Whirlpool WFW9050XW Support Question
Whirlpool WFW9050XW Support Question
Find answers below for this question about Whirlpool WFW9050XW.Need a Whirlpool WFW9050XW manual? We have 4 online manuals for this item!
Question posted by jwkillian40 on October 30th, 2011
Water Problem
I have water dripping out of the bottom of the washer door and when it fille to rinse it runs out of the drawer that you put your detergent in
Current Answers
Related Whirlpool WFW9050XW Manual Pages
Owners Manual - Page 3
...176;F (0°C). Your washer can cause damage in a basement, laundry room, closet, or recessed area. Tools needed for connecting the water inlet hoses ■...water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
■ A level floor with a total weight (water and load) of the washer. Some water can remain in the washer and can be considered. Installing the washer...
Owners Manual - Page 4
... closet installation - closet or confined area B. Installation clearances ■ The location must be large enough to allow the washer door
to reduce noise transfer.
■ Companion appliance spacing should be considered. closet or confined area
4 Washer only
2" (50 mm)
36" min. (914 mm)
1" (25 mm)
27" (686 mm)
1" (25 mm)
1" (25 mm)
27...
Owners Manual - Page 7
... coupling by hand until the bolts are removed.
Clear the water lines
■ Run water through the opening of the rear panel and close the hole with the attached cap.
4. Firmly seat the washers in the rear panel of the washer that the rear of the washer is within approximately 3 ft. (900 mm) of its final...
Owners Manual - Page 8
... in place, release pliers. Turn on the hoses for future reference.
Laundry tub drain or standpipe drain
Connect the drain hose form to the washer's cold (C) water faucet. Once drain hose is seated on the valve. Hot water inlet C.
A
B
A. To keep drain water from washer drum
1. CH
2. Screw on coupling by hand until it is seated...
Owners Manual - Page 9
... the drain hose in the laundry tub or standpipe as shown. Slide the washer to clean your washer, measure 1/2 the detergent
manufacturer's recommended amount of your washer avoids excessive noise and vibration.
Read "Washer Use." 9. Select Clean Washer with the floor.
3. Repeat to start washer.
Check the electrical requirements. Level the Washer
Proper foot to follow these instructions...
Owners Manual - Page 10
...washer saves energy, too. Smart Dispensers The three compartments in the dispenser allow loading of water is available in all laundry products before the washer is included in the detergent advantage system. The detergent... large load sizes. Use only HE High Efficiency detergent. This washer allows a 7-minute period in the rinse cycle. With a low water level, you can wash a pillow or a ...
Owners Manual - Page 11
...Sort laundry according to specific sections of detergent to the detergent, bleach, or fabric softener compartments. See "Using the Dispenser."
4. See "Options."
6. Using the Proper Detergent
Use only High Efficiency detergents. This wash system, along with less water, will be caught within the washer resulting in washer errors, longer cycle times, and reduced rinsing performance...
Owners Manual - Page 12
...the dispenser drawer. 2.
Choosing the Right Detergent
Use only High Efficiency detergents. Push in washer errors, longer cycle times, and reduced rinsing performance. To power down the washer after the wash cycle. Always use . Using regular detergent will likely result in the dispenser drawer slowly and completely (to
the Main Wash compartment along with less water, will be...
Owners Manual - Page 13
...oversudsing occurs or the load is too high, the washer will stay on your water pressure, water temperature, detergent, and clothes load. Cycles
Wash Cycles
Choose Wash...door unlocks, and clothes can be canceled, the items added, and a new wash cycle started , if the Add a Garment status light is pressed. Heavy Duty
Use this feature except Rinse & Spin, Drain & Spin, and Clean Washer...
Owners Manual - Page 14
... option will hear sounds that bleed or fade Light soils
In wash water temperatures colder than 60°F (15.6°C), detergents do not dissolve well.
See "Cleaning Your Washer." You may be the same temperature as the water coming from your cold water faucet. See "Troubleshooting." To change an option after starting a cycle anytime before...
Owners Manual - Page 15
... type
of your garments. ■ Use only High Efficiency detergents.
Separate lint-givers (towels, chenille) from noncolorfast items.
■ Sort by fabric and construction (sturdy cottons, knits, delicate items). It may rust if left in washer errors, longer cycle times and reduced rinsing performance. LAUNDRY TIPS
Preparing clothes for the best performance. This wash...
Owners Manual - Page 17
... under running water.
Always do the following to maintain washer freshness ■ Use only HE High Efficiency detergent.
■ Leave the door slightly open .
Open the washer door and remove any clothing or items from the softener and bleach
compartments). 3. The cycle will cause product damage over time.
4. Cleaning the dispenser drawer
The dispenser drawer is complete...
Owners Manual - Page 18
... the drum. 2.
If storing or moving your washer only when you should: ■ Unplug washer or disconnect power. ■ Turn off the water supply to reduce the risk of time, you are found. Run the washer through the Normal cycle with 1/2 the manufacturer's recommended amount of HE detergent for an extended period of hose failure. To...
Owners Manual - Page 19
...when the door is drained from the rear of normal washer operation.
■ Is washer installed on display (Long Fill - You may hear metal items touching the washer drum. As with metal snaps, buckles, or zippers? This happens during "Add a Garment"? See "Remove Transport System." Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for potential problem and...
Owners Manual - Page 20
..., or liquid chlorine bleach to the Main Wash compartment.
■ Is there water in the dispenser at the end of the cycle?
Failure to follow the manufacturer's directions when adding detergent and fabric softener to start
■ Is the washer door firmly shut? Do not use an extension cord. Check electrical source or call...
Owners Manual - Page 21
...water supply and the water valve. Incorrect water temperature or Wash/Rinse temperature
■ Are the hot and cold water... no water splashing in water source. Washer won 't fill
■ Low water pressure ...drawer is it taped to continue. See "Level Washer."
■ Has the drawer dispensed detergent? Washer won 't dispense
■ Is the washer level? Check if the home has low water...
Owners Manual - Page 22
... when mixing whites and colors in a low-speed cycle? For best performance, use powdered detergent in a load. Wash water colder than 60°F (15.6°C)? A hot rinse followed by spin will not operate correctly with this washer. If the laundry is still wet, take half of the load out of dye can be trapped in...
Owners Manual - Page 23
... LAUNDRY WARRANTY... authorized Whirlpool dealer to repair or replace appliance light bulbs, air filters or water filters.
WHIRLPOOL SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. If outside...to parts or systems resulting from state to state or province to resolve the
problem after checking "Troubleshooting," additional help you obtain assistance or service if you ...
Energy Guide - Page 1
...
Estimated Yearly Electricity Use
$11
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility rates and use.
• Cost range ....65 cents per kWh and natural gas cost of this label before consumer purchase.
Clothes Washer Capacity: Standard
Whirlpool Corporation Model: WFW9050X* Cat. Government
Federal law prohibits removal of
$1....
Warranty - Page 1
...Canada, call 1800253-1301. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase... future reference. Consumable parts are unable to resolve the
problem after checking "Troubleshooting," additional help you obtain assistance or...to repair or replace appliance light bulbs, air filters or water filters. In the U.S.A., call 1800807...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Not draining, not spinning out water, wet loads - Top-load washer
...very soft water, use slow spins to wash, drain, rinse and spin. Washer not draining, not spinning out water; Make ...washer isn't draining or spinning out enough water. enter your product model number in the load. Always measure detergent and follow the manufacturer's directions for details; Slow spinning also leaves more water in the search tool below to fill with the problem... -
The cycle time is not correct - Cabrio® washer with agitator
... to redistribute the laundry load in Corners Not draining, not spinning out water, wet loads - The Estimated Time Remaining is based on your desired cycle using less detergent in the suds to break. This pause and rinsing is not able to zero? During this time the washer pauses the wash action... -
Washer will not fill - Front-load Duet washer
...-load Duet washer Washer will not fill - washer Can I use an extension cord. Do not use anti-flood hoses and devices on . If the problem continues to start after the last cycle? NOTE: Both hot and cold water must be connected to side. Are the water inlet valve screens on ? Is the washer door firmly shut? The door must be...
Similar Questions
Liquid Bleach Dispenser Stays Full Of Water, Past The Max Fill Line.
liquid bleach dispenser stays full of water. I can never put bleach in because it is full of water e...
liquid bleach dispenser stays full of water. I can never put bleach in because it is full of water e...
(Posted by jj1042 9 years ago)
Whirlpool Wtw57esv Washer Wont Fill With Water
(Posted by remicJosem 9 years ago)
Washer Won't Fill With Cold Water.
The washer won't fill with cold water running on normal cycle. It will run for rinse & spin. We'...
The washer won't fill with cold water running on normal cycle. It will run for rinse & spin. We'...
(Posted by jcmaurer 10 years ago)
My Whirlpool Wfw9050xw Front-load Washer Fills With Water Until An Error Occurs
(Posted by huge40817 10 years ago)
Whirlpool Front Load Washer Stalls After Filling Up With Water
I have a whirlpool WFW9050XW , but without an LED display. On diagnosis, It blinks 8 times then one....
I have a whirlpool WFW9050XW , but without an LED display. On diagnosis, It blinks 8 times then one....
(Posted by rick94110 11 years ago)