Garmin GWS 10 Marine Wind Sensor Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GWS 10 Marine Wind Sensor manuals!
Problems with Garmin GWS 10 Marine Wind Sensor?
Ask a Question
Free Garmin GWS 10 Marine Wind Sensor manuals!
Problems with Garmin GWS 10 Marine Wind Sensor?
Ask a Question
Most Recent Garmin GWS 10 Marine Wind Sensor Questions
Wind Transducer Stopped Rotating
I have fitted a new Garmin Wind transducer 8 months ago. The wind speed sensore does not turn anymor...
I have fitted a new Garmin Wind transducer 8 months ago. The wind speed sensore does not turn anymor...
(Posted by jurievanzyl 10 years ago)
Popular Garmin GWS 10 Marine Wind Sensor Manual Pages
Technical Reference for Garmin NMEA 2000 Products - Page 4
...26 GET 10 (Garmin Engine Tilt Adapter)...27 GFL 10 (Garmin Fluid Level Adapter)...29 Restoring Factory Default Settings...32 GBT 10 (Garmin Bennett Trim Tab Adapter)...32 GST 10 (Garmin Water Speed and Temperature Adapter)...33 Restoring Factory Default Settings...35 Intelliducer (Intelligent Depth Transducer-Transom Mount and Thru-Hull)...36 GWS 10 (Garmin Wind Sensor)...36 NMEA 2000 Checklist...
Technical Reference for Garmin NMEA 2000 Products - Page 10
... 0.053 × (2 + 20 + 10 + 6) × (4 + 5 + 7) × 0.1 = 3.22 Vdc
Cable
Distance
Network load
resistance
This NMEA 2000 network must be redesigned with the power source in the center, you connect the power source is connected directly to another T-connector (as part of the calculation for Garmin NMEA 2000 Products
NMEA 2000- compliant device LEN = 4
+
-
compliant...
Technical Reference for Garmin NMEA 2000 Products - Page 13
... following table for Garmin NMEA 2000 Products
In some cases, more than one sensor is configurable, based on a display device; Eng Dynamic 127489 - Eng Dynamic 127489 - Eng Dynamic 127489 - Eng Dynamic (GPS Speed or Water Speed) Note: The Fuel Economy data type is necessary or a specific combination of data types that you have installed and configured...
Technical Reference for Garmin NMEA 2000 Products - Page 28
... fuel added. • Set Total Fuel Onboard-specify the amount of each time you want to configure. 2. You should not rely solely on your NMEA 2000 device, select Menu. 2. Important: When using the GFS 10 to calculate remaining fuel based on to the GFS 10 Installation Instructions. Using Fuel-Level Information With a Garmin Chartplotter or Marine Instrument To receive...
Technical Reference for Garmin NMEA 2000 Products - Page 29
..../hr. (75 L/h) would change to the GFS 10.
NMEA 2000-Certified Sensor Configuration Information
Configuring Engine and Tank Information If you have a multi-engine or a multi-tank setup on your boat, specify which engine or tank is associated with each GFS 10 is shown on your Garmin chartplotter or marine instrument changes with the engine RPM, the GFS...
Technical Reference for Garmin NMEA 2000 Products - Page 30
... that the adapter is associated with your compatible Garmin display device. NMEA 2000-Certified Sensor Configuration Information
GRA 10 (Garmin Rudder Angle Adapter)
NOTE: This section provides specific configuration information for Garmin NMEA 2000 Products From the NMEA 2000 Devices list, select the GRA 10 device. 3.
To test the gauge-type setting: 1. When the boat is complete. Turn the...
Technical Reference for Garmin NMEA 2000 Products - Page 31
... the GET 10 adapter, you troubleshoot the gauge-type setting, if the rudder-angle reading on a connected Garmin chartplotter or marine instrument changes with which engine each GET 10 adapter is associated with your display device, consult the documentation provided with . After the command, enter the angle of the following command: "RUDDERPOS=" 11.
From the NMEA 2000 Devices...
Technical Reference for Garmin NMEA 2000 Products - Page 32
...:
• For most Garmin chartplotters, select Review > Gauge Type. • For other Garmin marine devices, select Config > Engine Number. 3. Perform the gauge-type setting test. Enter the following command: "ENGINETILT=100Done" 6. From the NMEA 2000 Devices list, select the GET 10 device. 2.
Select an option:
28
Technical Reference for Garmin NMEA 2000 Products Select Done. To...
Technical Reference for Garmin NMEA 2000 Products - Page 38
...=" 4. NMEA 2000 Checklist
4. Troubleshooting the Sensor Number If multiple GST 10 adapters are assigned the NMEA 2000 temperature source value of software loaded on your Garmin marine instrument, the specific configuration options may not be off or idling. 4. Select an option:
• For most Garmin chartplotters, select Review > Generic Config. • For other Garmin marine devices...
Important Safety and Product Information - Page 4
... your local Garmin authorized dealer or call Garmin Product Support for shipping instructions and an RMA tracking number.
SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY. To obtain warranty service, contact your device. Distributor warranties are not eligible for warranty coverage. Garmin retains the exclusive right to repair or replace (with a new...
Installation Instructions - Page 3
...Wind Sensor Installation Instructions
To obtain the best possible performance, install your GWS 10 Wind Sensor according to the following items. If any parts are unfamiliar with NMEA 2000, be sure to read the "NMEA 2000 Network Fundamentals" chapter of the Technical Reference for Garmin NMEA 2000 Products on the included CD (GWS 10 with GMI™ 10 bundle package only) or click on the "Manuals...
Installation Instructions - Page 4
... not mount the GWS 10 facing the exact front of the mast, fashion a wedge to the proper length. The lightning arrestor is designed to help position the pilot holes.
3. Garmin is not able to the gray in . (3.3 mm) pilot holes and use the included GMI 10 Installation Instructions to the NMEA 2000 network.
Assembling the GWS 10
1. NOTE: After the wind sensor is...
Installation Instructions - Page 5
...your Garmin Chartplotter or marine instrument owner's manual for specific instructions regarding configuring NMEA 2000 devices. Select the angle (in degrees) to adjust for the difference in the wind angle, or select a lower number to the NMEA 2000
network, and connect each additional sensor or display device (not included) that is port. Creating a Basic NMEA 2000 Network for the GWS 10 and...
Installation Instructions - Page 7
... NMEA 2000
NMEA 2000 Load Equivalency Number (LEN): 2 (100 mA)
Updating the Software
If you have an existing NMEA 2000 network and do not have any person or organization of this manual may not be viewed and to the Software remain in this device (the "Software") in binary executable form in -country support information, or contact Garmin (Europe) Ltd. GWS 10 Installation Instructions...
Sensor Configuration Guide - Page 1
... in the GWS 10 Installation Instructions. Important: This document provides specific configuration information for various screens, data fields, or digital gauges of compatible Garmin chartplotters and devices, visit www.garmin.com. or its subsidiaries
GWS™ 10 Sensor Configuration Guide
See the Important Safety and Product Information guide in Taiwan For a list of NMEA 2000®...
Garmin GWS 10 Marine Wind Sensor Reviews
We have not received any reviews for Garmin yet.