Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by sheryllee62 on September 7th, 2018
Wire Harness
I need to find a wiring harness for the model number FEX831FSO
Current Answers
Answer #1: Posted by Odin on September 7th, 2018 10:30 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.repairclinic.com/Shop-For-Parts/a17b2c57d683014/Model-FEX831FS0-Frigidaire-Washer-Dryer-Combo-Wire-Receptacle-Wire-Connector-Parts. You'll have a choice of 4 items; if you can't easily choose, either ask Frigidaire [use the contact information here--https://www.contacthelp.com/frigidaire/customer-service], or call the number at the top of the referenced page.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... not try to hazards that may occur. flexible gas supply line (gas dryer).
• 3-wire or 4-wire 240 volt corg kit • Metal foil tape not (duct tape).
(electric dryer).
2
These conditions will simplify the installation and ensure the Laundry Center is the safety alert symbol. We have provided many important safety messages in the...
Installation Instructions (All Languages) - Page 3
... or closed loop connectors and marked for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY...laundry center's water inlet. USE COPPER CONDUCTOR ONLY.
1.
Use separately fused circuits for use 4-conductor cord for this purpose). See ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM.
4 wire - See ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM. (Canada - 4-wire...
Installation Instructions (All Languages) - Page 4
...a clothes dryer with the flow of exhaust hood. Exceeding the length of duct pipe or number of elbows allowed in the surrounding area. Lint can cause an accumulation of water column, measured...used , number of elbows and type of air. Failure to collapse, be inspected and cleaned a minimum of 18 inches (45.7 cm) above the floor.
The dryer must be exhausted into the laundry area. ...
Installation Instructions (All Languages) - Page 5
... and 1 elbow left) 4. P. INSTALLATION IN RECESS OR CLOSET
1.A laundry center installed in the same closet as the Gas laundry center.
3.Your laundry center needs the spacearound it will be positioned about 4½ inches (11.43...IN.
(387.1 SQ. IN. (387.1 SQ. C M)
WASHER
60 SQ.
Air openings are required to line up , add an 11 inch (27.94 cm) length of standard 4 inch (10.16 cm) diameter...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR...¼ IN (104.77 CM) 29 7/16 IN (74.77 CM)
3 ¾ IN. (9.52 CM)
36 1/16IN. (91.60 CM)
27 IN. (68.58CM)
25 ¼ IN. (64.13 CM)
47"
2 ½ IN. (6.35 CM)
1 7/8 IN. (4.76 CM)
4...
Installation Instructions (All Languages) - Page 7
....
3. Using the four shipping carton corner posts (two on each side), carefully lay the laundry center on its left side and remove foam shipping base. These clamps form a standpipe to the right side of the washer, remove the wire shipping clips securing the drain hose and power cord (if equipped). DO NOT REMOVE THESE...
Installation Instructions (All Languages) - Page 8
... or remove the grounding prong from the plug.
8 Canadian ELECTRIC Laundry Center
WARNING Do not use an extension cord with a copper Wired power cord and plug (or vice versa). WARNING Do not use an aluminum wired receptacle with this manual for proper grounding. For a grounded cord connected laundry center: 1. Failure to whether the appliance is not attached...
Installation Instructions (All Languages) - Page 9
NON-CANADIAN ELECTRIC Laundry Center
1. approved power
power cord. Attach the white (neutral) wire from the power cord and the neutral ground wire from the appliance harness to the rear panel and remove cover.
2. approved strain relief connector in the entry hole on the back panel.
3. Insert a NEMA 10-30 Type SRDT, U.L. ...
Installation Instructions (All Languages) - Page 10
... supply line. Connect a 1/2 inch (1.27 cm) I.D. Test all four legs (no rocking of the drain hose with pliers. NOTE: DO NOT connect the laundry center to 3/8 inch (0.96 cm) reducer for leaks at the rear of the washer. d.
Remove the panel and set the laundry center back down to ensure the rubber washers are off the ground...
Installation Instructions (All Languages) - Page 11
...washer and dryer though a cycle. Check for service.
16. If the burner does not light within 45 seconds the first time the dryer is necessary for your laundry center, contact the source where you purchased your laundry tasks. If your laundry center...this laundry center are not meant to seal all the Safety and Operating instructions are needed for the gas line to light.
15. NOTE: A wiring ...
Complete Owner's Guide (English) - Page 2
.... If your gas supplier from service or discarded, remove the washer lid and dryer door to prevent accidental
entrapment. • Failure...models. Your laundry center may occur. Follow the gas supplier's instructions. These mixtures can produce dangerous fumes which can occur. Important Safety Instructions
Grounding type wall receptaGcAleS LAUNDRY CENTERS:
Avoid fire hazard or electrical...
Complete Owner's Guide (English) - Page 3
...laundry center to the empty tub. Do not use powdered bleach in a mesh bag. Washing Procedures
• Follow the guidelines below for preparing the wash load.
• Read the Washer Operating Instructions for washing.
• Empty pockets. • Brush off lint and dirt. Bleach Dispenser (some models... to the laundry center, the electrical power cord of a gas laundry center must be ...
Complete Owner's Guide (English) - Page 4
...about
2-3 minutes for the lid lock to release. For your specific model controls.
9. Place washed items in dispenser (see picture to washer.
• Dry load level should not be higher than top of... agitator vanes. Do not load items higher than the top of agitator vanes. Add laundry load to the left...
Complete Owner's Guide (English) - Page 7
... when the door is running, open the door. Items need room to prevent tangling and for even drying and less ...your specific model. • Always read and follow fabric care labels and laundry product labels. Prepare items for operating your specific model controls.
...drum 1/3 to OFF.
7
To reduce the risk of fire, electrical shock, or serious injury to persons or property, comply with small...
Complete Owner's Guide (English) - Page 9
... moving the laundry center, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent floor damage.
9
Remove the lint and replace the screen.
• Occasionally a waxy build-up in Important Safety Instructions, page 2, and those listed below.
• Before cleaning the washer or dryer interior, unplug the electrical power cord...
Complete Owner's Guide (English) - Page 10
...
SOLUTION
WASHER -
Squealing sound or hot Washer is a power outage, call local electric company. Laundry center is ...washer in knob, unplug electrical power cord, dry tub interior, and close lid. 7.
Do not add wash load. Vibrating noise. Wash load unevenly distributed in tub or pump.
OPERATING
Washer does not start.
A certain amount of the RV antifreeze will be needed...
Complete Owner's Guide (English) - Page 11
...
hot enough. Water leaks.
Install rubber sealing washers provided.
Washer won't spin. Shake or brush excess dirt and sand from laundry center. spin.
Check another faucet in the house... house.
Lid is filling. Water inlet hoses are regulated.
Water is entering washer Drain hose standpipe is overloaded. Unclog drain pipes. Connect hot water hose to...
Operating Instructions (Operating Instructions) - Page 1
... selector on fabric care labels. This cycle is determined automatically at the temperature selection of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in place.
3. To reduce the risk of your laundry center Owner's Guide. If desired, add a dryer fabric softener sheet. Set Temperature control. 6. Cycle Selection
Turn cycle...
Operating Instructions (Operating Instructions) - Page 3
... SIZE
MEDIUM SMALL (LOW)
LARLAGREGE (FULL, SUPER)
RESET *
* Some Models
KNITS & DELICATES SPIN
RINSE
15
OFF
12 8 4
REGULAR (WHITES)
START
OFF
SPIN RINSE
RINSE SPIN
OFF
12 PERM PRESS
48
(COLORS)
5. Add laundry load loosely to wash tub. For best results, DO NOT overload.
8. To stop the washer, push in your Laundry Center Owner's Guide.
Operating Instructions (Operating Instructions) - Page 4
...and rinse water temperatures are low.
• Follow proper laundry procedures to select the wash water temperature suitable for the ... heavy items such as towels and jeans.
• Operate the washer in the tub for items to move freely.
• Select ... SIZE
MEDIUM SMALL (LOW)
LARLAGREGE (FULL, SUPER)
RESET *
* Some Models
KNITS & DELICATES SPIN
RINSE
15 12 8
OFF
4
REGULAR (WHITES)
START...
Similar Questions
How To Install A Lid Switch On A Frigidaire Washer Fex831fs
(Posted by adamwar 9 years ago)
How Do I Get The Tube Off Of Model Number Fex831fs4 Washer So I Can Replace The
tub seal
tub seal
(Posted by tvad 10 years ago)
Frigidaire Washer Model Number Atf6700fsi
I have a frigidare washer model number atf6700fsi and when I close it and try to start the machine i...
I have a frigidare washer model number atf6700fsi and when I close it and try to start the machine i...
(Posted by Brownmaisha 11 years ago)
My Front Load Washer Model Number Gltf2940eso Will Not Finish Last Spin Cycle
my Frigidaire front load washer will not finish the last spin cycle. Whats wrong?
my Frigidaire front load washer will not finish the last spin cycle. Whats wrong?
(Posted by wiatrekmartin 12 years ago)