Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack manuals!
Problems with Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack?
Ask a Question
Free Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack manuals!
Problems with Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack?
Ask a Question
Popular Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack Manual Pages
Installation Instructions - Page 1
...; Compact Reactor™ Hydraulic
Installation Instructions
Important Safety Information
WARNING See the Important Safety and Product Information guide in the product box for product warnings and other boats. It does not relieve you of the responsibility of the components on the device. • The mounting surface must be connected to configure and control the autopilot system...
Installation Instructions - Page 2
... these instructions to help determine the pump-installation location (Hydraulic Layouts, page 4). • The pump must be mounted vertically, with the hydraulic
connections facing...Reactor
Hydraulic autopilot system. If you should install a manual Single Pole Single Throw (SPST) switch (not included) to a compass than the helm, but you manually take control of the helm and suspends autopilot...
Installation Instructions - Page 3
... connecting the pump to the pump cannot be located within 0.5 m (19 in the detailed installation instructions for planning purposes only.
If your autopilot package does not include a Shadow Drive valve, you are included in .) of magnetic interference. If needed, specific connection diagrams are building a NMEA 2000 network. Item Description Helm control
À
(or compatible...
Installation Instructions - Page 4
... 2000 network on your boat. If needed, specific connection diagrams are not shown in this manual and you can be connected to a NMEA 2000 network using the included Tconnectors (NMEA 2000 Connection Considerations, page 2). Hydraulic connections are included in any of the boat, in the detailed installation instructions for each component.
Item Description NMEA 2000...
Installation Instructions - Page 7
...install all hose connections are complete and fully tightened. 1 Select an option:
• If the helm reservoir contains insufficient fluid, fill it can be extended using the appropriate wire gauge for more-specific information about bleeding the system. Refer to the instructions... of the other autopilot components, connect the power cable to the ECU. Bleeding the Hydraulics
NOTICE This is ...
Installation Instructions - Page 8
... Shadow Drive to the hydraulic steering of all parts, apply corrosion blocker to install the Shadow Drive in all hydraulic and electrical connections are closed.
If you must be connected to the NMEA 2000 network. A marine-rated corrosion blocker should install a manual Single Pole Single Throw (SPST) switch (not included) to disable the autopilot if necessary.
8
1 Route...
Installation Instructions - Page 9
... to the NMEA 2000 network. See the included configuration guide for more information on the helm control or a compatible Garmin chartplotter to configure the autopilot. See the installation instructions provided with the autopilot system must be installed in all connections and seal them with heat-shrink tubing. • See Specifications, page 11 for extended runs of wire. Solder...
Installation Instructions - Page 10
... with only one receiving wire (Rx), it must be connected to any of your Garmin device.
• The internal NMEA 0183 ports and communication protocols are not linked. Only...the NMEA 0183 device must remain unconnected. For example, if the input of the chartplotter owner's manual for the NMEA 2000 bus and the NMEA 0183 device to connect to NMEA 0183 ground. Function...
Installation Instructions - Page 11
...176; to 30 min. For more information, go to www.garmin.com/waterrating.
Helm Control
Specification
Measurement
Dimensions without sun cover (H 110 x 115 x 30 ...optional NMEA 0183-compatible devices, the autopilot uses the following NMEA 0183 sentences.
Alarm
Specification Dimensions (L×diameter) Weight Temperature ...update 129026 COG & SOG: Rapid update 129283 Cross track error ...
Installation Instructions - Page 12
....
GHP™, GHC™, Reactor™, and Shadow Drive™ are trademarks of Garmin Ltd. Uflex® and MasterDrive™ are trademarks of the UltraFlex Group. Teflon® is a trademark of Garmin. Type
Sentence grme gsa gsv rmc bod bwc dtm gll rmb vhw mwv xte
Error and Warning Messages
Error Message
Cause
Autopilot Action
ECU Voltage...
Configuration Guide - Page 1
... the dashboard of calm water. 2 Select an option:
• On a helm control, select Menu > Setup > Dealer Autopilot Setup > Wizards > Sea Trial Wizard.
Performing the Sea Trial Wizard 1 Drive your boat to your boat.
GHP™ Compact Reactor™ Hydraulic Configuration Guide
The autopilot system must be stationary while you complete the wizard. The Dockside Wizard and the...
Configuration Guide - Page 2
... Fine Heading Adjustment This procedure appears only if you do not have a large stretch of the Sea Trial Wizard on a chartplotter, select Settings > My Vessel > Autopilot Installation Setup > Compass Setup > Set North > Begin.
3 Continue to drive the boat at cruising speed in a perfect magnetic environment and calibrated correctly. The boat should not list during calibration.
3 Select...
Configuration Guide - Page 3
... on the Helm Control, page 3). 2 Select an option:
• On a helm control, from the heading screen, select Menu > Setup > Dealer Autopilot Setup > Autopilot Tuning > Rudder Gains.
• On a chartplotter, select Settings > My Vessel > Autopilot Installation Setup > Autopilot Tuning > Rudder Gains.
3 Select an option based on the type of boat: • If you have a planing-hull powerboat...
Configuration Guide - Page 4
... On a chartplotter, select Settings > My Vessel > Autopilot Installation Setup > Rudder Gains. NOTE: These settings apply only to displacement-hull powerboats and powerboats with the speed source set to Tach. - NOTE: These settings apply only to planing-hull powerboats with the tachometers on the dashboard of the configuration is available on -screen instructions. Low Speed Counter: Allows...
Configuration Guide - Page 5
Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries. Configuring the Autopilot
5 GHP™, GHC™, Reactor™, and Shadow Drive™ are trademarks of Garmin Ltd. You can test and reverse the steering direction if necessary.
These trademarks may not be used without the express permission of Garmin.
Allows you to set the direction...
Garmin GHP Compact Reactor Hydraulic Autopilot with GHC 20 Pack Reviews
We have not received any reviews for Garmin yet.