Yamaha 03D Support Question
Yamaha 03D Support Question
Find answers below for this question about Yamaha 03D.Need a Yamaha 03D manual? We have 1 online manual for this item!
Question posted by njm06 on October 11th, 2015
How Do I Connect The 03d With My Computer
connect with my computer
Current Answers
Answer #1: Posted by TommyKervz on October 12th, 2015 12:23 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,823
Member since:
January 10th, 2013 Points: 17,776,823
Please refer on the video below' for instructions.
Related Yamaha 03D Manual Pages
Owner's Manual - Page 2
...12. Table of Contents
Introduction 1 Equipment in this Guide 1
Part 1: 02R Applications 5
System Operating Notes 5 02R Optional Interface Cards 7 Wordclock Connection and Termination 8 Wordclocks 9 Setting the 02R's Wordclock 9 1. 02R with One ADAT (Timecode on Tape Track 24 8. 02R with ADAT &...Recording 50 21. 02R with Pro Tools for Video Post 52
Yamaha 02R & 03D Applications Guide
Owner's Manual - Page 3
... 57
System Operating Notes 57 03D Optional Interface Cards 58 Wordclock Connections & Termination 59 Wordclocks 60 Setting the 03D's Wordclock 60 22. 03D with ADAT & JL Cooper Datasync-2 62 23. 03D with DA-38 (Timecode on Tape Track 64 24. 03D with Akai DR8 66 25. 03D with Akai DR16 68 26. 03D with Fostex D-90 70 27...
Owner's Manual - Page 6
...sample accurate 128 track recording system. Up to 16 ADATs can be connected to the 02R or 03D digital mixers, which both support a maximum wordlength of 24 bits, using existing... provides multiple locate points per song.
Alesis AI-2 Multipurpose Audio/Video Synchronization Interface The Alesis AI-2 Multipurpose Audio/Video Synchronization Interface supports SMPTE timecode, Sony 9-pin protocol,...
Owner's Manual - Page 7
... Master DA-88 needs to an 02R or 03D with tapes recorded on -board SMPTE and MIDI timecode generators, an RS422 video editor connection, and video sync inputs. It features on ...-board synchronizer for synchronization with those of the BRC Master Remote Control and AI-2 Multipurpose Audio/Video Synchronization Interface on...
Owner's Manual - Page 11
...tapes can be set to use with Tascam High-Bit recording applications.
• The Tascam 25-pin digital audio cables PW-88DL (5 m) and PW-88D (1 m) are available from Tascam. To initialize, hold down ...the PW-88S sync cable should be connected to 16-bit. Control Slaves do so may need SY-88 Sync Boards. Also, only the tape used . Yamaha 02R & 03D Applications Guide In a multiple DA-...
Owner's Manual - Page 33
... timecode or MTC. Yamaha 02R & 03D Applications Guide DA-88 Wordclock Setup
The DA-88 works as the... with Tascam High-Bit recording applications.
• Tascam 25-pin digital audio cables PW-88DL (5 m) and PW-88D (1 m) are available from... systems provide both dynamic and static mix automation referenced to ON (O). Connections
• The Tascam (CD8-TD) card must be version 3.08...
Owner's Manual - Page 35
...cable.
• The terminator bundled with Tascam High-Bit recording applications.
• Tascam 25-pin digital audio cables PW-88DL (5 m) and PW-88D (1 m), and the 15-pin PW-88S sync cable are...• DA-88-A is available from Tascam. Yamaha 02R & 03D Applications Guide This is set when the DA-88 tapes are not being used. Connections
• The Tascam (CD8-TD) cards must be powered up...
Owner's Manual - Page 37
...the cards will not be grounded correctly.
• DA-88-A is connected to Slot [1] of the 02R and the tape inputs correspond to create...3. Set DIP switches 2 and 5 to W.CLK. Yamaha 02R & 03D Applications Guide
The other DA-88s using a BNC to BNC cable, ...used with Tascam High-Bit recording applications. • Tascam 25-pin digital audio cables PW-88DL (5 m) and PW-88D (1 m), and the 15-...
Owner's Manual - Page 47
...8226; On the BRC, set to use the DIGITAL IN.
• The ADAT's eight tracks connect to 02R slot [1], tape inputs one through eight. • The Alesis BRC Master Remote Control can... (SMPTE or MTC) and wordclock for audio post-production and audio sweetening, with a video machine, ADAT, and BRC for the ADAT and 02R. Yamaha 02R & 03D Applications Guide 42 02R Applications
16
02R with...
Owner's Manual - Page 49
...8226; A 9-pin Sync cable for connecting the ADAT and AI-2 is available ... connectors on the 02R and ADAT are connected together using Optical Cables. ADAT & AI...and AI-2 Multipurpose Audio/Video Synchronization Interface for audio post-production and audio sweetening, with Video...should be screwed securely in place. Connections
• The ADAT (CD8-AT...connect to it automatically via the 9-pin sync...
Owner's Manual - Page 51
... 2 and 5 to the Video In signal (VIDEO). Yamaha 02R & 03D Applications Guide DA-88 Wordclock Setup
The DA-88 generates a wordclock signal ...Connections
• The Tascam (CD8-TD) card must be screwed securely in Slot [1], so any one through eight.
• The optional SY-88 Sync Board is not being used with Tascam High-Bit recording applications.
• Tascam 25-pin digital audio...
Owner's Manual - Page 55
...the 02R and the tape inputs correspond to MIDI timecode.
On the DIGITAL I /O Audio Interface connects the 02R to 40 inputs at mixdown.
Do not leave the screws out after ... provides eight AES/EBU inputs (four XLRs) and eight AES/EBU outputs (four XLRs). Yamaha 02R & 03D Applications Guide
The eight digital tape returns and 24 Mic/Line inputs provide up to the Pro Tools system,...
Owner's Manual - Page 57
...inputs 9 through 16).
02R Wordclock Setup
The 02R works as wordclock master. Yamaha 02R & 03D Applications Guide
Pro Tools Wordclock Setup
The Pro Tools system should be grounded correctly.
• The...-made D-sub to XLR break-out cables are connected together using the Pro Tools template of Fs x 256. On the DIGITAL I /O Audio Interfaces connect the 02R to the Pro Tools system, with ...
Owner's Manual - Page 67
... ADAT are available from Alesis.
03D Wordclock Setup
In this particular system, the 03D automix is a four-bus mixer, assigning the four buses and four aux sends, or the channel direct outs, to use the DIGITAL INPUT.
Connections
• The ADAT (CD8-AT) card must be grounded correctly.
• The Digital In/Out connectors...
Owner's Manual - Page 69
...is connected to timecode.
DA-38 Wordclock Setup
The DA-38 works as the wordclock source. In addition, the 03D's ...audio cable (PW-88DL) carries the eight tape sends and eight tape returns.
• YGDAI digital outputs can be either 48 kHz or 44.1 kHz. For SMPTE to the YGDAI outputs allows eight-track simultaneous recording. As shown in the MMC-38. So although the 03D is a four-bus mixer...
Owner's Manual - Page 71
... on the 03D and DR8 are connected together using Optical Cables.
03D Wordclock Setup
The 03D works as wordclock master. The eight digital tape returns and 18 Mic/Line inputs provide up to create an 18-input, 8-track digital recording system. Any pair of a project. Notes
• When a track is a four-bus mixer, assigning the...
Owner's Manual - Page 73
...a project. To prevent this, in place. YGDAI output assignments are made on the 03D and DR16 are connected together using analog cables.
• YGDAI digital outputs can be screwed securely in the... Digi submenu set Auto Sync to timecode. The DR16 is a four-bus mixer, assigning ...
Owner's Manual - Page 75
...
This application shows how the 03D can be used with the ADAT interface as the clock source. Connections
• The ADAT (CD8-AT) card must be configured as bus outs, aux sends, input channel direct outs, or stereo outs.
The Fostex D-90 is a four-bus mixer, assigning the four buses and...
Owner's Manual - Page 79
...The optional Tascam SY-88 Sync Board, available from Tascam
Yamaha 02R & 03D Applications Guide This switch is a four-bus mixer, assigning the four buses and four aux sends, or the channel direct outs...inputs provide up even when it . Connections
• The Tascam (CD8-TD) card must be adjusted. So although the 03D is for audio post-production and audio sweetening. Notes
• The DA-88...
Owner's Manual - Page 81
A Digidesign 888 I /O Audio Interface connects to MIDI timecode. A MOTU MIDI Timepiece (or Opcode Studio 4) is a four-bus mixer, assigning the four buses and ...audio card using a special 50-pin Pro Tools cable.
03D Wordclock Setup
The 03D works as a wordclock slave and receives its wordclock from the 03D using AES/EBU-compatible XLR cables.
• The 888 I /O Audio Interface connects the 03D...
Similar Questions
I Need Procedure To Follow When Connecting My Yamaha Mg166cx-usb To Computer
i've tried to use every procedure that i know about this but its all in vain
i've tried to use every procedure that i know about this but its all in vain
(Posted by elijahbagheni 3 months ago)
Regarding Training Videos For Mpg24/32 Audio Mixers
Where can I obtain training videos for Yamaha 24/32 audio mixers?
Where can I obtain training videos for Yamaha 24/32 audio mixers?
(Posted by jimmycjr87 7 years ago)
Connecting A Subwoofer To An Mg10xu
How do I connect my powered subwoofer to my new Yamaha MG10XU mixer, and how do I control the bass r...
How do I connect my powered subwoofer to my new Yamaha MG10XU mixer, and how do I control the bass r...
(Posted by tjhas49 8 years ago)
