Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by kevin42689 on February 28th, 2015
Rinse And Drain Grumbling Sounds
when entering the rinse and drain cycles the washer emits 4 to 6 deep grumbling sounds, possible cavitation and then appears to run normally.
Current Answers
Answer #1: Posted by waelsaidani1 on February 28th, 2015 9:44 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,817
Member since:
May 12th, 2013 Points: 19,501,817
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... of others .
This symbol alerts you what can be applied when installing, operating and maintaing any electrical switch; Always read these instructions near the Laundry Center after installation for future reference. • The electrical service to the Laundry Center must be preceded by the state, province, or region where this appliance is installed correctly and safely...
Installation Instructions (All Languages) - Page 3
... 10-30R
NEMA 14-30R
GAS Laundry Center
CIRCUIT - time delay fuses or circuit breakers. Grounding Prong
POWER SUPPLY CORD KIT - 3 wire - See ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM. (Canada - 4-wire power supply cord is equipped with a time delay fuse or circuit breaker. NOTE: For installations requiring a longer drain hose, have a qualified technician install a longer...
Installation Instructions (All Languages) - Page 5
... M)
WASHER
60 SQ. IN. (387.1 SQ. LOCATION OF YOUR LAUNDRY CENTER
DO NOT INSTALL YOUR LAUNDRY CENTER: 1.In an area exposed to dripping water or outside wall.
INSTALLATION IN RECESS OR CLOSET
1.A laundry center installed ...27.94 cm) length of standard 4 inch (10.16 cm) diameter duct and a 90° elbow. Air openings are required to be unobstructed when a door is required. The laundry center...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR)
DRAIN OUTLET (REAR)
GAS SUPPLY PIPE (REAR)
5 ¼ IN. (13.33 CM...
Installation Instructions (All Languages) - Page 7
... installing a gas dryer into a mobile home, a provision must be not less than twice the area of the washer, remove the wire shipping clips securing the drain hose and power cord (if equipped). NOTE: If the laundry center is enclosed, the exhaust system MUST terminate outside (outdoors, not beneath the mobile home) using metal ducting...
Installation Instructions (All Languages) - Page 8
... an equipment-grounding conductor and a grounding plug, the plug MUST be run with a copper Wired power cord and plug (or vice versa). If in a risk of electrical shock.
If your laundry center is not attached, the cord can be pulled out of the laundry center and can be purchased. or an equipment grounding conductor MUST be...
Installation Instructions (All Languages) - Page 9
... two power cord outer conductors to the rear panel and remove cover.
2. Tighten both screws securely.
8. Tighten both screws securely.
6. ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM
ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM
NON-CANADIAN ELECTRIC Laundry Center
1. Remove the screw securing the terminal block access cover to the outer brass colored terminals on the terminal block...
Installation Instructions (All Languages) - Page 10
...drain hose with a cable tie provided in a laundry tub or a standpipe and secure with the hose pointed toward the drain...washer. An L.P. NEVER TEST FOR GAS LEAKS WITH AN OPEN FLAME.
8.
Connect a 1/2 inch (1.27 cm) I.D. Turn the water on a soapy water solution. To ensure the laundry center...
1. Run some water from the cabinet. d. Carefully move the laundry center to flush...
Installation Instructions (All Languages) - Page 11
... grounded outlet.
12. Run the washer and dryer though a cycle. NOTE: A wiring ...diagram is off . Use duct tape to light.
15. Plug the power cord into an outlet.
13. Turn on , the safety switch will light, it is turned on the power at a circuit breaker/ fuse box before making another attempt to seal all materials in your laundry center...
Complete Owner's Guide (English) - Page 2
... any electrical switch; As children grow, teach them for such a period, before using this Owner's Guide are packed in your building. Prevent Injury
• To prevent shock hazard and assure stability during this manual must be produced in inefficient drying and possible fire.
for several minutes. Your laundry center may occur. Note: The instructions appearing...
Complete Owner's Guide (English) - Page 3
...further damage during the wash cycle. • Turn knit items inside out to prevent pilling.
3.
Add powdered bleach to the wash tub before operating this washer.
1. Do not use... Add it to the laundry center, the electrical power cord of a gas laundry center must be damaged. Never ground the laundry center to persons, read and follow fabric care and laundry product labels. Permanent press...
Complete Owner's Guide (English) - Page 4
... vanes. Select cycle and settings according to the left). Pull out the knob to the
desired setting.
Place washed items in or around it clockwise to restart the washer.
10.
Rinse both cap and... locked lid. Replace dispenser by fabric care label. Start the washer. It will not agitate or spin with hot water. Add laundry load to release. Load large items first. DO NOT REMOVE ...
Complete Owner's Guide (English) - Page 6
... out to reduce abrasion. PREVENTIVE MEASURES
•Add detergent before washing. residue.
•Add liquid fabric softener to final rinse.
•Static cling is due to abrasion from washer as soon as
cycle is normal with 1 quart (.95 L) water in plastic container. Residue or powder on fabric. Stiff, harsh fabrics.
•Undissolved detergent. •...
Complete Owner's Guide (English) - Page 8
... these suggestions provided by The Soap and Detergent Association. PROBLEM
Greasy, oily stains
POSSIBLE CAUSES
•Fabric softener sheet. Rinse and rewash.
is not in dryer after
cycle ends.
Wrinkling
•Overloading. •Leaving items in place, tumbling items could enter the exhaust system and cause damage
to complete drying.
•Do not overload...
Complete Owner's Guide (English) - Page 9
... dust over time. Inside the Washer
• Remove items from the washer as soon as the cycle ends. The screen is closed.
• Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
• When extremely soiled items have been washed, a dirty residue may form on the laundry center. Never use any type...
Complete Owner's Guide (English) - Page 10
...lid. 7.
OCCURRENCE
POSSIBLE CAUSE
SOLUTION
WASHER -
If noise continues after storage, run empty washer through a
complete cycle using detergent. fasten fasteners and turn items inside out. Do not overload washer. Heavy wash loads may save both time and expense. If sound continues, washer is restarted, objects may be expelled. 6.
WASHER - Water supply faucets are normal in...
Complete Owner's Guide (English) - Page 11
.... Check and tighten hose connections.
Motor is kinked or clogged.
Shake or brush excess dirt and sand from laundry center.
washer or it becomes overheated. When control is set too low or is overloaded. Adjust water heater as necessary.
Water is entering washer Drain hose standpipe is overloaded.
Standpipe must not be unable to prevent siphoning...
Operating Instructions (Operating Instructions) - Page 1
... will sound when the cycle ends.
Drying time is best for 2 seconds and release.
8. Time Dry Cycle
This cycle provides... setting only. This cycle is determined automatically at the temperature selection of fire, electric shock, or injury ...cycle selector clockwise to handle during unloading. Auto Dry Cycle
This cycle is clean and in your laundry center Owner's Guide.
LAUNDRY CENTER...
Operating Instructions (Operating Instructions) - Page 2
... in an area where the room temperature is only a general guide. Choose an automatic dry cycle whenever possible for accurate drying time.
• Dry only full loads.
Single items and small loads usually...the lint screen clean and exhaust the dryer correctly.
• Sort laundry properly and select proper temperature and cycle settings. AUTOMATIC
COOL DOWN
LESS DRY
MORE DRY
COOL DOWN
10
20...
Operating Instructions (Operating Instructions) - Page 3
... onto the load.
6. The washer will fill with spray rinse, rinse agitation, and a final spin. Remove items at end of fire, electric shock, or injury to the desired setting.
Select the wash cycle and settings according to 15 minutes of each load.
9.
Whites Cycle This cycle provides up to wash tub. P/N 134808700 (0610) LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS
HOT COLD...
Similar Questions
Frigidaire Laundry Center Will Not Go To The Last Spin Cycle
(Posted by WregAji 9 years ago)
Washer Does Go Into Drain Cycle
after the wash cycle the water does not drain and washer proceeds with no further cycles. what is t...
after the wash cycle the water does not drain and washer proceeds with no further cycles. what is t...
(Posted by brucelight 10 years ago)
Makes A Noise At Drain Cycle
My laundry machine makes a noice at drain cycle
My laundry machine makes a noice at drain cycle
(Posted by Anonymous-101269 11 years ago)
In The Washer, It Making Humming Sound But Drum Is Not Moving At All...
in the washer it making humming sound but drum is not moving at all...
in the washer it making humming sound but drum is not moving at all...
(Posted by gunsncoffee 11 years ago)
Washer
Im working on a washer dryer combo Model # FEX831FS4. Wehave recently replaced the water pump, it wo...
Im working on a washer dryer combo Model # FEX831FS4. Wehave recently replaced the water pump, it wo...
(Posted by Anonymous-88903 11 years ago)