Whirlpool WFW72HEDW Support Question
Whirlpool WFW72HEDW Support Question
Find answers below for this question about Whirlpool WFW72HEDW.Need a Whirlpool WFW72HEDW manual? We have 5 online manuals for this item!
Question posted by berniesue5 on May 30th, 2019
Codes For Operation And Error Codes
we never got manuals with the washer, is there a error code list and operation page on setting to use different settings?
Current Answers
Answer #1: Posted by Odin on May 30th, 2019 9:39 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
The manual can be viewed at https://www.manualslib.com/manual/985420/Whirlpool-7mwfw72hedw0.html. A list of error codes is at https://www.partselect.com/JustForFun/Whirlpool-Appliance-Fault-Codes.aspx (scroll down to Whirlpool Duet Front Loading Automatic Washer Fault Codes). For any further concerns, use the contact information at https://www.contacthelp.com/whrlpool/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW72HEDW Manual Pages
Installation Guide - Page 3
... must be exposed to 120° F (49° C). IMPORTANT: Do not install, store or operate washer where it will need:
n A water heater set to weather or in .2 (155 cm2)
3"
1"*
(76 mm) (25 mm)
5" (127 mm...(1.2 m) of hot and cold water fill valves on washer, and water pressure of 20-100 psi (137.9-689.6 kPa). Installing on back of washer to your "Use and Care Guide" for ease of 1" (25 mm...
Installation Guide - Page 4
...from bottom of washer. See "Alternate...washer. Floor drain system
4.5" (114 mm)
See requirements for a standpipe drain: 2" (51 mm).
Top of laundry tub must be at least 30" (762 mm) high; Floor standpipe drain system
Laundry...washer. (Additional hoses may be needed . Recessed area or closet installation (washer...1" (25 mm) on all sides of washer.
** Recommended 4" (102 mm), minimum...
Installation Guide - Page 5
..., set washer onto cardboard before moving it is recommended that a qualified electrician determine that a separate circuit breaker serving only this appliance be in a fully upright position.
2. Move washer
n A 120 volt, 60 Hz., AC only, 15- A time-delay fuse or circuit breaker is required. If a mating outlet is not available, it is used, it .
1.
n If codes...
Installation Guide - Page 6
... shown in until installation has been completed.
CONNECT DRAIN HOSE
7. For a laundry tub or standpipe drain, go to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 Place power cord over end of washer.
3. IMPORTANT: Do not plug washer in Step 8. Remove power cord
If clamp is transported at later...
Installation Guide - Page 7
... attaching hoses to remove the drain hose form from the end of laundry tub. Washer
IMPORTANT: To avoid leaks, check that your water inlet hoses have flat washers at both ends. Do not use hoses without washers.
11. C onnect inlet hoses to faucets or washer. IMPORTANT: Only 4.5" (114 mm) of drain hose should run until it...
Installation Guide - Page 8
... contact
Slowly turn .
IMPORTANT: Do not overtighten or use tap or sealants on floor. Place a level on water faucets to Step 19. Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (114 mm)
4.5" (114 mm)
4.5" (1143 mm)
Grip washer from beneath washer. Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for leaks...
Dimension Guide - Page 2
...It is available (Part Number 3363920).
IMPORTANT: To avoid siphoning, only 4.5" (114 mm) of washer to 1" (25 mm) diameter Standpipe Adapter Kit is recommended that may be purchased separately. A...) that a separate circuit serving only this appliance be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. See "Alternate Parts". Top of installation and servicing,...
Use & Care Guide - Page 5
For best results, follow the garment label instructions. Spin This washer automatically selects the spin speed based on the washer.
For lightly soiled and delicate fabrics, use the Soil setting to select more damp. Lower soil level settings will periodically tumble the load after the wash cycle. A Extra Rinse Activate this option to turn on .
4 DELAY...
Use & Care Guide - Page 6
...to see how the settings you may pause the washer, open the door, and add items. Touch and hold soil in the "Using Your Washer" section.
3.
n Use powdered detergent when using the Delay Wash ... closed. however, the display will light to start the washer again.
IMPORTANT:
n Do not add single-dose laundry packet to use. They hold START to indicate that cycle. Door Locked
Door...
Use & Care Guide - Page 8
...
Drain
Hot
Fast
Heavy TumbleFresh™
that best fit the load being washed. For some options cannot be used together. Small load: Fill the washer drum with affresh® cycle. This cycle should not be set the spin speed to about 3/4 full.
Small loads of clothes
Drain
N/A
& Spin
Fast
N/A TumbleFresh™
Medium
Delay...
Use & Care Guide - Page 9
... the latch clicks. Close the washer door by pushing it without laundry
Before washing clothes for colorfastness by recommended cycle, water temperature, and colorfastness.
Use only HE detergent. Use 1/2 the manufacturer's recommended amount for best cleaning and to adding laundry.
Loose change, buttons, or any small object can set stains into washer
Sort items by testing stain...
Use & Care Guide - Page 13
... and remove any detergent or other chemicals to the washer drum. Dilute Liquid Chlorine Bleach Procedure: i. Mix a dilute bleach solution, using a damp cloth. IMPORTANT: n Wear rubber gloves when cleaning with affresh® Cycle Operation is on , the washer door will use it for future wash cycles until you deselect that option.
f. NOTE: For best results...
Use & Care Guide - Page 14
... dispenser
with guides in the washer's dispensers. Use mild soap and water.
Washer Maintenance
WASHER CARE (cont.)
Description of Clean Washer with affresh® Cycle Operation: 1. The Clean Washer with affresh® cycle will determine
whether clothing or other items are in the washer. 2. If no items are using your washer to help keep it stops. 2. Use an all-purpose surface...
Use & Care Guide - Page 15
... moving : 1.
Shut off both water faucets. Plug in washer drum
and run washer through HEAVY DUTY cycle to your washer only when you are home. NON-USE AND VACATION CARE
Operate your washer, it from back of washer.
4. See "Cleaning the Dispensers." If storing or moving .
3.
TRANSPORTING YOUR WASHER
1. If washer will not freeze. Bundle power cord with a rubber...
Use & Care Guide - Page 16
... than 41⁄2" (114 mm). Touch POWER once to clear the code. Drain hose extends into standpipe farther than 96" (2.4 m) above appears in the inlet hose. Use only HE detergent. Always measure detergent and follow manufacturer's directions based on . Washer making error beeps
Door has not been opened and closed completely and latching. Troubleshooting...
Use & Care Guide - Page 17
... for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Only use HE detergent.
Properly seat all household plumbing for proper installation
Water or suds leaking from washer" in water
...here or visit our website at certain stages of the washer.
In Canada www.whirlpool.ca for assistance and to operate properly. If you experience
Possible Causes
Solution
Vibration or...
Use & Care Guide - Page 20
... water or high level of balance. If you will not operate correctly with dry items only. Select a slower spin speed.
The washer will start to operate incorrectly.
If safe for
are not reversed. Use only HE detergent.
Unload the washer as soon as expected (cont.)
Desired setting or option does not light
For best performance, not...
Use & Care Guide - Page 22
.... Load dispensers before adding clothes.
Cycle time changes or Normal washer operation. This routine will see "3," then "2," then "1."
22 Avoid washing single items. Balance a single item such as expected (cont.)
Incorrect dispenser operation
Clogged dispensers or laundry products dispensing too soon. When using correct cycle for 3 seconds to redistribute the load.
For each...
Use & Care Guide - Page 23
...Serial number Purchase date
23 WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is installed, operated, and maintained according to instructions attached... and repair labor to correct defects in accordance with electrical or plumbing codes, or use or when it is installed in an inaccessible location or is not installed in ...
Warranty Information - Page 1
...LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase.
6. Cosmetic damage, including scratches, dents, chips or other damage to the finish of your major appliance, unless such damage results from defects in materials or workmanship and is installed, operated... other rights that comes with electrical or plumbing codes, or use or when it is installed in an inaccessible ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water supply hookup - French door with exterior dispenser
...whether the sediment filter in some households. Allow 24 hours to operate the water dispenser and ice maker. You should be between...;" drilled hole in the water pipe and that the rubber washer is used in many areas due to connect the copper tubing. 7. ...Place the free end of copper tubing you are ready to plumbing code requirements. Coil the copper tubing. Connect to 31.8 mm) vertical... -
Water supply hookup - Bottom freezer/French door refrigerators
... IMPORTANT: All installations must meet local plumbing code requirements. Add 8' to the cold water ... before you have questions about 3 to operate the water dispenser and ice maker. Check...service loop, and use special care to flow. Correct any tools listed here. Water pressure ... Do not kink; shape so that the rubber washer is blocked. French door with a "P" clamp.... -
Proposition 65 Warnings
... for chemicals used within the product. Therefore, Whirlpool has elected to comply with all listed chemicals provide exposure limit requirements. Error code on the list of chemicals identified... Front-load washer Different types of California. To comply with this warning is present. California Proposition 65 is required in the Use and Care Manual is present....
Similar Questions
Washer Over Flowing
Washer over flowing on certain settings and flossing bathroom
Washer over flowing on certain settings and flossing bathroom
(Posted by Aubreylillian21916 1 year ago)
My Washer Just Under 30 Days , Maybe Used 5 Times. Started A Wash Last Night, O
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
(Posted by rwtaylor7678 6 years ago)
The Washer Door Is Locked
We tried to push the unlock button, it counts down but it will not release. Will unplugging it reset...
We tried to push the unlock button, it counts down but it will not release. Will unplugging it reset...
(Posted by sandiezweber 8 years ago)
Whirlpool Duet Model Wfw72hedw Washer Is Frozen - Panel Does Not Light Up Except
(Posted by pmakay 8 years ago)
Washer Is Frozen With Door Lock Light Flashing.
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
(Posted by wendyfinn892 9 years ago)