Dewalt DC628K Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt DC628K manuals!
Problems with Dewalt DC628K?
Ask a Question
Free Dewalt DC628K manuals!
Problems with Dewalt DC628K?
Ask a Question
Most Recent Dewalt DC628K Questions
Dealt Dc628 Finish Nailer Wount Fire
IT turns on and sounds like it's going to work then go and pull trigger and nothing happens
IT turns on and sounds like it's going to work then go and pull trigger and nothing happens
(Posted by Mcneelykenneth2 3 years ago)
Dewalt Dc628 Cordless Nail Gun Won't Cite More Than One Nail
hello, I recently acquired a like new nail gun as mentioned In title. The person I got it from said ...
hello, I recently acquired a like new nail gun as mentioned In title. The person I got it from said ...
(Posted by sethmccullough 6 years ago)
Dewalt DC628K Videos
DEWALT DC628K XRP 1-1/4-Inch to 2-1/2-Inch 15-Gauge 34 Degree Angled Finish Nailer
Duration: :48
Total Views: 90
Duration: :48
Total Views: 90
DEWALT DC628K XRP 1 1 4 Inch to 2 1
Duration: :48
Total Views: 0
Duration: :48
Total Views: 0
DEWALT DC628K XRP 1 1 4 Inch to 2 1
Duration: :48
Total Views: 1
Duration: :48
Total Views: 1
Popular Dewalt DC628K Manual Pages
Instruction Manual - Page 1
... MANUAL DE INSTRUCCIONES
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE GARANTÍA.
632246-00,01,DC628 8/29/06 6:26 PM Page 1
Before returning this product call
1-800-4-DEWALT
IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR DEWALT PURCHASE,
CALL 1-800-4 DEWALT
IN MOST CASES, A DEWALT REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. DC628 15 Gauge Cordless Nailer...
Instruction Manual - Page 2
... manual and pay attention to 110 nails
NAIL SPECIFICATIONS
Nail Lengths
Shank Diameters
Nail Stick Angles
Angled 1-1/4'', 1-1/2", 2", 2-1/2" (32 mm, 38 mm, 44 mm, 51 mm, 65 mm)
15... result in death or serious injury. Trigger B. No-mar pad L. TOOL SPECIFICATIONS
Firing Mode Voltage Height Width Length Weight Magazine Angle Loading Capacity
Selective 18
12" (305 mm) 5" (127 mm) 14" (356 mm)...
Instruction Manual - Page 3
... discharge.
• Remove adjusting keys or wrenches before making any nailer, all instructions before leaving the area or passing the tool to follow Maintenance Instructions may result in use . Refer to lose control. English Distractions can be repaired.
• Disconnect battery pack from this manual.
ELECTRICAL SAFETY
• Do not abuse the cord. PERSONAL SAFETY...
Instruction Manual - Page 4
... use common sense when operating a power tool. L
• Keep hands and body parts clear of this product will stand upright on the battery pack but may cause serious and permanent respiratory or other fasteners. The
symbols and their definitions are as a working in control. 632246-00,01,DC628 8/29/06 6:26 PM Page 2
English...
Instruction Manual - Page 5
... attempt to an authorized service center when service or repair is out of injury, charge only DEWALT nickel cadmium rechargeable batteries. DANGER: Electrocution hazard. 120 volts are not on where to damage or stress.
• Do not use an extension cord unless it to open
the battery pack for use the tool and battery pack in locations where the...
Instruction Manual - Page 6
... surrounding air temperature is between 65°F and 75°F (18°- 24°C). The charger will keep the battery pack fresh and fully charged. SAVE THESE INSTRUCTIONS FOR FUTURE USE
Chargers
Your tool uses a DEWALT Charger. WEAK BATTERY PACKS: Chargers can be obtained if the battery pack is charged when the air temperature is approximately 65...
Instruction Manual - Page 7
... protection. 2.
The DEWALT cordless nailers are assembled in accordance with selective
B
actuation, when in bump fire mode will
allow the motor to start ).
3.
SEQUENTIAL ACTION Use sequential action for intermittent nailing where very careful and accurate placement is fully charged. Release trigger. 5. Lift nosepiece off trigger, disconnect battery pack from tool and remove...
Instruction Manual - Page 8
... push driver blade back in nosepiece,
have tool serviced by an authorized DEWALT service center. Cold Weather Operation
When operating tools at all screws, nuts and fasteners are no nails remaining. Remove battery pack from the tool. Insert fasteners into the rear of pusher to open front door (O).
4. To sink a nail deeper, rotate the depth adjustment wheel (C) clockwise. LOW BATTERY...
Instruction Manual - Page 9
... by calling
1-800-4-DEWALT
TO REPLACE RETURN CORD ASSEMBLY
NOTE: For correct cord position during assembly, refer to the solenoid; Three Year Limited Warranty
DEWALT will repair, without charge, any other than those offered by calling
1-800-4-DEWALT
5. CHARGER CLEANING INSTRUCTIONS
WARNING: Disconnect the charger from the date of the tool. Slide the driver/return assembly (R) toward...
Instruction Manual - Page 10
.... 24
DC628 18 V DC 15 GA. LA HERRAMIENTA SE DEBERÁ UTILIZAR SOLAMENTE CON LAS BATERÍAS Y CON LOS CARGADORES DEWALT. EMPLOYEZ SEULEMENT AVEC LES BATTERIES ET LE CHARGEUR DE DEWALT.
8
UTILISER LE DISPOSITIF DE VERROUILLAGE EN MODE HORS TENSION LORSQUE L'OUTIL NE SERT PAS. FREE WARNING LABEL REPLACEMENT: If your DEWALT Power Tool, Laser, or Nailer for any...
Instruction Manual - Page 11
... setting
Tool not firmly applied to workpiece
See instruction manual
Material and fastener length too rigorous an application
Choose appropriate material or fastener length
Damaged or worn driver blade tip
Replace driver/return assembly; see authorized service center
Damaged or worn driver blade
Replace driver/return assembly; FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A DEWALT...
Instruction Manual - Page 36
... instruction manual for one or more specific information.
and the array of lozenge-shaped humps on the surface of pyramids on the handgrip; 632246-00,01,DC628 8/29/06 6:26 PM Page 34
DEWALT Battery and Charger Systems
Systèmes de batterie et de chargeur de DEWALT • Sistemas de la batería y del cargador de DEWALT
Battery
Output
Batterie...
Instruction Manual
- Lid Card - Page 1
... tool instruction manual before making any adjustments, changing accessories, servicing, or moving the tool.
The lower contact trip will accept all brands of 15 gauge "DA" type angled finish nails.
LOCKED
GETTING STARTED
1. Select and insert nails
(refer to the instruction manual for additional symptoms.
HOW DO I SERVICE MY DEWALT CORDLESS NAILER?
TROUBLESHOOTING
Symptom...
Dewalt DC628K Reviews
We have not received any reviews for Dewalt yet.