Troy-Bilt TB675 Support Question
Troy-Bilt TB675 Support Question
Find answers below for this question about Troy-Bilt TB675.Need a Troy-Bilt TB675 manual? We have 1 online manual for this item!
Question posted by Duvalbob on September 17th, 2020
Replacing Fuel Lines
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Troy-Bilt TB675 Manual Pages
Operation Manual - Page 1
...by an authorized and approved service dealer. When servicing, use only identical replacement parts.
769-08458 / 02
All information, illustrations, and specifications in ... Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB675 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance...
Operation Manual - Page 2
...#753-08052 Muffler Assembly. Wash hands after handling. Replace damaged parts. DO NOT smoke.
• Never operate the unit without the fuel cap securely in the states of California, Maine, ...factory equipped with the controls and proper use metal-reinforced line, wire, chain or rope. Take the following precautions:
• Store fuel only in a well ventilated outdoor area.
• ...
Operation Manual - Page 3
...and are available from debris. Do not extend the trimming line beyond the length of the vibration. The cutting head remains ... could block moving parts.
• To reduce fire hazard, replace a faulty muffler and spark arrestor.
Stop the unit. 2. ...mask or dust mask if the operation is not in contact with fuel in the tank, inside a building where
fumes may reach an open...
Operation Manual - Page 4
Failure to do not touch the line cutting blade.
4 Wear eye protection meeting current ANSI Z87.1 standards and... causing injury. • SAFETY & INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that fuel containing
greater than 10% ethanol will likely damage this engine and void the warranty. Read the operator's manual for a short...
Operation Manual - Page 5
... Plug
Starter Rope Grip Primer Bulb
ASSEMBLY TOOLS REQUIRED:
• #2 Phillips Screwdriver • 3/8" Socket
On/Off Switch
Handle Shaft Housing
Air Filter Cover
Throttle Control
Fuel Cap Choke Lever
Coupler
Oil Fill Plug
Cutting Head
Cutting Head Shield
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, 4-Cycle Displacement 30 cc (1.83 cu.
Operation Manual - Page 8
....
Funnel Spout Oil Fill Plug
Fig. 6
O-Ring Oil Fill Hole
Fig. 7
8 Failure to the fuel tank. Unscrew the top of oil during future oil changes. Set the unit on the oil fill plug ... Unscrew the oil fill plug (Fig. 7). 5. NOTE: Never add oil directly to use dirty oil. OIL AND FUEL
USING THE RIGHT OIL
Use a high-quality SAE 30 weight oil. NOTE: This unit was shipped without oil in ...
Operation Manual - Page 9
... spilled. 5. Keep sparks and open flames at least 30 ft. (9.1 m) from the fuel container and
the fueling site before storing the unit
WARNING: DO NOT USE E85 FUEL IN THIS UNIT.
NOTE: Dispose of ignition for spilled fuel.
WARNING: Remove the fuel cap slowly to federal, state and local
regulations. Avoid creating a source of old...
Operation Manual - Page 10
... area. Off (O) / Stop On ( I ) position at all times (Fig. 8).
3. Fill the fuel tank. Slowly press and release the primer bulb 10 times (Fig. 9).
4. Move the choke lever to ...
1. STARTING AND STOPPING
WARNING: Operate this time. Refer to squeeze the throttle control. Continue to Fueling the Unit. Pull the starter rope with a controlled and steady motion 3 to Position 2, and ...
Operation Manual - Page 11
... 9).
4. Insert the electric start accessory into the electric start . Move the choke lever to Fueling the Unit. Continue to squeeze the throttle control. Then move the choke lever to the electric...Electric Starter
STARTING INSTRUCTIONS
1. Press and hold the throttle control (Fig. 8). Fill the fuel tank. Run the electric start accessory in the OFF (O) position until the unit starts....
Operation Manual - Page 12
...level. • Keep the cutting head parallel to the proper length if any excess line is released. NOTE: Some line breakage will occur from left to the unit.
This may stall the engine. For... arm
slightly bent. • Hold the handle with the right hand. NOTE: Always keep the trimming line fully extended. Each time the bump knob is tapped, about 1 inch (25.4 mm) of injury ...
Operation Manual - Page 13
....
Cut one 20 foot (6 m) length of trimming line may be a part of any old trimming line and/or obstructions from starting accidentally. REPLACING THE TRIMMING LINE
Only use the trimming line described in the table. Insert the new trimming line into the entry eyelet (Fig. 16). Pull the line until a few inches protrude from each side of...
Operation Manual - Page 14
...Maximum Oil Level
Fig. 20
Spool Cover Inner Reel Outer Spool
O-Ring
14 Remove any old trimming line and/or obstructions. 4. Align the tabs on the spool cover with the holes on the cutting...plug. Stop the engine and allow it to Adding Oil. Removing Old Trimming Line and Obstructions If necessary, remove any old trimming line and/or obstructions from entering the oil fill hole. 2. NOTE: DO NOT...
Operation Manual - Page 15
...covered by the product warranty. Refer to spread and remove excess oil. 6. oz (60 ml) fill line indicated on the air filter cover into
a container (Fig. 21). Wash the air filter in the ...around the oil fill plug (Fig. 20) to federal, state and local
regulations. 4. Fig. 21
Fill Line
Fig. 22
Hole
Air Filter Housing
Tab
Air Filter Cover
Air Filter
Fig. 23
Cover Screw
15 NOTE: ...
Operation Manual - Page 16
...the engine hesitates or stalls on acceleration • there is cracked, fouled or dirty, replace it with a replacement part #753-05784, a Champion RDZ4H or an equivalent spark plug.
4. Grasp the ...in the engine could damage the cylinder.
3. Grit in the cylinder head.
Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. Inspect ...
Operation Manual - Page 17
...allow it to cool. Pull the starter rope slowly to run until it stalls. Repair or replace damaged parts and tighten loose screws, nuts or bolts. Wipe off any high quality motor oil...unauthorized use strong detergents. Preparing the Unit for more than 30 days.
STORAGE
• Never store a fueled unit where fumes may reach an open flame or spark.
• Allow the engine to cool before...
Operation Manual - Page 18
... The spark plug is fouled
Drain the fuel tank and add fresh fuel Stop the engine and clean the cutting head Clean or replace the air filter
Drain the fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug
THE CUTTING HEAD WILL NOT ADVANCE LINE The cutting head is bound with...
Operation Manual - Page 20
...Department of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental or ..., OH 44136-0019. Spark Plugs, Carburetor Adjustments, Filters B. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars,
Cultivator Tines...
Similar Questions
How To Replace Primer Bulb Lines On Tb675ec With A Two Port Primer
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
(Posted by dsnyder488 9 months ago)
3 Fuel Lines??
This has me stumped....Old 4 stroke trimmer given to me. All fuel lines broken or gone. Carb...no pr...
This has me stumped....Old 4 stroke trimmer given to me. All fuel lines broken or gone. Carb...no pr...
(Posted by donmmiller47 11 months ago)
Diagram For Correct Fuel Line Connections For Tb6044xp Trimmer
(Posted by geistys 2 years ago)
Fuel Lines For Tb6044xp
I think I have fuel lines going to the wrong nipples on the primer bulb. It is a three nipple bulb. ...
I think I have fuel lines going to the wrong nipples on the primer bulb. It is a three nipple bulb. ...
(Posted by memeishere 3 years ago)
Fuel Lines
I'm having trouble knowing where to correctly place the 3 fuel lines any help?
I'm having trouble knowing where to correctly place the 3 fuel lines any help?
(Posted by Reynaldoher98 7 years ago)