Home » Dodge » Technical Support » 2010 Dodge Avenger

2010 Dodge Avenger Support Question

Find answers below for this question about 2010 Dodge Avenger.
Need a 2010 Dodge Avenger manual? We have 2 online manuals for this item!

Dodge Overview Questions Manuals Reviews Videos Research

Question posted by twetz on September 22nd, 2014

Change Language

how and where do you change the language from spanish to english?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on September 22nd, 2014 1:24 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,427

1,100
points

Personal Settings (Customer-Programmable Features)

Personal Settings allows the driver to set and recall

features when the transaxle is in PARK.

Press and release the MENU button until Personal Settings displays in the EVIC.

Use the SCROLL button to display one of the following choices.

“Language”

When in this display you may select one of three languages

for all display nomenclature, including the trip

functions and the navigation system (if equipped). Press

the RESET button while in this display to select English,

French, or Spanish. Then, as you continue, the information

will display in the selected language.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related Manual Pages

Owner Manual - Page 22

... Information Center (EVIC)/Personal Settings (Customer-Programmable Features)" in "Understanding Your Instrument Panel" for at least four seconds, but not longer than 10 seconds. To change the current setting, proceed as follows: • For vehicles equipped with the EVIC, perform the following procedure: 1. Then, press and hold the LOCK button on...

Owner Manual - Page 23

... transmiting Your Instrument Panel" for at least four seconds, but not longer than 10 seconds. This feature can be turned on a programmed Alarm system. To change mitter with the Electronic Vehicle 4. Test the feature while outside of the vehicle, by the doors are inside the vehicle will cause the alarm to...

Owner Manual - Page 24

... the alarm to "Electronic 2 Opening a door with the ignition in "UnderstandThe time for this feature to lock all doors. Press the UN- Illuminated Approach - To change the current setting, proceed as follows: system. Test the feature while outside of the vehicle, by Vehicle Information Center (EVIC)/Personal Settings pressing the LOCK...

Owner Manual - Page 27

... Remote Start. Weak battery in the RKE transmitter. proved by the party responsible for these two conditions. niently from a normal new battery with an autoNOTE: Changes or modifications not expressly ap- The system has a range of FCC rules and with 1. Remove and replace the battery. General Information This device complies with...

Owner Manual - Page 68

...; The Airbag Warning Light remains on after airbag deployment or near deployment (if applicable), and up to a quarter second of either highspeed deceleration data or change in a collision. EDR data is ONLY recorded if an airbag deploys, or nearly deploys, and is designed to be maintenance free, if any engine related...

Owner Manual - Page 81

... sure everyone in hot weather. 80 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE The engine oil installed in a seat and using a seat belt properly. Oil changes should be seriously injured or killed. • Do not allow people to "Maintenance Procedures" in and not interpreted as an indication of difficulty. WARNING! •...

Owner Manual - Page 82

...a competent mechanic inspect the complete exhaust system and adjacent body areas for lubrication or oil change is noticed in or out of the vehicle is set at high speed. Open seams or... system, when exhaust fumes can eventually poison you. Set the blower at high speed. Whenever a change . Replace as required. 2 Exhaust gases can injure or kill. If you unconscious and can be...

Owner Manual - Page 87

... Washers ...112 ▫ Headlights And Parking Lights ...107 ▫ Automatic Headlights - If Equipped ...108 ▫ Headlight Time Delay ...108 ▫ Turn Signals ...108 ▫ Lane Change Assist ...109 ▫ High/Low Beam Switch ...109 ▫ Flash-To-Pass ...109 86 UNDERSTANDING THE FEATURES OF YOUR VEHICLE ▫ Fold-Flat Front Passenger...

Owner Manual - Page 110

... switch the headlights to -pass operation. 3 there is a very fast flash rate, check for the next defective. UNDERSTANDING THE FEATURES OF YOUR VEHICLE 109 Lane Change Assist Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then...

Owner Manual - Page 114

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 113 3 Windshield Wiper/Washer Lever Changing Wiper Speeds Rotate the end of the lever to the LO position for position if you turn the ignition switch to the HI position for ...

Owner Manual - Page 115

... wiper delay times depend on vehicle speed. Intermittent Wiper System Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause Changing Intermittent Settings between cycles. Rotate the end of the windshield wiper/washer control lever to select the desired delay If the vehicle is left in...

Owner Manual - Page 121

... VEHICLE ACCEL lever. WARNING! An accident could lose control. When the pedal is released, the vehicle will increase speed by 3 mph (5 km/h), etc. A slight speed change on roads that tapping the lever three times will return to the set speed. Each time the lever is reached, and the new set , push...

Owner Manual - Page 124

...Code System." If the indicator light blinks rapidly for the HomeLink௡ indicator to change flash rates. Simultaneously press and hold the just-trained HomeLink௡ button and ...procedures noted in 5. If the indicator light stays on constantly, programming is When it changes, it is pressed. Programming A Rolling Code System the "Gate Operator/Canadian Programming" section...

Owner Manual - Page 128

...: • The transmitter has been tested and it complies with FCC and IC rules. This device must accept any interference that may be POWER SUNROOF - Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. • The term IC before...

Owner Manual - Page 169

...drivable distance of Reset will RESET button a second time within three seconds of continue until ENGLISH or METRIC appears. Press and hold the RESET button once to the current fuel tank level...When the DTE value is currently the vehicle, regardless of the DTE display value. NOTE: Significant changes in the tank. displayed. This display will only occur if a resettable function is less than...

Owner Manual - Page 172

...in this display selects NOTE: The Variance Values will be shown in the selected language. Variance" and the current Variance Value displays in PARK. (Customer-Programmable Features)... will wrap around from 15 English, Spanish, French, German, Italian, or Dutch deback to increment the Variance Value by one, (one button press per update), Language until "Personal features when the...

Owner Manual - Page 175

...- Display Units In The EVIC and odometer can be turned on the lower right NOTE: The ignition switch must be changed between English and Metric units of the radio faceplate. If Equipped The "ECO" message is located on or off. Radio Mode...measure. MEDIA CENTER 230 (REQ) - To make your selection, press and release the FUNCTION SELECT button until "ENGLISH" or "METRIC" appears.

Owner Manual - Page 180

... to play the current station with the same selected Music Type name. Repeatedly pressing SELECT will switch subtitles to different subtitle languages that are NOTE: Turn the TUNE/SCROLL control knob to the preset station. • DVD Play Options - The highlighted... toggle between the following : Pressing the SETUP button allows you to select an entry and make changes. • Audio Stream -

Owner Manual - Page 181

...again to select. Allows you to change • Set Home Clock - Selecting this item will change the Enter the four-digit country code using the TUNE/ mode of the above entries changes. defaults according to choose the &#...select Љother.Љ • VES™ CH1/CH2 - language supported by SCROLL control knob to adjust the hours and then press and turn VES™ ON and...

Owner Manual - Page 182

... choose between wide screen, pan scan, and letter box. You can select a language not listed by scrolling down and selecting Љother .Љ Enter the country ...If changes are made to these defaults before Selecting this item allows you to choose a default subtitle language (effective only if the language is set to choose between subtitle loading a disc. Subtitle Language -...