My Dish Network Remote Will Turn The Tv Off But Cant Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... local programming from an off -air antenna, then the channel range to the television's user manual for typical in the TV as normal. This is accomplished by simply changing the TV channel to the "SAT" button on the remote control and change channels on channel 25. When the TV was therefore not preset in -home cabling systems. Programming...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... at TV Home: Help: Remote & Keyboard: Setting up the appropriate device on the right side of equipment and the location where the remote is in satellite mode by various light sources including direct sunlight, halogen and fluorescent lighting, or obstructions to the device. We do have enough power left to remote commands or changing channels on...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...remote commands or changing channels on the back of the receiver between the piece of the receiver. Is there an IR-to Troubleshooting w/ TV/VCR/AUX remote flow For dual tuner receivers: Verify the correct remote...not, continue. this takes approximately 5 minutes Place the receiver in standby mode by turning the receiver off from the AC electrical outlet. Caution: The Smart Card could ...