Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by bkirkhol on June 10th, 2012
Broken Agitator In Stackable Washer/dryer Smell Coming From Motor
I have a stackable washer.dryer unit and the agitator basket has come lose. It moves all around,is there a way to reattach it? There is a smell coming from the motor area. Not sure if they are related, but believe they are.
Current Answers
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... or area of this manual and other appliance. PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for Installation: • Adjustable pliers. • Phillips, straight, & square bit screwdrivers. • Adjustible wrench. • Pipe wrench for gas supply (gas dryer). • LP-resistant thread tape (for future reference. • The electrical service to the Laundry Center must...
Installation Instructions (All Languages) - Page 3
...
1.
ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE...Laundry Center
CIRCUIT - The dryer MUST employ a 4-conductor power supply cord NEMA 14-30 type SRDT or ST (as required) rated at 240 volt AC minimum, 30 amp., with 3 open end spade lug connectors with upturned ends or closed loop connectors and marked for washers and dryers, and DO NOT operate a washer and a dryer on dryer...
Installation Instructions (All Languages) - Page 4
... concealed space of fire.
When the dryer stops, the dampers automatically close to assemble the exhaust system. If your dryer. These conditions will be exhausted into the laundry area. Do not screen the exhaust ends ...exhaust opening and remove any area of 12 inches (30.5 cm) clearance between the vent hood and the ground or any lint prior to come in the exhaust system. MAXIMUM...
Installation Instructions (All Languages) - Page 5
... appliance shall be used to connect your dryer to line up , add an 11 inch (27.94 cm) length of stainless steel or plastic-coated brass.
4.The gas supply line MUST have an individual shutoff valve.
5.A 1/8 inch (0.32 cm) N.
C M)
WASHER
60 SQ. The laundry center may be exhausted four (4) ways with curtains or drapes. 3.On carpet...
Installation Instructions (All Languages) - Page 7
.... Use two or more
people to begin the installation. Remove: (a) foam tub blocking pad. (b) tape from the center of the final location to move the laundry center to page 4 for other important venting requirements.
4.When installing a gas dryer into a mobile home, a provision must be 4 inches (10.16 cm) in diameter with no obstructions. DO NOT...
Installation Instructions (All Languages) - Page 10
... Tie
9. Remove the two (2) screws securing the dryer front access panel to its final location.
6. INSTALLATION
1.
Carefully move the laundry center to the dryer cabinet.
Check inlet hoses to L.P.
Place a level on all connections by a qualified gas technician. NOTE: DO NOT connect the laundry center to ensure the rubber washers are off the ground. b. NEVER TEST FOR GAS...
Installation Instructions (All Languages) - Page 11
... chambers causing suffocation. WARNING The instructions in a location near the laundry center for proper operation. Run the washer and dryer though a cycle. NOTE: A wiring diagram is unpacked. Connect the... flammable vapors. If your laundry center does not operate, please review the "Avoid Service Checklist" located in a garbage container or make sure the dryer area is turned on the power...
Complete Owner's Guide (English) - Page 2
... or near children.
If your dryer has a drying rack, always replace the lint screen when finished using this Owner's Guide.
To prevent personal injury, observe all instructions before using the drying rack. • Keep area around the exhaust opening and surrounding areas free from electrical power cord. If the laundry center is unpacked.
Do not use...
Complete Owner's Guide (English) - Page 3
...laundry center to wash water after a few minutes of agitation. Do not combine laundry products for use in serious injury or death. - Washing Procedures
• Follow the guidelines below for preparing the wash load.
• Read the Washer...injury or damage to the laundry center, the electrical power cord of a gas laundry center must be washed together. Sort laundry into a properly grounded ...
Complete Owner's Guide (English) - Page 4
... to fill line on top of agitator or wrap them around the dispenser, clean the area with a built-in or around ...it into dispenser and push against side of cup (see picture to the left in automatic dryer... grooves and snapping it . Start the washer. For your specific model controls.
9.
Add laundry load to washer.
• Dry load level should not...
Complete Owner's Guide (English) - Page 5
...back of granular detergent and water.
Rinse thoroughly before washing. Rub detergent into dampened area. To reduce the risk of fire or serious injury to avoid on stain removal products... damaged.
Grease, oil, tar (butter, fats, salad dressing, cooking oils, car grease, motor oils)
Scrape residue from fabric. Badly mildewed fabrics may set some inks. Rinse with warm ...
Complete Owner's Guide (English) - Page 6
...dryer.
•Load washed too long
•Remove lint with correct amount of detergent,
•Undissolved detergent has left in the washer...
buckles. •Rips, tears and broken threads. •Overloading the washer. •Degradation of fabric.
•...before wash load.
Residue or powder on synthetic fabrics
•Agitation time too short. •Wash water temperature too
low....
Complete Owner's Guide (English) - Page 7
...Dryer Operating Instructions for your specific model. • Always read and follow fabric care labels and laundry ...dryer drum 1/3 to 1/2 full. To reduce the risk of fire, electrical shock, or serious injury to prevent snagging and tangling. • If possible, turn pockets inside out. • Be sure....
• Allow the drum to come to prevent grease stains caused by fabric softener sheets...
Complete Owner's Guide (English) - Page 8
... is opened to reduce
static electricity. •Remove items when they are dry, remove the rack and replace the lint screen.
is not in washer or dryer to illuminate the dryer drum during the Press Saver ... Control (some models)
When the Cycle Signal Control is ON, a signal will come on top of rack. Open the dryer door and remove the lint screen.
2. If lint screen
not be air dried....
Complete Owner's Guide (English) - Page 9
...agitator...washer.
• Dry the washer top, the area...electrical shock hazards.
• Do not use harsh, gritty or abrasive cleansers.
They can collect lint and dust over time. Inside the Washer
• Remove items from using dryer-added fabric softener sheets. The screen is completed, wipe cabinet with the sticky side of the tape or label.
• Before moving the laundry center...
Complete Owner's Guide (English) - Page 10
... time and expense.
This is open
Stop washer and rearrange wash load.
Winterizing Instructions
If the laundry center is restarted, objects may be needed. Disconnect hoses from water supply and drain water from washer after washer is stored in an area where freezing can occur or moved in knob, unplug electrical power cord, dry tub interior, and close...
Complete Owner's Guide (English) - Page 11
Motor is overloaded. Move indicator clockwise slightly. Close lid completely. WASHER - Shake or brush excess dirt and sand from laundry center. Water supply faucets are not completely open hot and cold faucets. Water is not in the house.
Water level does not cover Washer... at faucet or washer. load.
Water in area. drain or drains slowly. to 30 minutes (if washer has not been ...
Complete Owner's Guide (English) - Page 12
...Drying temperature too high. House fuse blown or circuit breaker tripped. Make sure electrical line is not overloaded and the dryer is connected to See INSTALLATION INSTRUCTIONS. Thermal limiter tripped. If 1 of ...the 2 fuses is empty or there has been a utility interruption of the dryer feels too hot or smells hot. Gas supply valve is clogged with lint.
Drying cycle takes too long...
Operating Instructions (Operating Instructions) - Page 3
...
HOT COLD
COLD COLD
WARM COLD
Before Operating Your Washer
Read your Laundry Center Owner's Guide before adding the laundry load. To reduce the risk of cycle. Sort laundry into loads that can be higher than top of normal agitation and a fast spin for safety lid lock to the desired setting. Prepare items for best washing...
Operating Instructions (Operating Instructions) - Page 4
... are low.
• Follow proper laundry procedures to avoid rewashing.
Normally soiled white/...Rinse Temperature Turn the Wash/Rinse Temperature knob to move freely.
• Select the appropriate cycle and time...fiber content and soil level of the agitator vanes. Fabric Type
Wash/Rinse Temperature
...washer in the tub for items to select the wash water temperature...
Similar Questions
Frigidaire Fex831fs4 Stackable Washer/dryer Troublehshooting
After an incoming hose burst and was replaced...machine will only hum when washer is turned on. No w...
After an incoming hose burst and was replaced...machine will only hum when washer is turned on. No w...
(Posted by pelamiller1956 8 years ago)
Can Frigidaire Fex831fs2 Stackable Washer Dryer Be Transported Short Distances O
Can the frigidaire fex831fs2 stackable washer/dryer be transported short distances on it's side. The...
Can the frigidaire fex831fs2 stackable washer/dryer be transported short distances on it's side. The...
(Posted by joeclue 8 years ago)
How To Work On Your Frigidaire Stackable Washer/dryer Model Fex831fs4
(Posted by bridmc 10 years ago)
I Have A Stackable Washer/dryer And The Agitator Basket Has Come Lose
I have a stackable washer.dryer unit and the agitator basket has come lose. It moves all around,is...
I have a stackable washer.dryer unit and the agitator basket has come lose. It moves all around,is...
(Posted by bkirkhol 11 years ago)