Cisco AIR-LAP1131AG-E-K9 Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco AIR-LAP1131AG-E-K9 manuals!
Problems with Cisco AIR-LAP1131AG-E-K9?
Ask a Question
Free Cisco AIR-LAP1131AG-E-K9 manuals!
Problems with Cisco AIR-LAP1131AG-E-K9?
Ask a Question
Most Recent Cisco AIR-LAP1131AG-E-K9 Questions
Yellow Light
have an air lap off line, the ring light is yellow, what does this indicate
have an air lap off line, the ring light is yellow, what does this indicate
(Posted by keaheysm 11 years ago)
Popular Cisco AIR-LAP1131AG-E-K9 Manual Pages
Hardware Installation Guide - Page 4
...IP Address Behavior 3-4 Default SSID and Radio Behavior 3-4 Enable Radio Interfaces 3-5 SSID 3-5 WEP Keys 3-5 Security Settings 3-5
Low Power Condition for Autonomous Access Points 3-6 Intelligent Power Management 3-6 Inline Power Status Messages 3-7 Configuring Power Using the CLI 3-10 Issuing the Cisco IOS Command Using the CLI 3-11
Cisco Aironet 1130AG Series Access Point Hardware Installation...
Hardware Installation Guide - Page 10
... elements. • Braces and vertical bars within square brackets ([{ | }]) mean a required choice within an optional
element. Note Means reader take note. Conventions
Preface
Chapter 3, "Troubleshooting Autonomous Access Points," provides troubleshooting procedures for lightweight access points. Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
x
OL-8369-05
Hardware Installation Guide - Page 13
... Serial Number Label
SN: AAANNNNXXXX
SN: AAANNNNXXXX
121967 781-00295-01 A0
The access point serial number label contains the following information: • Model number, such as AIR-AP1131AG-A-k9 or AIR-LAP1131AG-A-k9 • Serial number, such as VDF0636XXXX (11 alphanumeric digits) • MAC address, such as 00abc65094f3 (12 hexadecimal digits) • Location of the housing (refer to...
Hardware Installation Guide - Page 19
...Low Power Condition for operation in accordance with Section 300-22(c) of the Canadian Electrical Code, Part 1, C22.1.
the bottom plate might not provide enough power to a Power over the Ethernet cable. the AIR-PWRINJ3 power injector and the power module are not tested to UL 2043 and should not be hot. OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide...
Hardware Installation Guide - Page 47
... with 802.3AF PoE module - OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-21 Statement 353
The access point supports the following power sources: • Power module • Inline power:
-
Cisco Aironet Power Injector (AIR-PWRINJ3 or AIR-PWRINJ-FIB) - The access point also activates a Status LED low power error indication and creates an error log entry...
Hardware Installation Guide - Page 54
... indefinitely. Blinking red Flash file system failure. and off
Blinking red Boot environment error. If the access point does not communicate with a default configuration to your DHCP server, and if it does not receive an IP address, it continues to the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points for instructions on configuring the SSID and the "Enable Radio...
Hardware Installation Guide - Page 56
... for in the client adapter and for Autonomous Access Points
Chapter 3 Troubleshooting Autonomous Access Points
Security Settings
Wireless clients attempting to authenticate with the radios disabled to which the access point is printed on the label on the back of supplying 12.95 W. The power module and Cisco Aironet power injectors are compatible with the access point settings. Using two...
Hardware Installation Guide - Page 61
... Cisco IOS command and the corresponding Cisco switch power command.
OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-11 Support for Intelligent Power Management might not be AIR-PWRINJ3 or AIR-PWRINJ-FIB. 3. Cisco switches that support Intelligent Power Management always configure the use of the power injector being used with the access point...
Hardware Installation Guide - Page 63
... or AIR-PWRINJ-FIB. 3. The default username is Cisco and the default password is Cisco.
Choose one of these Power Settings options (see Figure 3-2):
a.
Cisco switches that support Intelligent Power Management always configure the use of these operations:
a. Choose one of a power injector at the switch.
OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide...
Hardware Installation Guide - Page 67
...Reset to c1130-k9w7-tar.default. Reloading the Access Point Image
If your access point has a firmware failure, you must be configured with a static IP address, the IP address does not change.
Place a copy of the access point image file (such as the access point. OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-17 Chapter 3 Troubleshooting Autonomous Access...
Hardware Installation Guide - Page 80
...ap power injector enable
power inline auto power inline never3 power inline never
Power injector used with the CLI commands are not changed. Power injector must be used by the access point to determine which Cisco IOS release supports Intelligent Power Management.
Manually Configuring Controller Information Using the Access Point CLI
Chapter 4 Troubleshooting Lightweight Access...
Hardware Installation Guide - Page 92
... the requirements of Industry Canada. European Community, Switzerland, Norway, Iceland, and Liechtenstein
Autonomous Access Point Models: AIR-AP1131AG-E-K9 AIR-AP1131G-E-K9
Lightweight Access Point Models: AIR-LAP1131AG-E-K9 AIR-LAP1131G-E-K9
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
B-4
OL-8369-05 For further information, contact your local Industry Canada office...
Hardware Installation Guide - Page 96
Autonomous Access Point Models:
AIR-AP1131AG-J-K9 / AIR-AP1131G-P-K9 Lightweight Access Point Models:
AIR-LAP1131AG-J-K9 / AIR-LAP1131G-P-K9
Japanese Translation
43768
03-6434-6500
English Translation
This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as setting partitions. 3. These guidelines are used in Japan. If this equipment...
Hardware Installation Guide - Page 99
...of Cisco Aironet access points in the previous section.
Appendix B Declarations of Conformity and Regulatory Information
Operation of Cisco Aironet Access Points in Brazil
Operation of Cisco Aironet Access Points in Brazil
This section contains special information for the access point models identified in Brazil. Access Point Models
AIR-AP1131AG-T-K9 AIR-AP1131G-E-K9 AIR-LAP1131AG-T-K9 AIR...
Hardware Installation Guide - Page 101
...Jose, CA 95134 USA
Declare under our sole responsibility that the product,
Product: AIR-AP1131AG-E-K9 Variant: AIR-LAP1131AG-E-K9
Cisco Aironet 1130AG Series IEEE802.11 a/b/g Access Point
Fulfils the essential requirements of the Directive 1999/5/EC The following standards were applied.... USA
DofC 441919rev1
OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
B-13
Cisco AIR-LAP1131AG-E-K9 Reviews
We have not received any reviews for Cisco yet.