Garmin echo 150 Support Question
Garmin echo 150 Support Question
Find answers below for this question about Garmin echo 150.Need a Garmin echo 150 manual? We have 2 online manuals for this item!
Question posted by iclausman on May 20th, 2013
Y Garmin Echo 150 Was Plugged In For The First Time And Believed To Be Functioni
My new Garmin echo 150 is not giving right depth readings, while in around 5 to 7 feet of water it was showing on the screen 37 feet. Is there a way to reset the programs? The transducer was mounted correctly and the two cords that plug into the back of the unit can only go into the correct hole. What can i do to get correct depth readings.
Current Answers
Related Garmin echo 150 Manual Pages
Installation Instructions - Page 1
... to the center of your echo, plan the installation by phone at the same time. Follow these guidelines for in . In the USA, go to www.garmin.com/support and click Contact Support for optimal performance.
• Mount the transducer as possible.
• Do not mount the transducer behind strakes, struts, fittings, water intake or discharge ports, or...
Installation Instructions - Page 2
... away any excess marine sealant.
2
echo Installation Instructions Make sure that it touches the mounting bracket and
then tighten 1/4 turn more (do not overtighten).
8. Place the cable-entry cover ➊ over the hole and the cable, with the water line ➋, and mark the center location of the gel-coat.
4. Align the transducer parallel with...
Installation Instructions - Page 3
... damage the base.
1. For use in cold water or in areas with bolts, use , tighten the 10-32 locking nut ➍ until equal lengths extend on the transducer mount ➋, with countersunk heads will void your warranty.
1. Route the transducer cable to the installation location of the echo device while taking the following precautions. •...
Installation Instructions - Page 4
... swivelmount base, but do not need to the device.
4
echo Installation Instructions
Connecting the Cables to an echo 100/150/300c On an echo 100/150/300c device, the connectors on the device.
1. Pull out enough slack from the power and
transducer cables so that the mount can
fully swivel to
fit only in the upward position...
Installation Instructions - Page 5
... have connected the cables to carry the sonar signal, the transducer must be working properly, gradually increase speed while observing the echo device.
Testing the Transom Mount Transducer Installation
Notice When adjusting the depth of the water. With the boat in the port.
3. Repeat steps 2-4 until
the echo device ➋ is severely degraded, note the speed at...
Installation Instructions - Page 6
...*Depth capacity is dependent on water salinity, bottom type, and other countries. or its subsidiaries
Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA
Garmin (Europe) Ltd. Specifications
Specification Device
Size
echo 100/150/300c
echo 200/500c/550c
Weight (without bail mount)
Weight (with bail mount)
Display
echo 100/150/300c echo 200 echo 500c echo 550c...
Owner's Manual - Page 1
echo™ 100 and echo 150
owner's manual
Owner's Manual - Page 2
... or organization of such changes or improvements. Garmin® and the Garmin logo are trademarks of Garmin Ltd. echo™ is a trademark of Garmin Ltd. Except as expressly provided herein, no part of this and other countries. Garmin reserves the right to notify any purpose without the express permission of Garmin. Information in this manual or any storage...
Owner's Manual - Page 3
... 0808 2380000. • In Europe, go to www.garmin.com/support, or contact Garmin USA by completing our online registration today.
• Go to www.garmin.com/support and click Contact Support
for in the product box for the echo™ 100 and echo 150 fishfinders. echo 100 and echo 150 Owner's Manual
1 Introduction
Warning See the Important...
Owner's Manual - Page 4
... a menu item. Scrolls through the brightness settings.
2
echo 100 and echo 150 Owner's Manual Turns the device on or off and adjusts the backlight. Configuring the Initial Device Settings
Before you can update each of these settings when restoring original factory settings. Select a language. 2. From the Sonar screen, select MENU > Setup > System > Contrast. 2. Select...
Owner's Manual - Page 5
... .
Menu Timeout
After a menu appears for 20 seconds and no keys are triggered, select Alarms Only. echo 100 and echo 150 Owner's Manual
Getting Started 3
Using Quick Adjust
After adjusting a setting and returning to the Sonar screen, you select an item and when an alarm is triggered, select On.
• To have the device...
Owner's Manual - Page 6
...starting depth.
➎
➊
4
echo 100 and echo 150 Owner's Manual
Using the echo 100 and echo 150
Using the echo 100 and echo 150
Sonar Screen
The sonar screen shows a full-view graph of sonar readings from 5 feet deep to 20 feet deep.
1. For example, if you would like to show. 3. From the Sonar screen, select Menu > Zoom > Manual. 2. Adjusting the Zoom on the right side...
Owner's Manual - Page 7
... echo 150
Setting the Gain to see noise in the water portion of the screen, then slightly decrease the gain.
1. Select the starting depth. Select to the contour of the water bottom. From the Sonar screen, select MENU > Setup > Alarms. 2.
Adjusting the Zoom on the Alarms screen.
5 For example, if you begin to show . 3. Pausing the Screen
From the Sonar screen...
Owner's Manual - Page 8
... in shallower waters. Selecting a Frequency for the echo 150 Sonar screen when using a dual frequency transducer. Note: The echo 100 operates only at which the sonar scrolls from a 77 kHz sonar signal. You can show suspended targets as symbols with background sonar
information, select . • To show data from a 200 kHz sonar signal or data from right to sound...
Owner's Manual - Page 9
...
Power Source Voltage Range Fuse Freshwater Depth
Saltwater Depth
Measurement 4 in . (250 mm)
echo 100: 200 kHz echo 150: 77 kHz or 200 kHz 10-20 Vdc
AGC/3AG - 3.0 A echo 100: 600 ft. (183 m) echo 150: 1300 ft. (396 m) echo 100: 300 ft. (91 m) echo 150: 500 ft. (152 m)
Appendix
Viewing System Information
From the Sonar screen, select MENU > Setup > System > System...
Owner's Manual - Page 10
...product. You further acknowledge that the Software in Garmin and/or its third-party providers. Title, ownership rights, and intellectual property rights in and to use the software embedded in...Garmin and/or its thirdparty providers and is not provided, are valuable trade secrets of any derivative works based on the Software. Appendix
Software License Agreement
BY USING THE ECHO 100 OR ECHO 150...
Owner's Manual - Page 12
January 2011
© 2011 Garmin Ltd. A
Printed in Taiwan or its subsidiaries
Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA
Garmin (Europe) Ltd. Liberty House, Hounsdown Business Park, Southampton, Hampshire, SO40 9LR UK
Garmin Corporation No. 68, Jangshu 2nd Road, Sijhih, Taipei County, Taiwan
www.garmin.com
Part Number 190-01312-00 Rev.
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
My Echo 150 S.n.27v019012,less Than One Year Old Dont Start Up With Normal Tens
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
(Posted by dameliomario 9 years ago)
In Accurate Reading On Echo 150
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
(Posted by johnyankosky 11 years ago)