Sonar and DSI Installation Manual
Page 6
.... Be careful when mounting a transducer inside surface of the hull, where the transducer is long enough to reach the sonar unit. Apply pressure to set before moving the boat. 6 0.TWEETY INSTALL_SONAR_DSI.indd 6 9/14/2011 11:55:32 PM Sand the hull until it is in contact with an ... sanded area should be about 1-16" or 1.5 mm) on the face of the transducer. Epoxy is setting. Make sure there are no air pockets Epoxy Hull in place while the epoxy sets. out on the hull. Once epoxied into the epoxy, turning it bottoms Epoxy transducer to move the transducer...
.... Be careful when mounting a transducer inside surface of the hull, where the transducer is long enough to reach the sonar unit. Apply pressure to set before moving the boat. 6 0.TWEETY INSTALL_SONAR_DSI.indd 6 9/14/2011 11:55:32 PM Sand the hull until it is in contact with an ... sanded area should be about 1-16" or 1.5 mm) on the face of the transducer. Epoxy is setting. Make sure there are no air pockets Epoxy Hull in place while the epoxy sets. out on the hull. Once epoxied into the epoxy, turning it bottoms Epoxy transducer to move the transducer...