Brother International PE-400D Support Question
Brother International PE-400D Support Question
Find answers below for this question about Brother International PE-400D - Embroidery And Sewing Machine.Need a Brother International PE-400D manual? We have 2 online manuals for this item!
Question posted by fryman123 on April 23rd, 2014
Bobbin Keep Eating The Top Thread
when emboaring the top theard wrap around the bobbin
Current Answers
Related Brother International PE-400D Manual Pages
Users Manual - English - Page 2
... play with same type rated 8V 2.4 watts. Never operate this sewing machine if it has a damaged cord or plug, if it is required around the sewing machine needle. 11. Special care is not working properly, if it to persons.
1. Always use as threading needle, changing needle, threading bobbin, or changing presser foot, and the like. 15.
It...
Users Manual - English - Page 6
... buttons 10
BASIC SEWING MACHINE
OPERATION 11
FLAT BED EXTENSION TABLE 11 Free arm 11
POWER SUPPLY 12 USING THE SCREEN KEYS 13 ABOUT THE SCREEN 13 ADJUSTING THE BRIGHTNESS OF THE SCREEN 13 HOW TO CHANGE LANGUAGE 14
How to the embroidery unit 77 Removing the embroidery frame 77 Embroidering 78 THREAD TENSION 80...
Users Manual - English - Page 7
...
BEFORE TAKING YOUR MACHINE IN FOR SERVICE 100
Basic sewing machine maintenance .......... 100
ERROR MESSAGES 103
Warning messages 103 Instruction messages 105 Alarms 105
SEWING CHART
106
PATTERNS (PROGRAMMED IN MACHINE)
107
Utility stitches 107 Character embroidering chart 107 Frame pattern embroidering chart 107
4
PATTERNS (MEMORY CARD)
108
ONE POINT MARK EMBROIDERY PATTERN 108
Users Manual - English - Page 10
... (Stabilizer material)
15 Net **
16 Foot controller
17 Embroidery bobbin thread
18 Spool felt*
Part Code X56409-001 103561-002 X59375-051 XA3336-051 X59476-051 184783-001 XA5357-001 XA2005-051
- - - - only) Foot controller : Model N5V This foot controller can be used for sewing machine model PE-300S/PE-400D.
7 XA5523-050 XC1154-051 SABTS (USA) X81164...
Users Manual - English - Page 19
... in bodily injury and/or damage to the machine. Turn the power on.
ೖI O
2. For sewing, use bobbins that the spool pin is pulled out and pushed toward the back of the sewing machine.
1 Spool pin
16 BOBBIN WINDING / BOBBIN THREAD SETTING
Note: Always use the plastic bobbin (X80309-001) for sewing.
5·11
4
2·3
7
6·8
ઃఆ
࣍...
Users Manual - English - Page 21
..." button.
Trim the excess thread from the inside.
While holding the thread end, press the "START/STOP" button. The bobbin will stop the sewing machine.
11. Guide the thread through the small hole in the bobbin with the
spring on the shaft and place the bobbin on the shaft
2 Groove of the bobbin after the machine stops.
2 1
18
8. Align the...
Users Manual - English - Page 28
... pulling out the bobbin thread. * Use the J presser foot.
3. TRIAL SEWING
CAUTION - Pass the thread underneath the presser foot and pull it out from all times while sewing, and keep your right hand to lower the needle to the sewing start position.
1 Thread
25 Be aware of the machine by about 5 cm.
1 Upper thread 2 5 cm (13/64")
* Sewing can easily...
Users Manual - English - Page 33
... before beginning on the tension dial is set to the most appropriate point irrespective of fabric. 2 Surface 3 Upper thread 4 Bobbin thread 5 Looser
ɹ
* The 5 setting on the actual piece to be worked.
* The machine may stop sewing if tension is a guide for gathers. This is not a sign that there is automatically set extremely low. Simply...
Users Manual - English - Page 77
... hoop 2 Stabilizers
- Use a stabilizer that is to embroider any patterns.
embroidery bobbin thread (X81164-001) Perfect needlework cannot be torn
off after you might wish to use ballpoint needles.
* Use Brother embroidering thread (X81164-001) for lightweight fabrics and/or stretchable fabrics. Home sewing machine needle 75/11 Do not use a thick stabilizer or two layers...
Users Manual - English - Page 81
... color, then stop the sewing machine and cut off any color you embroider when the bobbin thread is suggested color
to Color screen.
2. If you like.
· Refer to use.
· Some parts may not have been sewn, stop automatically. (When it through embroidery foot "Q". The order of slack in the thread. Thread the needle for each...
Users Manual - English - Page 83
...;
ɹ
ɹ
When doing machine embroidery, the tension dial should be loose
Poor stitch tension can result in poor stitch conformation, puckered fabric and thread breakage.
This is about one -point patterns on top. THREAD TENSION
Set thread tension according to the fabric you reduce the tension by a half notch when sewing the outline. Fabric
Dial...
Users Manual - English - Page 92
... stitch of the color without sewing. Goes back one stitch at a time. Stop the machine, raise the needle and foot, and rethread the machine.
· If the bobbin thread breaks
1 Cut the upper thread, raise needle and foot, and remove hoop.
2 Reset the bobbin thread, then reattach hoop.
2. IF THE THREAD BREAKS DURING EMBROIDERY
If the upper thread breaks
1. Press "
" key...
Users Manual - English - Page 100
... detergent, squeeze it out firmly and then wipe the surface. Loosen the screws.
5 3
3. Cleaning the sewing machine surface
If the surface of the sewing machine is dirty, wipe it again with a soft, dry cloth. It should be affected and bobbin thread detection will be kept clean at all times.
1. Turn off the power and remove the...
Users Manual - English - Page 103
... in the race or shuttle.
P.97~98
NO
Bobbin is not correct.
TROUBLESHOOTING
BEFORE TAKING YOUR MACHINE IN FOR SERVICE
Basic sewing machine maintenance
Before calling for repairs.
100 P.34
NO
Fabric puckers
Threading is not correctly set. Remove thread ends in the race or inner shuttle.
P.34
NO
Correct needle is not used
Change to...
Users Manual - English - Page 104
... the eye of bobbin thread is not correct. P.20
NO
Set of the needle. Set bobbin properly and pull out the bobbin thread.
P.35
NO
The embroidery frame has been ...fabric has been placed in the embroidery frame correctly.
Change presser foot to the machine incorrectly.
Check "RELATED CHART OF SEWING FABRICS, THREAD AND NEEDLE". Thread is not properly attached. Set ...
Users Manual - English - Page 105
.... * If the power shuts off by itself while sewing: Turn sewing machine off the power then insert the memory card. Note * This machine comes equipped with an upper thread sensor to see if the machine is too wide for repairs.
Start the sewing machine again according to the machine.
P.12
NO
Embroidery unit is not inserted.
Needle breaks
Needle is...
Accessory Catalog - Page 3
..., 400D M: PC2800, 3000, 6000, CS8072 N: PS2200, 2300, 2500 O: PS1000, 1250,1800, 1950, 2100 P : LS1520, 1717, LS2000 series, VX1400/1500 series Brother Sewing Machine Lineup
03
Please select your very own customized stitches or embroidery motifs. Loaded with these compact and mid-sized sewing machines.
Perfect for class or to introduce sewing to make your machine from these machines...
Accessory Catalog - Page 27
..., others fit perfectly on water soluble stabilizer so that can be embroidered on garments for the youngsters in various sizes. Add your embroidery work that added touch of home embroidery machines (.pes, .dst, vip, .hus, .art, .exp, .jef, .xxx).
NO 77
Card No. 78 Combination Lace
SA378: 31 designs for weddings, birthdays and baby...
Accessory Catalog - Page 33
...-is 900D series, SE-350, HE-240, LB6770, Innov-is 4000D/2500D/1500D
SA560 QuattroTM 6000D
Embroidery Machine Hoops
Select hoops appropriate for your machine. SA539 DuettaTM4500D,Innov-is 500 series, SE-270D, HE-120 series, PE-300S, PE-400D:
• Large: 172 x 100 mm (approx. 6-3/4 x 4 inches)
• Medium: 100 x 100 mm (approx. 4 x 4 inches)
SA432
•...
Accessory Catalog - Page 34
... and White): The 1,100-meter (approx.1,200-yds) filament thread is best suited for the Quattro™ 6000D, Duetta™ 4500D/Innov-is 4000D, 2500D, 1500D, 1200 series, PC and ULT series machines and the PE-400D and Innov-is color keyed to hoop your sewing counter or can illustrate more of fabrics with a high...
Similar Questions
Can I Use Pes File In My Disney Brother Embroidery Machine Pe 180d
Can i use a pes file in my disney brother embroidery machine pe 180d
Can i use a pes file in my disney brother embroidery machine pe 180d
(Posted by emschwartz35 2 years ago)
Tension For Sewing Forward How To Adjust?
How do I adjust the tensions for sewing forward?
How do I adjust the tensions for sewing forward?
(Posted by Sandy2425 3 years ago)
I Need A Repair Manual For The Se270d Embroidery/sewing Machine. Error F05
I need a repair manual for the Brother SE270D Embroidery/Sewing Machine, to fix error F05. The cost ...
I need a repair manual for the Brother SE270D Embroidery/Sewing Machine, to fix error F05. The cost ...
(Posted by romaplovell 10 years ago)
What Kind Of Design Cards Do I Use With This Machine Ped, Pes??
(Posted by lumplump 12 years ago)
How Can I Get Thread Out Of Bobbin Winding Spindle?
I have the screws out of case but can't get case apart.
I have the screws out of case but can't get case apart.
(Posted by sandram40 12 years ago)