Sharp HN-VA401SU Support and Manuals
Get Help and Manuals for this Sharp item
View All Support Options Below
Free Sharp HN-VA401SU manuals!
Problems with Sharp HN-VA401SU?
Ask a Question
Free Sharp HN-VA401SU manuals!
Problems with Sharp HN-VA401SU?
Ask a Question
Popular Sharp HN-VA401SU Manual Pages
HNVA401SU Operation Manual - Page 2
... for a Class B digital device, pursuant to Part 15 of the following two conditions: (1) this ...radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause undesired operation. Operation is ...a particular installation.
Declaration of Conformity
SHARP PowerLine Ethernet Adapter, HN-VA400U and HN-VA100U This device complies with the limits...
HNVA401SU Operation Manual - Page 4
... of up to 85 Mbps on your powerline network. Up to four devices can be used.
2 If you for purchasing a SHARP PLC (PowerLine Communication) adapter kit.
Data can be purchased to the adapters with ease. Introduction
Introduction
Thank you have Broadband Internet service, connect your router to one of the adapters to allow all your network devices...
HNVA401SU Operation Manual - Page 5
... cables (2): 59.1" (1.5 m)
Operation manual
(Part order number: QCNWG337DXHZZ)
Safety Information
Do not disassemble the adapter or attempt any procedures not described in a wet basement. The adapter produces odors, smoke, or unusual noises. - The power cord is frayed or damaged. Refer all servicing to rain or water. -
Do not install or use the adapter outdoors.
3 Do not touch...
HNVA401SU Operation Manual - Page 7
... previous HomePlug adapters without mutual interference. The SHARP PLC adapter kit is only for service, it is recommended that you cancel the
registration of security, it is registered on your network. (Note that although 128-bit AES encryption provides a high level of your remaining adapters (see page 18).
♦If you lose an adapter, it does...
HNVA401SU Operation Manual - Page 8
... to
cancel the network registration of an adapter. (The SET button is also used to register the adapter on (see page 16).
4 Power cord
Plug this into an electrical outlet to connect the adapter to the network.
6 The two adapters in the HN-VA401SU kit have canceled
the registration of the adapter.)
2 POWER indicator
This lights green when...
HNVA401SU Operation Manual - Page 9
...LAN3
LAN4
5
5
LAN ports Connect network devices such as needed.)
Note: The HN-VA100U adapter has only one LAN port.
♦The indicator at the bottom left and right ...connected to
these ports using LAN cables. (Two LAN cables are off, the power is either off or the adapter is taking place: Blinks green: Communicating by 100BASE-TX Blinks orange or red: Communicating by 10BASE-T If both ...
HNVA401SU Operation Manual - Page 11
Installation
2 Make sure that the adapter is able to communicate. • To be able to communicate, the adapter must be registered. If you are provided in the HN-VA401SU kit have been registered at the factory.
The two
adapters in the kit. LAN1 LAN2 LAN3 LAN4
9
Firmly insert the cable ends until they "click" into place. •...
HNVA401SU Operation Manual - Page 13
... next to one of the existing adapters.
• Check the PLC indicator on the existing adapter and make sure it is not able to register the adapter.
SET
POWER
11 Registering an Additional Adapter
Registering an Additional Adapter
If you release the SET button, the POWER indicator will be cleared). Existing adapter
New adapter
2 Hold down too long (if...
HNVA401SU Operation Manual - Page 14
... and
then release it .
• If the PLC indicator on the new adapter does not light up to 30 seconds.
• Important: Do not remove either adapter from the outlet and plug it into the outlet where you release the SET button, the POWER indicator will blink and registration will stop blinking and...
HNVA401SU Operation Manual - Page 15
.... If the PLC indicator still does not light, it cool. Once the adapter has cooled, try plugging the adapters into a different outlet.
• If the temperature of the adapter rises to the following troubleshooting guide. Troubleshooting
Troubleshooting
If you cannot solve the problem, call 1-800-BE-SHARP. Make sure that the LAN cables are category 5 or 6 cables that are...
HNVA401SU Operation Manual - Page 16
... maximum distance is 492 ft. (150 m), however, this may be correctly set to their electrical outlets. Troubleshooting
Connection to the Internet is not possible.
• To connect to the Internet via the network, you also using PLC adapters of the PLC adapters. Network communication is correctly connected to one that your router is slow...
HNVA401SU Operation Manual - Page 17
...SHARP.
If the adapter still does not operate correctly, cancel the registration as explained on page 11. The PLC indicator blinks even though no data is used to prevent outsiders from gaining access to your network, remove the adapters...use your network. Troubleshooting
A PLC adapter does not operate, or does not operate correctly.
• Unplug the adapter from the electrical outlet...
HNVA401SU Operation Manual - Page 20
... going to discard or give an adapter to someone else, or have an
adapter serviced.
♦If you suspect that someone is
now complete. • Important: Do not remove the adapter from the outlet until the POWER indicator turns off (about 10 seconds) and then release the button. SET
2 Wait until the POWER indicator turns...
HNVA401SU Operation Manual - Page 23
... purchaser should follow the steps set forth herein are in its option, either repair the defect or replace the defective Product or part thereof with respect to enforce the rights under applicable state law, implied warranties may not apply. Your Product:
PowerLine Ethernet Adapter Kit
Warranty Period for any other than an authorized servicer. To find out the...
HNVA401SU Operation Manual - Page 24
Model Number HN-VA401SU Serial Number Date of Purchase Place of loss or theft. Space is also provided for easy reference, in case of Purchase
PRINTED IN THAILAND (TINSE4561XHTZ) SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-1163
1-800-BE-SHARP http://www.sharpusa.com
SHARP CORPORATION
FOR YOUR RECORDS Please record the model number and serial number...
Sharp HN-VA401SU Reviews
We have not received any reviews for Sharp yet.