Olympus 102-425 - iZoom 75 Ultra Compact APS Camera Support and Manuals
Get Help and Manuals for this Olympus item
View All Support Options Below
Free Olympus 102-425 manuals!
Problems with Olympus 102-425?
Ask a Question
Free Olympus 102-425 manuals!
Problems with Olympus 102-425?
Ask a Question
Popular Olympus 102-425 Manual Pages
Instruction Manual - Page 3
IF THE INTERNAL PARTS OF THE CAMERA ARE EXPOSED DUE TO DROPPING OR DAMAGE, REMOVE THE BATTERIES IMMEDIATELY TO PREVENT FURTHER USAGE. IN CASE OF MALFUNCTION, CONSULT YOUR NEAREST OLYMPUS DEALER OR OLYMPUS SERVICE CENTER.
3 IT CONTAINS A HIGH-VOLTAGE CIRCUIT. NEVER ATTEMPT TO DISASSEMBLE THE CAMERA;
Instruction Manual - Page 7
Diopter adjustment dial Green lamp Orange lamp Viewfinder Print type selector switch Selftimer/remote control button Battery compartment cover Cartridge cover release button Cartridge cover Tripod socket MODE and SET buttons Mid-roll rewind button Flash mode button LCD panel (date/time indicator)
7
Instruction Manual - Page 12
... cartridges with the
(unexposed) visual exposure indicator can result in camera trouble.
12 Using a damaged cartridge can be used with this camera. • When a cartridge with other than the
visual exposure indicator is loaded, the camera will rewind the film and set the cartridge to (exposed). • Take along plenty of film...
Instruction Manual - Page 30
...; Do not forcibly move the visual exposure indicator because this may damage the cartridge. Using a damaged cartridge can be reused after being rewound in camera trouble.
30 However, the visual exposure of that were rewound when no exposure has been made will remain (unexposed). This cartridge can result in mid-roll...
Instruction Manual - Page 43
After the Spot mode has been engaged or disengaged, check the selftimer/remote control and flash mode settings. Then press the shutter release button fully. Focus and exposure can be adjusted at a different point from the autofocus frame using the Spot mode.
43 3. Reposition your subject in the picture frame while keeping the shutter release button depressed halfway.
Instruction Manual - Page 46
The selftimer automatically disengages after you press the button. The shutter will be released about 12 seconds after release. 10 sec: Selftimer indicator lights
2 sec: Blinks
46 SELFTIMER
1. Aim at your subject, and press the shutter release button. Press the selftimer/remote control button to display
Fix the camera on a tripod or other support.
2.
Instruction Manual - Page 52
Press the MODE button for two seconds or longer. If you keep it pressed, the numbers will advance by 1. And if you press the button once, the number on the display will run in rapid succession.
52 CORRECTING THE DATA
1. Press the SET button to correct the year. The year indication will start blinking.
2.
Instruction Manual - Page 53
The month indication will be finished when the MODE button is pressed again.
53 Repeat steps 2 and 3 to set the day, hour and minutes. 3. Note: As you press the mode button, the blinking indication changes in the order of year, month, day, hour, and minute. The data correction will start blinking.
4. Press the MODE button again.
Instruction Manual - Page 59
• Avoid leaving the camera unused for manual inspection.
59 Try to press the shutter release button and check the operation of time. This can damage the film in your camera through these ... for long periods of the camera before use.
• Some airport X-ray machines can cause mold to grow on the camera as well as other problems. Try to avoid passing your camera.
Instruction Manual - Page 62
... approximately three years to avoid getting sand on use and wear. They may need more frequent replacement depending on or inside of your nearest Olympus service center. If you need replacement, contact your camera. If the gaskets are taking pictures at the beach, you are damaged or need to insure consistently good weatherproof performance...
Instruction Manual - Page 63
Keep the camera warm while using it.
Replace the battery with new one. (p. 16) The battery is temporarily unable to function because of the battery terminals is not correct.
TROUBLESHOOTING
OPERATING PROBLEMS The camera does not work
The lens barrier is exhausted. Remove the film. (p. 18)
63 Open the lens barrier completely. (p. 21) The...
Instruction Manual - Page 66
... Fill-in the dark. The orange lamp blinks, and the shutter release button will not release.
Set the flash mode to Off. The flash has not been recharged yet.
The flash mode is being used. Remove your finger from the shutter release ...
Instruction Manual - Page 67
.... (p. 13)
The cartridge cover does not open even though the cartridge cover release button is not adjusted.
Then replace the battery with a new one.
The camera moved when the
shutter release button was pressed. Diopter dial is pressed. PROBLEMS WITH PRINTED
PICTURES
The picture is exhausted.
The battery is out of focus.
Instruction Manual - Page 73
delay.
73 Automatic setting range: ISO25 ~
ISO3200. Rewind possible at end of film, automatic rewind stop). Film loading: One-touch insertion,
automatic loading (automatically ...film rewind (automatic rewind activation at any point with approx. 12-sec. Selftimer: Electronic selftimer with rewind button. Film speed range: Automatic setting. Film advance: Automatic film advancing.
Instruction Manual - Page 78
.... 5 m (16.4ft). Battery: One CR1220, replace-
Weight: 11 g (0.4 oz) (without battery). THE ACTUAL PRODUCT MAY DIFFER
FROM ONES SHOWN IN THIS
78
MANUAL. service life - Dimensions: 32 x 44 x 13mm (1.2 x 1.7 x 0.5 in). Other: Operating confirmation beeper;
SPECIFICATIONS ARE SUBJECT TO
CHANGE WITHOUT ANY NOTICE OR
OBLIGATION ON THE PART OF THE
MANUFACTURER. weatherproof design...
Olympus 102-425 Reviews
We have not received any reviews for Olympus yet.