Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by btsavage48 on August 20th, 2015
Drain Pump Voltage Low
I have the FEX831FS2 washer dryer combo. The tub would not drain. Tore it apart, thinking it was a pump. The pump looked OK, so I put it on the bench and put 120VAC to it. It ran fine. I measured the voltage on the supply line to the pump (at the connector) and it' only 25 VAC.
Current Answers
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
...straight, & square bit screwdrivers. • Adjustible wrench. • Pipe wrench for gas supply (gas dryer). • LP-resistant thread tape (for HOME USE only. Do not store or use them for .... • Do not install a Laundry Center with rugs, bedspreads, or plasic sheets can be applied when installing, operating and maintaing any electrical switch; Flexible venting materials are not ...
Installation Instructions (All Languages) - Page 3
...minute.
2.
For drain systems in the installed position. (Canada - Individual 30 amp.
The dryer MUST employ a ...laundry center's water inlet. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not under any circumstances remove grounding prong from an authorized parts distributor. Use separately fused circuits for washers and dryers, and DO NOT operate a washer and a dryer on dryer...
Installation Instructions (All Languages) - Page 5
... sideways). CM)
DRYER
Closet Door
60 SQ. C M)
WASHER
60 SQ. The laundry center may be exhausted four (4) ways with the National Fuel Gas Code, ANSI Z223.1 (latest edition) or in Canada, the current AN/CGA B149.
2.The gas supply line should be of 1/2 inch (1.27 cm) pipe.
3.If codes allow, flexible metal tubing may be...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR)
DRAIN OUTLET (REAR)
GAS SUPPLY PIPE (REAR)
5 ¼ IN. (13.33 CM...
Installation Instructions (All Languages) - Page 7
...laundry center to prevent water syphoning. From the back of the washer backsheet. PLASTIC SPACER BLOC K
MEC HANISM SHIPPING BOLT
FOAM SHIPPING PAD
SHIPPING CARTON CORNER POSTS
POWER CORD (IF EQUIPPED) DRAIN HOSE
7 MOBILE HOME INSTALLATION
1.Dryer... date, the tub blocking pad, shipping bolt, and plastic spacer block should be made for Mobile Homes. NOTE: If the laundry center is enclosed, ...
Installation Instructions (All Languages) - Page 8
... MUST be plugged into a properly grounded three-prong receptacle. Do not modify plug provided with a copper Wired power cord and plug (or vice versa).
Canadian ELECTRIC Laundry Center
WARNING Do not use an extension cord with all codes and ordinances.
Refer to whether the appliance is properly grounded. or an equipment grounding conductor...
Installation Instructions (All Languages) - Page 9
... brass-colored terminals on the terminal block. Attach the red and black wires from the green ground screw located above the termial block. NON-CANADIAN ELECTRIC Laundry Center
1. Install a U.L. Attach the green power cord ground wire to the rear panel and remove cover.
2. Attach the remaining two power cord outer conductors to the...
Installation Instructions (All Languages) - Page 10
...the washer. Remove the two (2) screws securing the dryer front access panel to its final location.
6. GAS CONNECTION (Gas laundry centers only)
a.
NOTE: DO NOT connect the laundry center to...the laundry center back down to ensure the laundry center is resistant to self adjust. gas service without converting the gas valve. INSTALLATION
1.
b. Connect a 1/2 inch (1.27 cm...
Installation Instructions (All Languages) - Page 11
... situation that nothing (such as a routine with your laundry tasks. Use duct tape to seal all wires prior to children. Reinstall the dryer front access panel.
If this laundry center are understood and practiced as boxes, clothing, etc.) obstructs the flow of air.
Run the washer and dryer though a cycle. If the burner does not light...
Complete Owner's Guide (English) - Page 2
...warnings on all instructions before or after the laundry center is removed from service or discarded, remove the washer lid and dryer door to prevent accidental
entrapment. • ...any accumulated hydrogen gas.
Important Safety Instructions
Grounding type wall receptaGcAleS LAUNDRY CENTERS:
Avoid fire hazard or electrical shock. Failure to follow these warnings could cause a load to...
Complete Owner's Guide (English) - Page 3
Never ground the laundry center to the empty tub. Do not use powdered bleach in a mesh bag. Washing Procedures
• Follow the guidelines below for preparing the wash load.
• Read the Washer Operating Instructions for operating your specific model.
• Always read Important Safety Instructions, page 2-3, before adding the laundry load. Bleach Dispenser (some models...
Complete Owner's Guide (English) - Page 6
... water temperature too
low. •Incorrect ...in the washer to lubricate...;Do not overload washer.
•Not...washer. Do not use of chlorine ...washer...not overload washer. •...Drain water heater occasionally. •For an ongoing problem, install an iron
filter in dryer...low. •Not enough detergent.
Soak item. Wrinkling
•Overloading the washer... Then start washer.
•...
Complete Owner's Guide (English) - Page 7
... clockwise to tumble freely for drying.
• Dry items of static electricity, which may permanently set dryer controls (some stains. When the cycle ends, remove items immediately and hang...for your specific model. • Always read and follow fabric care labels and laundry product labels. Fill dryer drum 1/3 to prevent tangling and for better drying, less wrinkling, and to prevent...
Complete Owner's Guide (English) - Page 8
...or low heat for proper tumbling.
•Some "silk-like" fabrics should be air dried. •Use proper drying temperature. •Place fabric softener sheet on top of rack. Open the dryer door... lint brush or roller to remove lint.
•Do not overload dryer. •Use fabric softener in washer or dryer to reduce
static electricity. •Remove items when they are dry, remove the rack and...
Complete Owner's Guide (English) - Page 9
... front leveling legs to avoid electrical shock hazards.
• Do not use harsh, gritty or abrasive cleansers. Rinse thoroughly with water.
• The agitator or tub may remain on the laundry center. If the cabinet becomes stained, clean with diluted chlorine bleach [1/2 cup (120 ml) in the washer.
• Dry the washer top, the area around...
Complete Owner's Guide (English) - Page 10
...not resting on water supply faucets. Disconnect hoses from water supply and drain water from washer after washer is stored in an area where freezing can occur or moved in...damage to tub,
hitting wash tub. Close lid. 5.
rubber odor.
Close washer lid
Electrical power cord may be in knob, unplug electrical power cord, dry tub interior, and close lid. 7. Move laundry center so it...
Complete Owner's Guide (English) - Page 11
... elsewhere in area. Water leaks.
If problem persists, your washer
Clean and straighten the drain hose.
Standpipe must be unable to 30 minutes (if washer has not been manually turned off).
Pull out knob. Lid is overheated.
Shake or brush excess dirt and sand from laundry center. spin. See Washing Procedures. Wait until water supply...
Operating Instructions (Operating Instructions) - Page 1
...load.
Load the dryer. Use Cool Down...type of fire, electric shock, or injury ...risk of installation and electrical voltage or gas pressure can...dryer door. 5. This reduces wrinkling and makes items easier to desired cycle and setting. Operating Steps
1. Drying time is best for items of your laundry center...laundry center Owner's Guide. Start dryer...ends.
LAUNDRY CENTER DRYER OPERATING ...
Operating Instructions (Operating Instructions) - Page 3
... SMALL (LOW)
LARLAGREGE (FULL, SUPER)
RESET *
* Some Models
KNITS & DELICATES SPIN
RINSE
15
OFF
12 8 4
REGULAR (WHITES)
START
OFF
SPIN RINSE
RINSE SPIN
OFF
12 PERM PRESS
48
(COLORS)
5. To change a cycle, push in your Laundry Center Owner's Guide before adding the laundry load.
A cool down spray rinse helps reduce wrinkling.
LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS...
Operating Instructions (Operating Instructions) - Page 4
...and jeans.
• Operate the washer in the tub for items to avoid rewashing. Warm and cold wash and rinse water temperatures are low.
• Follow proper laundry procedures to move freely.
•...noncolorfast fabrics, knits, delicates
Cold/Cold
Load Size Turn the Load Size knob to the tub.
Oversize loads use lower water levels. Wash / Rinse Temperature Turn the Wash/Rinse ...
Similar Questions
Wire Harness
I need to find a wiring harness for the model number FEX831FSO
I need to find a wiring harness for the model number FEX831FSO
(Posted by sheryllee62 5 years ago)
How To Open Fix Drain Pump In Frigidaire Washer Dryer Combo
(Posted by NguRikiga 9 years ago)
Is It Common Practice To Replace The Drain Filter On The Gleh1642fs Washer/dryer
I took apart 75%of drain pump/filter. It was clogged real bad. Was unable to get last connection off...
I took apart 75%of drain pump/filter. It was clogged real bad. Was unable to get last connection off...
(Posted by jeffhp63 11 years ago)
How Do I Get To The Drain Pump On My Gleh1642fs1 Frigidaire Washer/dryer Combo.
Believe the drain pump is clogged or broke since water is not draining . How do I access the pump,...
Believe the drain pump is clogged or broke since water is not draining . How do I access the pump,...
(Posted by jeffhp63 11 years ago)
Washer
Im working on a washer dryer combo Model # FEX831FS4. Wehave recently replaced the water pump, it wo...
Im working on a washer dryer combo Model # FEX831FS4. Wehave recently replaced the water pump, it wo...
(Posted by Anonymous-88903 11 years ago)