HP Mini 1104 - Maintenance and Service Guide
Page 35
... mats, use alligator clips to a grounded system. The following grounding equipment is recommended to prevent electrostatic damage: ● Antistatic tape ● Antistatic smocks, aprons, and sleeve protectors ● Conductive bins and other assembly or soldering aids ● Nonconductive foam ● Conductive tabletop workstations with ground cords of one megohm resistance ●...
... mats, use alligator clips to a grounded system. The following grounding equipment is recommended to prevent electrostatic damage: ● Antistatic tape ● Antistatic smocks, aprons, and sleeve protectors ● Conductive bins and other assembly or soldering aids ● Nonconductive foam ● Conductive tabletop workstations with ground cords of one megohm resistance ●...
HP Mini 1104 - Maintenance and Service Guide
Page 42
NOTE: If the WLAN antennas are not connected to install the WLAN module. 34 Chapter 4 Removal and replacement procedures Reverse this procedure to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. Remove the WLAN module by pulling the module away from the slot at an angle (3). 5. NOTE: The WLAN module is designed with a notch (4) to prevent incorrect installation into the WLAN module socket.
NOTE: If the WLAN antennas are not connected to install the WLAN module. 34 Chapter 4 Removal and replacement procedures Reverse this procedure to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. Remove the WLAN module by pulling the module away from the slot at an angle (3). 5. NOTE: The WLAN module is designed with a notch (4) to prevent incorrect installation into the WLAN module socket.
HP Mini 1104 - Maintenance and Service Guide
Page 44
NOTE: The WWAN module is designed with a notch (4) to the terminals on the WWAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. NOTE: If the WWAN antennas are not connected to prevent incorrect installation into the WWAN module socket. Reverse this procedure to install the WWAN module. 36 Chapter 4 Removal and replacement procedures Remove the WWAN module by pulling the module away from the slot at an angle (3). 3.
NOTE: The WWAN module is designed with a notch (4) to the terminals on the WWAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. NOTE: If the WWAN antennas are not connected to prevent incorrect installation into the WWAN module socket. Reverse this procedure to install the WWAN module. 36 Chapter 4 Removal and replacement procedures Remove the WWAN module by pulling the module away from the slot at an angle (3). 3.