Whirlpool WFE361LVQ Support Question
Whirlpool WFE361LVQ Support Question
Find answers below for this question about Whirlpool WFE361LVQ - WhirlpoolR 30 in. Ing Electric Range5.Need a Whirlpool WFE361LVQ manual? We have 4 online manuals for this item!
Question posted by taylordavid on January 28th, 2017
Neither The Range Top Or The Oven Are Heating. Why?
the double 30 amp breaker was old so I bought a new dbl 30A breaker and replaced it. now the display works but nothing gets hot. it's getting power at the breaker on both legs but stove isn't getting hot.
Current Answers
Answer #1: Posted by Odin on January 28th, 2017 6:14 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See http://producthelp.whirlpool.com/Troubleshooting?startid=3670., esp. "Nothing Will Work." Good luck!
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFE361LVQ Manual Pages
Dimension Guide - Page 1
... height (max.) with leveling legs screwed
all the way in the "Product Dimensions" section. Model/serial rating plate (located on the oven frame behind
storage drawer panel)
*Range can be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate.
30" (76 cm) Freestanding Electric Range
PRODUCT MODEL NUMBERS
GFE461LV...
Installation Instructions - Page 1
... Only 7 Verify Anti-Tip Bracket Location 12 Level Range 12 Storage Drawer 12 Complete Installation 13 Moving the Range 14 ANTI-TIP BRACKET TEMPLATE 15
IMPORTANT:
Save for local electrical inspector's use. U.S.A. INSTALLATION INSTRUCTIONS 30" (76 CM) FREESTANDING ELECTRIC RANGES
Table of Contents
RANGE SAFETY 2 INSTALLATION REQUIREMENTS 3
Tools and Parts 3 Location Requirements...
Installation Instructions - Page 3
...range should be rated at 250 volts minimum, 40 amps or 50 amps that all electrical connections be made by reaching over heated surface units, cabinet storage space located above .
■ Four-wire power... be used . This oven has been designed in ring terminals or open-end spade terminals with the range, see "Install Anti-Tip Bracket" section.
■ Grounded electrical supply is to be ...
Installation Instructions - Page 4
Cabinet Dimensions
Cabinet opening dimensions shown are in doubt as to combustible walls with local codes. Electrical Requirements - U.S.A. Do not use an extension cord.
A freestanding range may be raised approximately 1" (2.5 cm) by adjusting the leveling legs. upper cabinet depth B. 30" (76.2 cm) min. opening width C. A copy of the above the cooktop surface. WARNING: Improper ...
Installation Instructions - Page 5
... of the 4-wire power supply cord is connected to the figures in a NEMA Type 14-50P plug on the oven frame behind the storage drawer panel. or 50-amp range power supply cord (pigtail).... breaker box (or fused disconnect) through the neutral conductor. This uses a 3-wire receptacle of the range.
■ The wiring diagram is manufactured with the ground connected to the proper electrical ...
Installation Instructions - Page 6
... more people to lower the front and rear leveling legs one-half turn. Remove oven racks and parts package from inside
the oven cavity) or from range. 2.
On Ranges Equipped with a warming drawer, the rear legs cannot be centered in the "Location Requirements" section, adjust template so range will be killed. Use wrench or pliers to move...
Installation Instructions - Page 7
... of your local hardware store. Use a new 40 amp power supply cord. Use 8 gauge copper or ...range.
3. Fasten anti-tip bracket with a hammer. Only
Power Supply Cord
Direct Wire
WARNING
WARNING
Electrical Shock Hazard Disconnect power before servicing.
Electrically ground range. Two mounting tabs each side B.
Disconnect power.
2. Electrical Shock Hazard Disconnect power...
Installation Instructions - Page 8
...40-amp, range power supply cord
4-wire connection: Power supply cord
A
A. Electrical ...breaker 4-wire connection:
box or fused
Direct wire
disconnect
5" (12.7 cm)
3-wire receptacle (NEMA type 10-50R)
A UL listed, 250-volt minimum, 40-amp, range power supply cord
3-wire connection: Power supply cord
Style 2: Direct wire strain relief ■ Remove the knockout as needed for : ■ New...
Installation Instructions - Page 12
...Ranges Equipped with a warming drawer, the rear leg cannot be level for removal. Push range back into position. NOTE: Range must be seen by pressing the screwdriver handle toward the side of range, first side to adjust leveling legs up or down until rear leveling leg is level. Replace... back approximately 1" (2.5 cm). Insert a flat-blade screwdriver through the opening in oven.
2.
Installation Instructions - Page 13
... cloth. If range does not operate, check the following: ■ Household fuse is level. To Replace: 1. Complete Installation
1. Check that all packaging materials. 4.
Once the storage drawer is connected.
■ See "Troubleshooting" in the drawer glides. Turn on . 8. Slowly push the storage drawer into appropriate outlet. Turn power on surface burners and oven. Lift...
Owners Manual - Page 1
... in TROUBLESHOOTING, please visit our website at 1-800-253-1301. ®
ELECTRIC RANGE
USER INSTRUCTIONS
THANK YOU for additional information. Table of Contents
RANGE SAFETY 2 The Anti-Tip Bracket 2
FEATURE GUIDE 4 COOKTOP USE 5 OVEN USE 6
Electronic Oven Controls 6 Aluminum Foil 6 Positioning Racks and Bakeware 6 Oven Vent 7 Baking and Roasting 7 Broiling 7 Timed Cooking (on some...
Owners Manual - Page 3
... OR INTERIOR SURFACES OF OVEN - Let hot air or steam escape before removing or replacing food.
■ Do Not Heat Unopened Food Containers - Other surfaces of the appliance may subject wiring or components underneath to damage.
■ Protective Liners - No commercial oven cleaner or oven liner protective coating of any part of the range.
■ Wear Proper...
Owners Manual - Page 5
...REMEMBER: When range is on. Use cookware about the same size as a regular element. Timed Cooking allows the oven to be set to turn to enter the starting time for an oven function with ...the most even heating. If cookware is displayed.
Cookware should not be used in the display. Cooktop On Indicator Light (on some models)
On ceramic glass models, the hot surface indicator light...
Owners Manual - Page 7
... enter a
temperature other than one displayed. 3. Oven Vent
A A
The oven vent releases hot air and moisture from the oven, and should not be ordered.
Oven vent (ceramic glass model)
A. the...pan, one displayed.
3. Baking Layer Cakes on 2 Racks
For best results when baking cakes on some models)
The ACCUBAKE® system electronically regulates the oven heat levels during preheat...
Owners Manual - Page 8
...oven vent(s) during Self-Cleaning cycle. Air must be displayed.
4. How the Cycle Works IMPORTANT: The heating and cooling of day to move freely. If the temperature is time adjustable between LO and HI clean time.
3. Electronic Oven...2 hours 30 minutes and 4 hours 30 minutes in burns. The oven door will appear on . When the oven is reached, the oven will also be displayed. Press ...
Owners Manual - Page 9
....
9 Liquid detergent or all controls are off when hot. Cooktop Scraper Part Number WA906B is cool. You may...OVEN DOOR EXTERIOR
STAINLESS STEEL (on some models) Before removing or replacing coil elements and burner bowls, make sure they will burn off and the oven...cleaners with Cooktop Cleaner as soon as the entire range is also recommended for contact information. The marks...
Owners Manual - Page 10
... been a power failure. On some models, reset the clock, if needed. See "Control Display" in the "Feature Guide" section. Oven cooking results not what expected ■ Is the control knob set ? STORAGE DRAWER Check that have discolored and are in the "Feature Guide" section.
Replace the fuse or reset the circuit breaker. Excessive heat around cookware...
Owners Manual - Page 11
... Racks and Bakeware" section.
■ Is there proper air circulation around bakeware? Oven peeking releases oven heat and can result in the pan.
■ Is the proper length of the "Electronic Oven Controls" section.
■ Was the oven preheated? ■ Is the proper oven temperature calibration set? See "Baking and Roasting" section.
■ Are the racks...
Owners Manual - Page 12
...within 30 days from the date of your major appliance for future reference. Any food loss due to repair or replace appliance... Internet and you need further assistance, you on the oven frame behind the storage drawer panel. LIMITATION OF REMEDIES ... instructions attached to or furnished with electrical or plumbing codes, or use your major appliance, to replace or repair
house fuses, or to...
Warranty - Page 1
... to schedule service, you on the oven frame behind the storage drawer panel....
published installation instructions. 11. Proof of repair or replacement under this limited warranty. Service calls to refrigerator or... a daytime phone number in accordance
with electrical or plumbing codes, or use of consumables...workmanship and is reported to Whirlpool within 30 days from the date of purchase....
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I bake and roast using my gas range?
... be set temperature can be seen for the temperature showing on my electric range? How do I use . The bake range can be shown in the display. The temperature can be pressed again. "PrE" (on some models) The AccuBake system electronically regulates the oven heat levels during preheat and bake to the cycling of the elements. Press... -
My gas oven cooking results are not what I expected
.... Oven peeking releases oven heat and can be shown in intervals. Move rack to set between 30°F (15°C) and -30°F (-15°C). A minus sign means the oven will appear on the display.... regulates the oven heat levels during preheat and bake to the "Positioning racks and bakeware" section in the oven. The oven temperature on my gas range and how does it work? See the... -
What is the AccuBake® Temperature Management System on my electric range?
... Racks and Bakeware" section in use. Display showing letters and numbers and hidden features/functions What is the AccuBake ® Temperature Management System on some models) The AccuBake system electronically regulates the oven heat levels during preheat and bake to maintain a precise temperature range for the oven preheat conditioning time to wait for optimal...
Similar Questions
How Much Does The Oven Heating Element Cost?
(Posted by edenscatering 2 years ago)
My Display And Oven Wont Turn On
My stove works fine but the display isnt on not even the clock and when I open the door the light wo...
My stove works fine but the display isnt on not even the clock and when I open the door the light wo...
(Posted by dlacio84 9 years ago)
The Oven Is Not Getting Up To Temp. What Could This Be?
My oven is not getting up to temp but when I put the broiler on the top bake element starts glowing....
My oven is not getting up to temp but when I put the broiler on the top bake element starts glowing....
(Posted by Davidwwright1960 10 years ago)
Whirlpool Model Wfg114ssvq
F2 On Display When The Oven Heats Up
When the oven is turned on to heat up, we get F2 function when the oven gets to temparture. The oven...
When the oven is turned on to heat up, we get F2 function when the oven gets to temparture. The oven...
(Posted by kathleenolson5 11 years ago)
My Model Number Is Behind The Stuck Door On My Range. I Can't Get The Door To Un
(Posted by Anonymous-45874 12 years ago)