/300c/500c /550c. wrench or socket • Masking tape • Number 2 Phillips screwdriver • Marine sealant • Hardware for in ... 3/8 in Taiwan Verify that creates air bubbles or causes the water to your echo device.
About the echo Mount The echo device can degrade the performance of the boat as close to power. Place ...
Installation Instructions - Page 2
....
• If you are routing the cable using the other sources of the transom ➏. Wipe away any excess marine sealant.
2
echo Installation Instructions Cutting the transducer cable will void your boat.
1. Apply marine sealant to the included 30 mm M5 screws, and loosely attach the transducer assembly to the transom.
13. If...
Installation Instructions - Page 3
...base with the ridges of the cable tie facing up, until it will damage the base.
1. echo Installation Instructions
3 Feed the 20 in. (50 cm) cable tie ➊ through
holes ➊... fully tighten the cable tie. 5. Route the transducer cable to the installation location of the echo device while taking the following precautions. • Avoid routing the cable close to route the cables...
Installation Instructions - Page 4
...on the device ports to the 5/8 in the upward position, place the echo
100/150/300c device ➋ or the echo 200/500c/550c cradle ➌ into the swivel mount (page 4).
...through the mounting surface and the mount.
1. Fastening the Swivel Mount with marine
➋
sealant.
➎
➊
Installing the echo Device in the Swivel Mount 1. Place the swivel-mount base ➊ ...
Installation Instructions - Page 5
... ➋ is necessary to carry the sonar signal, the transducer must be working properly, gradually increase speed while observing the echo device. Press the release lever ➊ on the cradle.
Testing the Transom Mount Transducer Installation
Notice When adjusting the depth of time without plugging in the water to be in any screw...
Installation Instructions - Page 6
.../550c
Rated Current echo 100/150/
1 A
200/300c/500c/550c
Transmit
echo 100
Power (RMS/ echo 150 peak to peak) echo 200/300c
100 W/800 W 200 W/1,600 W 300 W/2,400 W
echo 500c/550c
500 W/4,000 W
Freshwater Depth*
echo 100 echo 150
600 ft. (183 m) 1,300 ft. (396 m)
echo 200/300c
1,500 ft. (457 m)
echo 500c/550c
1,900 ft. (579 m)
Saltwater Depth*
echo 100 echo 150
300 ft. (91...
Owner's Manual - Page 1
echo™ 100 and echo 150
owner's manual
Owner's Manual - Page 2
... obligation to make changes in any storage medium, for current updates and supplemental information concerning the use and operation of Garmin Ltd.
or its subsidiaries. echo™ is strictly prohibited. Visit the Garmin Web site (www.garmin.com) for any person or organization of Garmin. Except as expressly provided herein, no...
Owner's Manual - Page 3
echo 100 and echo 150 Owner's Manual
1 When you have any questions about this manual, the term "select" is highlighted, and ...may appear in the text. Introduction
Warning See the Important Safety and Product Information guide in the product box for the echo™ 100 and echo 150 fishfinders. by phone at (913) 397.8200 or (800) 800.1020.
• In the UK, contact Garmin (Europe)...
Owner's Manual - Page 4
... to cycle through options or changes settings. Select the units in which to your previous screen. Press and quickly release . 2. Scrolls through the brightness settings.
2
echo 100 and echo 150 Owner's Manual
Adjusting the Contrast
1. From the Sonar screen, select MENU > Setup > System > Contrast. 2. Select ENTER. Adjusting the Backlight
1. Repeat to measure...
Owner's Manual - Page 5
Otherwise, press to turn on the device.
From the Sonar screen, select MENU > Setup > Alarms > Beeper. 2.
echo 100 and echo 150 Owner's Manual
Getting Started 3 Setting the Beeper
You can set when the device makes audible sounds. 1. Turning On the Device Automatically
You can set the ...
Owner's Manual - Page 6
... side of the screen. Select an option:
• To allow the device to show. 3. Select the span you select a span of 15 feet and a starting depth.
➎
➊
4
echo 100 and echo 150 Owner's Manual Adjusting the Zoom on the Sonar Screen Manually
You can adjust the range of the...
Owner's Manual - Page 7
... and echo 150 Owner's Manual
Using the echo 100 and echo 150
Setting the Gain to show weaker signals and more detail, increase the gain. From the Sonar screen, select MENU > Setup > Alarms. 2. Select the span you select a span of the screen, then slightly decrease the gain.
1. Select the starting depth.
Select to the contour of...
Owner's Manual - Page 8
...penetrates deep water more detail, especially while moving or trolling. Select a frequency. Using the echo 100 and echo 150
Setting the Battery Voltage Alarm
You can set an alarm to sound when the device detects...targets as symbols with background sonar
information and target depth information, Select .
6
echo 100 and echo 150 Owner's Manual Use a higher scroll speed to left.
You can be...
Owner's Manual - Page 9
... Range Compass Safe Distance Frequency
Power Source Voltage Range Fuse Freshwater Depth
Saltwater Depth
Measurement 4 in . (250 mm)
echo 100: 200 kHz echo 150: 77 kHz or 200 kHz 10-20 Vdc
AGC/3AG - 3.0 A echo 100: 600 ft. (183 m) echo 150: 1300 ft. (396 m) echo 100: 300 ft. (91 m) echo 150: 500 ft. (152 m)
Appendix
Viewing System Information
From the Sonar...
Owner's Manual - Page 10
...") grant you a limited license to any country in the normal operation of any derivative works based on the Software. Title, ownership rights, and intellectual property rights in source code ...form the Software or any part thereof or create any other applicable country.
8
echo 100 and echo 150 Owner's Manual PLEASE READ THIS AGREEMENT CAREFULLY. and its third-party providers. You ...
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
My Echo 150 S.n.27v019012,less Than One Year Old Dont Start Up With Normal Tens
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
(Posted by dameliomario 9 years ago)
Y Garmin Echo 150 Was Plugged In For The First Time And Believed To Be Functioni
My new Garmin echo 150 is not giving right depth readings, while in around 5 to 7 feet of water it w...
My new Garmin echo 150 is not giving right depth readings, while in around 5 to 7 feet of water it w...
(Posted by iclausman 10 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 11 years ago)
In Accurate Reading On Echo 150
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
(Posted by johnyankosky 11 years ago)