Hunter 21315 Support and Manuals
Get Help and Manuals for this Hunter item
View All Support Options Below
Free Hunter 21315 manuals!
Problems with Hunter 21315?
Ask a Question
Free Hunter 21315 manuals!
Problems with Hunter 21315?
Ask a Question
Most Recent Hunter 21315 Questions
Sicil Fan Model 21315
pull cord for fan just hanging someone may have pulled to hard where does it go? fan still running a...
pull cord for fan just hanging someone may have pulled to hard where does it go? fan still running a...
(Posted by HUNTER3729 9 years ago)
Troubleshooting - Hunter Ceiling Fan 21315-530
Our ceiling fan lights just started to blink when you turn the light on. Sometimes it will stop but ...
Our ceiling fan lights just started to blink when you turn the light on. Sometimes it will stop but ...
(Posted by Robwelker 10 years ago)
Popular Hunter 21315 Manual Pages
Installation Guide - Page 1
... ANSI/ NFPA 70.
For instructions to install your ceiling fan, go to your fan manual and continue with the joist or support brace.
4-3. CAUTION: All wiring must be in the box align with 2 • Installing the Ceiling Plate.
Outlet Box o e outlet box is suitable, go to your fan manual and begin with national and local electrical codes and ANSI/NFPA 70. o ...
Owner's Manual - Page 1
For Your Records and Warranty Assistance For reference, also attach your receipt or a copy of your receipt to the manual. Model Name
Model No.
Date Purchased
Where Purchased
Type 2 Models
Owner's Guide and Installation Manual
English
Español
Form# 45039-01 20101217 ©2010 Hunter Fan Co.
Owner's Manual - Page 2
... the service panel. • All wiring must be in accordance with wiring, use only the hardware supplied. • To avoid possible electrical shock, before installing your fan. If you cannot lock the circuit breakers in the world.
SAVE THESE INSTRUCTIONS.
• Use only Hunter replacement parts. • To reduce the risk of personal injury, attach the fan directly to the
support...
Owner's Manual - Page 3
...; 12/17/10 • Hunter Fan Company
Wiring
• e electrical cable is directly below a joist or support brace that will hold the outlet box and the full weight of the outlet box are aligned with the rotating fan blades during
normal operation.
• e fan blades are essential for your new Hunter fan. Ceiling Hole
• e outlet...
Owner's Manual - Page 4
... it to allow you to your fan manual and continue with an approved connector, available at least 6" beyond the box.
5-3. If NOT, install a support brace as a tag, to the outlet box with Section 2 • Installing the Ceiling Plate.
Step 4 - Prepare the Wiring
5-1. Attach the fan supply line to the service panel.
5-2. read the fan supply line through the outlet...
Owner's Manual - Page 5
... 3-position mounting system provides you can install your Hunter fan in this manual include instructions for ceilings less than 8 feet, you maximum installation flexibility and ease.
Support Brace
Ceiling Outlet Box
For ceilings higher than 8 feet high
CAUTION: To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to...
Owner's Manual - Page 6
... or damaged, contact your fan to avoid damage to a licensed installer or electrician.
If you need the following : • Locate the ceiling joist or other suitable support in sets, as they were shipped.
6 45039-01 • 12/17/10 • Hunter Fan Company Check for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds...
Owner's Manual - Page 7
... with the pilot holes you
drilled in the wood support structure.
2 • Installing the Ceiling Plate
CAUTION: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off position, securely fasten a prominent warning device, such as a tag, to the service panel.
2-1. For Angled Ceilings: Be sure to the outlet box and associated wall...
Owner's Manual - Page 8
... with the holes in these installation instructions.
3-1. Remove the set screw from the fan and remove the paper caution tag. Hanging the Fan:
Note: To hang the fan, you must tilt the canopy to install the pipe and ball assembly. Unbundle the wires from the adapter.
3-5. Do not discard the tag until your installation is replaced with three low profile...
Owner's Manual - Page 9
... national and local electrical codes. 4-1. Connect the remaining wires as follows: Dual Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black wire (ungrounded) from the fan
• The black/white wire (ungrounded) from the fan to the wire (ungrounded) for the wall switch
Single Switch Wiring: • The black wire (ungrounded) from the ceiling to the green...
Owner's Manual - Page 12
... light fixture, proceed with step 7‑6. Feed the upper plug connector through the center opening of installing the fan with the housing assembly screws.
7-4.
7 • Completing Your Installation With or Without a Bowl Light Fixture
Your Hunter fan comes with this fan model.
7-1.
Tighten all three assembly screws could result in the housing with OR without the included...
Owner's Manual - Page 15
... Button
Step 7-20
15 45039-01 • 12/17/10 • Hunter Fan Company 7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the center of the
light fixture inside the lower switch housing...
Owner's Manual - Page 16
... slightly damp lint free cloth to the light. Restart fan. The pull chain has four settings in warm weather to cool the room with Hunter's Dust
Armor protection, making the blades less likely to the opposite position.
Turn on the fan to attract dust and
dirt. Ceiling fans work best by blowing air downward (counterclockwise blade...
Owner's Manual - Page 17
...5 minutes, then resume power to the wiring the fan section. 3. CFL light bulbs are installed meet the specifications on the light socket. 2. Remove the shipping bumpers. If so, replace all connections according to the fan.
9 • Troubleshooting
Problem: Nothing happens;
Problem: Lights shut off at http://www.hunterfan.com. Hunter Fan Company 7130 Goodlett Farms Parkway #400...
Parts Guide - Page 1
... Terminal, Male Dummy Terminal, Female Cap, Switch Housing Plug Button Balancing Kit
Model #
21315
Asm.
REFER TO THE INSTALLATION MANUAL FOR FULL ASSEMBLY INSTRUCTIONS. THIS PARTS GUIDE IS FOR REFERENCE ONLY. Hardware (Drawn to Scale)
x 1 x 2 x 4 x 2 x 3
x 4 x 1 x 4
Balancing
x 1
Kit
Wire
x 4
Connector
x 11 x 16 x 16 x 3 x 3
Low Profile Washer
3" Wood Screw
Flat Washer 1.5" Wood...
Hunter 21315 Reviews
We have not received any reviews for Hunter yet.