Frigidaire FMV157GS - Microwave Support and Manuals
Get Help and Manuals for this Frigidaire item
View All Support Options Below
Free Frigidaire FMV157GS manuals!
Problems with Frigidaire FMV157GS?
Ask a Question
Free Frigidaire FMV157GS manuals!
Problems with Frigidaire FMV157GS?
Ask a Question
Most Recent Frigidaire FMV157GS Questions
Where Can I Find The Door Lock Assembly On My Frigidaire Microwave Fmv157gs
(Posted by careycloud9 3 years ago)
Fan Automatically Comes On
when cooking & using oven at same time fan comes on. Cant shut it off.
when cooking & using oven at same time fan comes on. Cant shut it off.
(Posted by Anonymous-156262 8 years ago)
Unit Runs And Heats When The Door Is Closed.
No response from buttons to cancel or change settings. Light and turntable operate only if I push up...
No response from buttons to cancel or change settings. Light and turntable operate only if I push up...
(Posted by davelendon 9 years ago)
How Do I Get The Door Off To Replace It?
The handle broke and I had to order a new door. Now I need to take the old one off anf replace it. S...
The handle broke and I had to order a new door. Now I need to take the old one off anf replace it. S...
(Posted by tasc41 9 years ago)
Turntable Does Not Turn
Fridgidaire Model # FMV157GS mnfg 2007: The microwave heats but the turn table does not turn.
Fridgidaire Model # FMV157GS mnfg 2007: The microwave heats but the turn table does not turn.
(Posted by edwhit41 9 years ago)
Popular Frigidaire FMV157GS Manual Pages
Installation Instructions - Page 1
...Over the Range Microwave Oven
Questions? Keep these
instructions with the Consumer.
• Note to improper installation is the responsibility of the installer.
• Product failure due to Consumer -
Save these instructions completely and carefully.
• IMPORTANT -
Call
1-800-944-9044(US) 1-800-668-4606(Canada)
or Visit our Website at: http://www.frigidaire.com
BEFORE...
Installation Instructions - Page 2
... information
Important Safety Instructions 3 Electrical Requirements 3 Hood Exhaust 4, 5 Damage - Shipment/Installation 6 Parts Included 6 Tools You Will Need 7 Mounting Space 7
Step-by-step installation guide
Placement of Mounting Plate 8-10 Removing the Mounting Plate 8 Finding the Wall Studs 8 Determining Wall Plate Location 9 Aligning the Wall Plate 10
Installation Types 11-22...
Installation Instructions - Page 3
.... You should have it replaced with a standard three-prong (grounding) wall receptacle to 50 pounds (22.7 kg) or a total weight of supporting the cabinet load, in addition to the National Electrical Code or the prevailing local code.
3
The outlet box and supply circuit should be employed to 20- Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three...
Installation Instructions - Page 10
...
CAUTION: Wear gloves to support the weight of the 30″ (... illustration above/actual plate marked with the stud.
Line up with arrows). Set the mounting plate aside.
4 Drill holes on sharp edges. Hole C
Area...microwave. NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
10 NOTE: If neither C nor D is a stud, drill a 3⁄16″ hole for mounting.
Installation Instructions
D.
Installation Instructions - Page 11
... Outside Back Exhaust
See page 12
See page 15
C RECIRCULATING (NON-VENTED DUCTLESS)
See page 19
On models shipped for recirculating exhaust, a disposable charcoal filter is required for the recirculating exhaust. (See your installation and proceed to the following three types of ventilation required for your Owner's Manual for kit number.)
11
A OUTSIDE TOP EXHAUST...
Installation Instructions - Page 13
... at least two full turns after the microwave is metal, use handle during installation.
Be careful not to pinch the cord, especially when mounting flush to assure proper
alignment with the
top of the unit facing up against cabinet bottom.
3 Insert a self-aligning screw through hole in the cabinet bottom. Installation Instructions
A2. USE TOP CABINET...
Installation Instructions - Page 14
Installation Instructions
A4. MOUNT THE MICROWAVE OVEN (cont.)
Cabinet Front Cabinet Bottom Shelf Filler Block
Equivalent to Depth of Microwave
For Front-to-Back or Side-to the top cabinet.
5 Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. Blower Plate
Damper
Back of Cabinet Recess
Self-Aligning Screw
Microwave Oven...
Installation Instructions - Page 15
...; Make sure the motor wiring has
been properly routed and secured, and that holds the blower plate to the microwave.
You will help to cut an opening in the rear wall for holes A and B in the rear wall opening , following the instructions of the
REAR WALL TEMPLATE.
15
Back of Microwave Lift off the blower...
Installation Instructions - Page 16
... into the mounting plate through . Installation Instructions
B3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and a hole large enough ...adjust the blower unit.
ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST
1 Remove and save screw that the plate is properly centered under the cabinet. The wires will extend far enough to ...
Installation Instructions - Page 18
... microwave oven in place against the wall and the top cabinet.)
2 Rotate front of oven up against cabinet bottom.
3 Insert a self-aligning screw through hole in bottom of the cord. Do not pinch cord or lift oven by turning the screw at back bottom edge onto four lower tabs of cabinet.
8 Install grease filters.
Installation Instructions...
Installation Instructions - Page 19
...Install Charcoal Filter...(19 mm) onto each bolt. Check Microwave Assembly C4.
To use toggle bolts:... drill holes for the top support screws and a hole large ...wiring has been properly routed
and secured, and that the plate is properly centered under the cabinet. Attach Mounting Plate to the wall using toggle bolts. Installation Instructions C RECIRCULATING (Non-Vented Ductless)
INSTALLATION...
Installation Instructions - Page 20
....
Save any unused parts for recirculating models. BEFORE: Fan Blade Openings Facing Up
Roll
AFTER: Fan Blade Openings Facing Forward
Blower Plate
Back of Microwave
Blower Motor Screw
NOTE: The blower plate will extend far enough to allow you to C5.
The wires will be shipped assembled for
top exhaust (adaptor installed) or for recirculation...
Installation Instructions - Page 21
...turns after the threads have engaged. (It will be completely tightened later.) Be sure to the top cabinet.
21 Make sure the screw is metal, use handle during installation. MOUNT THE MICROWAVE...Microwave
C5.
Installation Instructions
C4. CAUTION: Do not pull or stretch the blower unit wiring.
IMPORTANT: Do not grip or use the nylon grommet around the power cord hole to microwave...
Installation Instructions - Page 22
... the front.
5 Replace the grille and the screws.
6 Close the door.
When properly installed, the wire mesh of the microwave oven. (While tightening screws, hold the microwave oven in recirculating models. C6. INSTALLING THE CHARCOAL FILTER
NOTE: The charcoal filter is factory installed in place against the wall and the top cabinet.)
8 Install grease filters. Installation Instructions
C5.
Installation Instructions - Page 23
... and ring in cavity. 4. ININSSTTARLULCATTIIOONNS
5. Ensure proper ground exists before use
23 Read the Owner's Manual.
Plug power cord into a dedicated 15- to instructions. Make sure the microwave oven has been installed according to 20-amp
electrical outlet. ININSSTTARLULCATTIIOONNS
6.
Replace house fuse or turn breaker back on.
7. Installation Instructions BEFORE YOU USE YOUR...
Frigidaire FMV157GS Reviews
We have not received any reviews for Frigidaire yet.