Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by finerty on November 29th, 2012
What Is The Washer Dryer Capacity On This Fex831fs2
What is the washer dryer capacity on this FEX831FS2
Mom's broke in 3 yrs with lite use. Can't find size to shop & compare new one.
Current Answers
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
...; External vent hood.
• Gas line shutoff valve (gas dryer).
• Rigid or semi-rigid metal 4 inch • ½ NPT union flare adapters (x2) and
(10.2 cm) exhaust duct work. do not use them for future reference. • The electrical service to the Laundry Center must be killed or seriously injured if you don't follow...
Installation Instructions (All Languages) - Page 3
... MUST be : Minimum height: 33 inches (83.82 cm) Maximum height: 96 inches (244 cm)
OUTLET RECEPTACLE - DRAIN REQUIREMENTS
WARNING -
POWER SUPPLY CORD -The gas laundry center is prohibited for use grounding terminal or lead to ground appliance in accordance with clothes dryers. See ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM.
4 wire - branch circuit fused with clothes...
Installation Instructions (All Languages) - Page 4
... exhaust system. Do not screen the exhaust ends of every 18 months with exhaust system. Use an approved vent hood to prevent drafts and the entrance of Fire - The exhaust system ... back pressure MUST not exceed 0.6 inches (1.52 cm) of a building. Do not exhaust dryer into the laundry area. Exceeding the length of duct pipe or number of elbows allowed in any other flammables ...
Installation Instructions (All Languages) - Page 5
... CLOSET
1.A laundry center installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors.
2.No other fuel burning appliance shall be installed in Canada, the current AN/CGA B149.
2.The gas supply line should be of 1/2 inch (1.27 cm) pipe.
3.If codes allow, flexible metal tubing may be used to connect your dryer to line...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR...¼ IN (104.77 CM) 29 7/16 IN (74.77 CM)
3 ¾ IN. (9.52 CM)
36 1/16IN. (91.60 CM)
27 IN. (68.58CM)
25 ¼ IN. (64.13 CM)
47"
2 ½ IN. (6.35 CM)
1 7/8 IN. (4.76 CM)
4...
Installation Instructions (All Languages) - Page 7
... block should be retained.
3. Metal ducting must be made for Mobile Homes.
Use two or more
people to move the laundry center to within 4 feet (1.22 m) of the dryer exhaust outlet.
5.Installation MUST conform to begin the installation. MOBILE HOME INSTALLATION
1.Dryer MUST be exhausted outside make up air. Rigid metal duct is preferred.
2.If...
Installation Instructions (All Languages) - Page 8
... with all local codes and ordinances. Refer to the pre-installation requirements in this laundry center utilizes and can result in a risk of the equipment
grounding conductor can melt, creating electrical shock and/or fire hazard. Canadian ELECTRIC Laundry Center
WARNING Do not use an extension cord with a licensed electrician if you are in doubt as to...
Installation Instructions (All Languages) - Page 9
... to the cabinet with the green ground screw.
6.
Tighten both screws securely.
8.
Tighten the screw securely.
7. NON-CANADIAN ELECTRIC Laundry Center
1. Remove the neutral ground wire from the power cord to the silver colored center terminal on the back panel.
3. Attach the green power cord ground wire to the rear panel and remove cover...
Installation Instructions (All Languages) - Page 10
...laundry center back down to the 3/8 inch (0.96 cm) pipe located on the left side of the dryer. Remove the shipping cap from the hot and cold faucets to the water valve (on the back of the washer...level and solid on top of the dryer.
d. Place the formed end in a laundry tub or a standpipe and secure with the hose pointed toward the drain. Use a 1/2 inch (1.27 cm) to 3/8 inch (0.96 cm...
Installation Instructions (All Languages) - Page 11
... and caution MUST be bled of combustion and ventilation air. Use duct tape to seal all wires prior to "OFF" and wait 5 minutes before plugging the power cord into a grounded outlet.
12.
Run the washer and dryer though a cycle. Check for play. If your laundry center does not operate, please review the "Avoid Service Checklist...
Complete Owner's Guide (English) - Page 2
...using the washer, turn on or in your building.
Prevent Fire • Do not wash or dry items that have every feature included.
• Immediately call the fire department. Use Air Fluff (No Heat) only. • Clean the dryer lint screen before using this laundry center...Instructions
Grounding type wall receptaGcAleS LAUNDRY CENTERS:
Avoid fire hazard or electrical shock. Note: The ...
Complete Owner's Guide (English) - Page 3
...laundry load. Washing Procedures
• Follow the guidelines below for preparing the wash load.
• Read the Washer Operating Instructions for use...size and soil level, and water hardness.
5.
Prepare items for details.
4. Add a measured amount of fire, electrical shock, or injury to persons, read and follow fabric care and laundry...damage to the laundry center, the electrical power cord ...
Complete Owner's Guide (English) - Page 4
... spin, push in dispenser (see picture to type, size, and soil level of each use. If fabric softener builds up the ribs and grooves ...not load items higher than the top of agitator vanes. Add laundry load to the final rinse. For models with hot water..... • To stop the washer, push in the cycle selector knob. • To change a cycle, push in automatic dryer, line dry, or dry flat...
Complete Owner's Guide (English) - Page 7
...immediately and hang or fold. Fill dryer drum 1/3 to prevent tangling and for your specific model. • Always read and follow fabric care labels and laundry product labels. Close zippers, fasten...the Dryer Operating Instructions for even drying and less wrinkling. To reduce the risk of fire, electrical shock, or serious injury to persons or property, comply with small and medium sized items...
Complete Owner's Guide (English) - Page 8
...causes static
electricity.
•Lint screen not clean when
cycle began.
•Lint is not in washer or dryer to reduce
static electricity. &#...Use a lint brush or shaver to remove pills.
•Use fabric softener to reduce abrasion.
•Irreversible condition.
•Reduce load size and tumble at the end of load before
starting the dryer.
•Reduce load size and rewash using...
Complete Owner's Guide (English) - Page 9
...the washer or dryer interior, unplug the electrical power cord to avoid electrical shock hazards.
• Do not use ...washer interior, unplug the electrical power cord to future loads.
Remove the lint and replace the screen.
• Occasionally a waxy build-up in the hoses.
• Clean the cabinet with water.
• The agitator or tub may remain on the laundry center...
Complete Owner's Guide (English) - Page 10
.... 5. A certain amount of balance. Rattling and clanking noise.
This is a circuit overload, have not been See INSTALLATION INSTRUCTIONS for service, review this laundry center.
Turn off water supply faucets. 2. Wash load unevenly distributed in knob, unplug electrical power cord, dry tub interior, and close lid. 7.
Push in tub. Do not overload washer. Thumping sound.
Complete Owner's Guide (English) - Page 11
...stop if it enters slowly.
Washer won't spin. Lid is overheated. Close lid completely. Residue left in area.
Shake or brush excess dirt and sand from laundry center. Wash load too wet ... cleanser, then rinse.
distance from items before or during washer use at faucet or washer.
Straighten hoses. Do not overload washer. When control is set too low or is filling. Measure...
Operating Instructions (Operating Instructions) - Page 1
... after every load.
Use Cool Down to freshen clothing, pillows or blankets, or to ON, hold for 5-10 minutes. Turn cycle selector clockwise to handle during unloading.
This reduces wrinkling and makes items easier to desired setting. Drying time is best for obtaining the best drying results.
7.
LAUNDRY CENTER DRYER OPERATING INSTRUCTIONS
AUTOMATIC
COOL...
Operating Instructions (Operating Instructions) - Page 3
...electric shock, or injury to wash tub before operating this appliance. The dry load should not be washed together.
2. Select the wash cycle and settings according to the desired cycle. Close lid and pull out cycle selector knob to restart the washer.
10. To change a cycle, push in your Laundry Center...the Cycle Selector knob clockwise to type, size, and soil level of normal agitation and...
Similar Questions
Diy Replace Heating Element For Glet1031fs Combo Washer Dryer
Need video on diy replace heating element for GLET1031FS combo washer dryer
Need video on diy replace heating element for GLET1031FS combo washer dryer
(Posted by rvidaud 7 years ago)
Can Frigidaire Fex831fs2 Stackable Washer Dryer Be Transported Short Distances O
Can the frigidaire fex831fs2 stackable washer/dryer be transported short distances on it's side. The...
Can the frigidaire fex831fs2 stackable washer/dryer be transported short distances on it's side. The...
(Posted by joeclue 8 years ago)
Washer Dryer Combo, Washer Won't Agitate, Dryer Wont Heat Up
(Posted by sakparr25 10 years ago)
Dryer Of Washer Dryer Combo Not Heating But Turning
The dryer in my washer dryer combo not drying but running.Just started with second load
The dryer in my washer dryer combo not drying but running.Just started with second load
(Posted by Kmbates10 11 years ago)
Broken Agitator In Stackable Washer/dryer Smell Coming From Motor
I have a stackable washer.dryer unit and the agitator basket has come lose. It moves all around,is...
I have a stackable washer.dryer unit and the agitator basket has come lose. It moves all around,is...
(Posted by bkirkhol 11 years ago)