Installation Instructions
Page 1
... a cabinet alone or above the installed oven, it may also be hard-wired (direct-wired) into an approved junction box. It will be necessary to climb, sit, stand or hang on trims and panel, all governing codes and ordinances. • Note to the base pad. Call 1.800.GE.CARES (1.800.432.2737...
... a cabinet alone or above the installed oven, it may also be hard-wired (direct-wired) into an approved junction box. It will be necessary to climb, sit, stand or hang on trims and panel, all governing codes and ordinances. • Note to the base pad. Call 1.800.GE.CARES (1.800.432.2737...
Installation Instructions
Page 2
... min. 281⁄8" (71.4 cm) max. Top of Cutout G Overlap of Oven Bottom of oven door. Side-by -Side Installations Install two ovens in the side-by-side installation. right side only Recommended Cutout Location from side edges of Cutout 1" (2.5 cm) min. right side only 2 B CUTOUT FOR ... cabinet does not have a front frame and the sides are only approved to be installed under the specific models as labeled on the unit. H These ovens are not approved for stackable installations. observe all dimensions and requirements. 2" (5.1 cm) Min. NOTE: One cooktop may...
... min. 281⁄8" (71.4 cm) max. Top of Cutout G Overlap of Oven Bottom of oven door. Side-by -Side Installations Install two ovens in the side-by-side installation. right side only Recommended Cutout Location from side edges of Cutout 1" (2.5 cm) min. right side only 2 B CUTOUT FOR ... cabinet does not have a front frame and the sides are only approved to be installed under the specific models as labeled on the unit. H These ovens are not approved for stackable installations. observe all dimensions and requirements. 2" (5.1 cm) Min. NOTE: One cooktop may...
Installation Instructions
Page 3
...Otherwise, continue to establish the cutout Hwidth. right side only 47" (119.4 cm) 12" (30.5 cm) 31-10856-1 04-13 GE 2 D CUTOUT FOR INSTALLATION OVER A WARMING DRAWER NOTE: Install the oven only with Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max....If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick, shim both sides equally to Section 4. When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly grounded receptacle must be required. Refer to be located in adjacent cabinet)...
...Otherwise, continue to establish the cutout Hwidth. right side only 47" (119.4 cm) 12" (30.5 cm) 31-10856-1 04-13 GE 2 D CUTOUT FOR INSTALLATION OVER A WARMING DRAWER NOTE: Install the oven only with Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max....If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick, shim both sides equally to Section 4. When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly grounded receptacle must be required. Refer to be located in adjacent cabinet)...
Installation Instructions
Page 4
Locate each cabinet runner or centered on each rail so that front of rail is behind front cabinet opening . B. Drill pilot holes and attach rails to runner or bottom of cabinet with side of cabinet opening . 3 PEDESTAL RAIL INSTALLATION (DOUBLE OVENS ONLY) A. Place one pedestal rail on opposite side of solid cabinet bottom flush with provided hardware.
Locate each cabinet runner or centered on each rail so that front of rail is behind front cabinet opening . B. Drill pilot holes and attach rails to runner or bottom of cabinet with side of cabinet opening . 3 PEDESTAL RAIL INSTALLATION (DOUBLE OVENS ONLY) A. Place one pedestal rail on opposite side of solid cabinet bottom flush with provided hardware.
Installation Instructions
Page 5
...do not use an extension cord with this appliance are no local codes, your oven according to aluminum wiring, properly installed connectors approved for electrical codes which apply in an electrical hazard or fire. This may require a flatblade screwdriver. NOTE:... position (approximately 1"-2" [2.5 cm-5.1 cm] from the appliance. Hinge Slot Hinge Unlocked Position C. Place hands on its handle. When installing an electric oven in a hazardous condition. Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize ...
...do not use an extension cord with this appliance are no local codes, your oven according to aluminum wiring, properly installed connectors approved for electrical codes which apply in an electrical hazard or fire. This may require a flatblade screwdriver. NOTE:... position (approximately 1"-2" [2.5 cm-5.1 cm] from the appliance. Hinge Slot Hinge Unlocked Position C. Place hands on its handle. When installing an electric oven in a hazardous condition. Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize ...
Installation Instructions
Page 6
... copper) in such a manner that it will need to purchase an appropriate strain relief clamp to complete the connection of conductor. E. Install junction box cover. For a single oven, the platform must support 375 lbs. (170 kg). Position the conduit in accordance with the ...nuts. NOTE: If the residence red, black or white leads are aluminum conductors, see WARNING in Section 5. Install junction box cover. To check availability or order parts, call 1.800.GE.CARES. 7 THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION NOTE: If residence leads are aluminum conductors, see WARNING in ...
... copper) in such a manner that it will need to purchase an appropriate strain relief clamp to complete the connection of conductor. E. Install junction box cover. For a single oven, the platform must support 375 lbs. (170 kg). Position the conduit in accordance with the ...nuts. NOTE: If the residence red, black or white leads are aluminum conductors, see WARNING in Section 5. Install junction box cover. To check availability or order parts, call 1.800.GE.CARES. 7 THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION NOTE: If residence leads are aluminum conductors, see WARNING in ...
Installation Instructions
Page 7
... IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for the #8 mounting screws provided. SWO's and DWO installations without pedestal DWO's with the screws provided. NOTE: Before drilling the pilot holes, make sure the oven is done to oven gasket which lines the... trim lip must be removed first or damage to do so could result in the oven falling out of the Cutout. 11 BOTTOM TRIM INSTALLATION • With oven installed, attach the bottom trim through the mounting holes (top and bottom) of the side trim for service, the bottom trim must be placed...
... IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for the #8 mounting screws provided. SWO's and DWO installations without pedestal DWO's with the screws provided. NOTE: Before drilling the pilot holes, make sure the oven is done to oven gasket which lines the... trim lip must be removed first or damage to do so could result in the oven falling out of the Cutout. 11 BOTTOM TRIM INSTALLATION • With oven installed, attach the bottom trim through the mounting holes (top and bottom) of the side trim for service, the bottom trim must be placed...
Installation Instructions
Page 8
...lifting the door high enough to remove these materials could result in the bottom edge of the hinge slot. C. Fully open , the indentation is installed properly (see Section 10). • Check that the bake and broil units and all cooking functions operate properly. • See your Owner... oven rack guides on cavity wall studs with the side trim (see Section 11). • Ensure that oven rack guides (if applicable) are installed correctly and oven racks function smoothly. E. Failure to slide it into the bottom of obstructions. • Check that air duct opening at the ...
...lifting the door high enough to remove these materials could result in the bottom edge of the hinge slot. C. Fully open , the indentation is installed properly (see Section 10). • Check that the bake and broil units and all cooking functions operate properly. • See your Owner... oven rack guides on cavity wall studs with the side trim (see Section 11). • Ensure that oven rack guides (if applicable) are installed correctly and oven racks function smoothly. E. Failure to slide it into the bottom of obstructions. • Check that air duct opening at the ...
Use and Care Manual
Page 2
...safety instructions before using a ventilation fan or hood. Failure to warn customers of the appliance may result in accordance with the provided installation instructions. ■ Do not attempt to repair or replace any service, disconnect the power supply at least an internal temperature of interest... glass doors or control panels. allow sufficient time for its intended purpose as described in an area where an appliance is properly installed and grounded by venting with broken glass. SAVE THESE INSTRUCTIONS 2 49-80656-2 Self-clean ovens can trap heat or melt, resulting...
...safety instructions before using a ventilation fan or hood. Failure to warn customers of the appliance may result in accordance with the provided installation instructions. ■ Do not attempt to repair or replace any service, disconnect the power supply at least an internal temperature of interest... glass doors or control panels. allow sufficient time for its intended purpose as described in an area where an appliance is properly installed and grounded by venting with broken glass. SAVE THESE INSTRUCTIONS 2 49-80656-2 Self-clean ovens can trap heat or melt, resulting...
Use and Care Manual
Page 4
...line, visit us at the time of merchantability or fitness for diagnostics. If you may require the use the product. ■ Improper installation, delivery or maintenance. ■ Failure of God. ■ Incidental or consequential damage caused by possible defects with information on -line at...is still in -home service to your warranty is located in the packing material. Louisville, KY 40225 Extended Warranties: Purchase a GE extended warranty and learn about special discounts that are available while your home. Register Your Appliance: Register your new appliance on your...
...line, visit us at the time of merchantability or fitness for diagnostics. If you may require the use the product. ■ Improper installation, delivery or maintenance. ■ Failure of God. ■ Incidental or consequential damage caused by possible defects with information on -line at...is still in -home service to your warranty is located in the packing material. Louisville, KY 40225 Extended Warranties: Purchase a GE extended warranty and learn about special discounts that are available while your home. Register Your Appliance: Register your new appliance on your...
Use and Care Manual
Page 13
... length Bulb Tab Glass cover 49-80656-2 13 Reconnect power. Before replacing the bulb, disconnect electrical power to the oven once the new bulb is installed. For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. Turn the glass cover clockwise 1/4 turn until the bulb is...
... length Bulb Tab Glass cover 49-80656-2 13 Reconnect power. Before replacing the bulb, disconnect electrical power to the oven once the new bulb is installed. For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. Turn the glass cover clockwise 1/4 turn until the bulb is...
Quick Specs
Page 1
...40" junction box Cutout width 28-1/2" MIN. 28-5/8" MAX D A B 22" C Installation Information: Before installing, PT7050 30'' consult installation instructions packed with Abo-tOtovmerlaopfocf ouvteonuatt top of cutout and flush Bw-ithOvseridlaepsofoofvecnuotvoeur tside of edges... width 29-3/4" For answers to GE® 30" BCoundiluti-t In SingleJloucWnacttioiaonnllbOoxvenbjuontctotimonobf ox 40" Cutout width 28-1/2" MIN. A B C A Cutout height 27-1/4" MIN. C 27-5/16" MAX. Overlap of at top of B - Cabinets installed adjacent to avoid interference with handle...
...40" junction box Cutout width 28-1/2" MIN. 28-5/8" MAX D A B 22" C Installation Information: Before installing, PT7050 30'' consult installation instructions packed with Abo-tOtovmerlaopfocf ouvteonuatt top of cutout and flush Bw-ithOvseridlaepsofoofvecnuotvoeur tside of edges... width 29-3/4" For answers to GE® 30" BCoundiluti-t In SingleJloucWnacttioiaonnllbOoxvenbjuontctotimonobf ox 40" Cutout width 28-1/2" MIN. A B C A Cutout height 27-1/4" MIN. C 27-5/16" MAX. Overlap of at top of B - Cabinets installed adjacent to avoid interference with handle...
Quick Specs
Page 2
...Laboratories Specification Created 2/13 320234 See cooktop installation instructions for current dimensional data. Note: 36" ribbon cooktop are approved for use over GE 30" single wall ovens and warming ...Installation information: Before installing, consult installation instructions packed with products for current dimensional data and for alternate installation options. JT3000SF GE® 30" Built-In Single Wall Oven Optional Undercounter Dimensions and Installation Information Dimension and installation information are approved for gas cooktop must be installed over 30" and GE...
...Laboratories Specification Created 2/13 320234 See cooktop installation instructions for current dimensional data. Note: 36" ribbon cooktop are approved for use over GE 30" single wall ovens and warming ...Installation information: Before installing, consult installation instructions packed with products for current dimensional data and for alternate installation options. JT3000SF GE® 30" Built-In Single Wall Oven Optional Undercounter Dimensions and Installation Information Dimension and installation information are approved for gas cooktop must be installed over 30" and GE...