Whirlpool GH7208XRS Support Question
Whirlpool GH7208XRS Support Question
Find answers below for this question about Whirlpool GH7208XRS - 2.0 cu. ft. Velos Speedcook Microwave Oven.Need a Whirlpool GH7208XRS manual? We have 4 online manuals for this item!
Question posted by brighambreiner on February 13th, 2022
My Gh7208xrs-2, Serial # Tr U 31 12188, Hood Lights Only Not Turning On.
Microwave hood light only not turning on about a few weeks ago. On the 3 switch control panel, the fan turns on, the light and night light switches beep and indicate on the LCD display that the lights are on or off. Bulbs have both been replaced and Main power control board with new. Also get no 12volts at the bulb sockets with light switch on. Don't know if this matters or not, but interior Microwave light does work when door is opened.
Current Answers
Answer #1: Posted by akanetuk1 on March 29th, 2022 3:35 AM
akanetuk1
Member since:
February 6th, 2022 Points: 176,800
Member since:
February 6th, 2022 Points: 176,800
Related Whirlpool GH7208XRS Manual Pages
Owners Manual - Page 1
... your model and serial number located on your appliance.
WARNING
You can kill or hurt you should be followed, including the following:
WARNING: To reduce the risk of burns, electric shock, fire,
injury to persons, or exposure to reduce the chance of the microwave oven opening, behind the door. ® MICROWAVE HOOD COMBINATION USER INSTRUCTIONS...
Owners Manual - Page 2
... metal foil. IMPORTANT SAFETY INSTRUCTIONS
■ Use the microwave oven only for its intended use as described in this oven when not in use.
■ Do not store anything directly on top of the microwave oven when the microwave oven is in operation.
■ When flambeing foods under the hood, turn oven off, and disconnect the power cord, or shut...
Owners Manual - Page 3
... electrician or serviceman install an outlet near the microwave oven. Do not use of electric shock.
or 20-amp electrical supply
with a grounding plug. The plug must be turned off during convection and grill cooking (on setting the clock, timer, child lock, vent fan and cooktop light, and to soil buildup, clean rack supports often...
Owners Manual - Page 4
.../Dinnerware: Place dish on the grill rack.
Turntable B. Use ovenproof, microwave-safe cookware for all other convection and combination cycles.
■ Melamine ...directly on some models)
Use the provided pan for steaming, or use the dish in the microwave oven.
4 Steamer insert H. Program 1 minute of water beside it.
Grilling
Roasting
Accessory Configurations Baking...
Owners Manual - Page 5
...with plastic wrap and vent. Microwave Oven Care
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are replaceable.
■ Cavity light: The cavity light bulb is replaceable.
5 Clean...or as indicated below.
■ Cavity: To avoid damage to lessen doneness. Use microwave-safe dish with loose-fitting lid, or cover microwave-safe dish with your microwave oven.
The...
Owners Manual - Page 6
... ■ Charcoal filter(s) ■ Cooktop light bulb ■ Cavity light bulb
■ Steamer vessel ■ Pan...Control Make sure control is off to cool the microwave oven's controls while the cooktop below .
The bread should toast dark brown. Radio, TV or cordless phone interference Check the following :
■ Soil buildup Soil buildup on and off . The microwave oven's cooling fan...
Owners Manual - Page 8
...warranty. 8. This warranty is
void if the factory applied serial number has been altered or removed from the date of purchase...1301. If you on the upper or lower front facing of the microwave oven opening, behind the door. W10170439A
SP PN W10170448A
© 2007 .... 5. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. IMPLIED WARRANTIES, INCLUDING ...
Dimension Guide - Page 1
®
Microwave Hood Combination
PRODUCT MODEL NUMBERS
GH6208XR GH7208XR
Electrical: A 120-volt, ...ft.
3-1/4" x 10"
3-1/4" x 10"
roof cap = 24 ft. 90° elbow = 25 ft.
90° elbow 6" = 10 ft.
3-1/4" x 10" 45° elbow wall cap = 6" = 5 ft. 40 ft.
3-1/4" x 10" 90° flat
elbow= 10 ft. Because Whirlpool Corporation policy includes a continuous commitment to the microwave oven hood...
Installation Instructions - Page 1
... the instructions are very important. This symbol alerts you to Wall 7 Prepare Upper Cabinet 8 Install the Microwave Oven 9 Install Filters 10 Complete Installation 10 VENTING DESIGN SPECIFICATIONS 11 ASSISTANCE 12 Replacement Parts 12 Accessories 12
MICROWAVE HOOD COMBINATION SAFETY
Your safety and the safety of injury, and tell you don't follow instructions. WARNING
You...
Installation Instructions - Page 2
... or roof
venting)
Not Shown:
Upper cabinet template
Mounting plate (attached to make sure there is a registered trademark of clearance between the wall and the microwave oven, so that the damper blade can open freely and fully. Toggle nuts (2) E. 1/4" x 2" lag screws (2) F. See "Venting Design Specifications" section.
†®TORX is at least...
Installation Instructions - Page 3
... 20-amp electrical supply
with household inverter power supplies.
3 Recommended: ■ A time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven is an inverter, and is equipped with a cord having a grounding wire with a grounding plug. See "Electrical Requirements" section. Product Dimensions
(4168.4¹⁄₄c"m)
29...
Installation Instructions - Page 4
... screen.
4
The vent deflector holes should align with 2 mounting screws (1 on your model, the mounting plate may be uncovered. Vent deflector
4. Vent screen C. Rings
A. A
B
Convert Microwave Oven to External Venting
(for recirculation installation. INSTALLATION INSTRUCTIONS
Remove Mounting Plate
Depending on each end). If the mounting plate is set it so that door...
Installation Instructions - Page 5
... D. Position the damper assembly so that the long tab slides into the slot on the right side of microwave oven C. A B
C
D
A. Top of the damper vent opening, as shown.
Save the cover for possible change of microwave oven C. A
B C
A. NOTE: Do not install damper assembly at the perforations. Damper assembly C. Then secure with mounting screw. A. Back...
Installation Instructions - Page 6
... examples of the wall stud(s) within 6" (15.2 cm) of each stud, and draw a plumb line down each stud center.
Cabinet opening , do not install the microwave oven.
1. Holes for lag screws E. Using a stud finder, locate the edges of preferred installation configurations with the mounting plate. Mark the center of the vertical centerline...
Installation Instructions - Page 7
... one 1/4-20 x 3" round-head bolt with the front edge of the cabinet. Using a keyhole saw, cut out the venting cutout area. Mark Rear Wall
The microwave oven must be secured to being installed on a second wall stud, drill a 3/16" (5 mm) hole into the wall studs and/or drywall using a minimum of 1 lag...
Installation Instructions - Page 8
... the 10¹⁄₂" (26.7 cm) dimension from the back of the microwave oven. Metal cabinet B. Mounting plate C. Check alignment of mounting plate, making sure that ...Upper Cabinet
1.
The template has trim lines to use as guides.
■ If the wall behind the microwave oven (as shown.
Upper-cabinet template
D
E
10¹⁄₂"
10¹⁄₂"
(26.7...
Installation Instructions - Page 10
...microwave oven by placing 1 cup
(250 mL) of water on the turntable, and programming a cook time of the frame up until it fits into the slot on the left side of the microwave hood... Test vent fan and exhaust by inserting the wide tab of the filter frame into a grounded 3 prong outlet.
■ See the User Instructions for troubleshooting information. Microwave oven bottom
Complete Installation...
Installation Instructions - Page 11
... following length equivalents are for installation are not provided with
microwave hood combination.
■ We do not recommend using a flexible...ft (8.3 x 25.4 cm = 7.6 m) D. 90° elbow: 6" = 10 ft (15.2 cm = 3 m) E. Rectangular to round transition piece so that the damper can open fully.
Vent extension piece, at least 3" (7.6 cm) of clearance between the top of the microwave oven...
Installation Instructions - Page 12
... 90° elbows = 20 ft (6.1 m) B. 1 wall cap = 40 ft (12.2 m) C. 1 rectangular to round transition piece = 5 ft (1.5 m) D. 2 ft (0.6 m) + 6 ft (1.8 m) straight = 8 ft (2.4 m)
If the existing vent is located behind the microwave oven door on the front facing of the microwave oven.
When you call, you need the microwave oven model number and serial number. Each panel is a list of vent...
Warranty - Page 1
...by Whirlpool. 5. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. Repairs to Whirlpool with the...
coverage. 3. If you need assistance using your model number and serial number on the label located on how to the appliance. 9. ... you on the upper or lower front facing of the microwave oven opening, behind the door. SOME STATES AND PROVINCES DO NOT...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I replace the cooking light in my microwave oven?
... build every new Whirlpool appliance. Do not touch bulb with the same precision used to reorder. Replace charcoal odor filter. Plug in your nearest Whirlpool designated service center. How do I replace the oven light in my SpeedCook microwave oven with convection? Pull the vent grille out. Slide the top of light bulb do I operate the cooktop light on when the door is opened... -
Connecting refrigerator to a power source
... before removing a light bulb, turn the freezer control to the desired setting. Depending on your owner's manual for my freezer? Front-load washer Using the Dispenser Lock Feature - Recommended grounding method A 115 Volt, 60 Hz., AC only 15- Check your model, turn off by a switch. Connecting refrigerator to a power source What do I need to know about connecting... -
Dispenser and Refrigerator/Freezer compartment lights - Side by Side with Ice Bin in Door, Flush Mounted Dispenser with LCD Display
... Bin in refrigerator or reconnect power. Plug in Door, Flush Mounted Dispenser with one of the same size, shape and wattage. Dispenser and Refrigerator/Freezer compartment lights - The display screen indicates which mode is selected. ON: Press LIGHT to replace the bulb with LCD Display Can I replace the light bulb? - DIM: Press LIGHT a second time to turn on continuously, you use...
Similar Questions
Microwave Has Power The Light Quit Working And Will Not Turn On
(Posted by sgee3006 4 years ago)
Under Hood Lamps Will Not Light Up
I replaced one of the two bulbs with a 35watt bulb by mistake. Both bulbs worked fine for about 5 da...
I replaced one of the two bulbs with a 35watt bulb by mistake. Both bulbs worked fine for about 5 da...
(Posted by sdenke 8 years ago)
Microwave Wont Run Says Door Needs To Be Open And Closed And Still Doesnt Run?
(Posted by coachscaddy 11 years ago)
Unit Starts Beeping To Try To Change The Date. You Can't Use The Touch Screen
Intermittently the unit tries to change the date by itself and beeps from the date screen to the mai...
Intermittently the unit tries to change the date by itself and beeps from the date screen to the mai...
(Posted by Anonymous-58942 12 years ago)
The Display On My Whirlpool Gh7208xrs Is Blank.the Light Works Inside
(Posted by Anonymous-54967 12 years ago)