Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by lathissa on June 10th, 2013
String Holder Is Wobbling When In Use
I was using my new weed trimmer when it began to shake. I noticed that the part that holds the string was wobbling horribly. is there a way to fix this or do I just take it back?
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
... call the Customer Support Department to make changes at any time without notice. When servicing, use only identical replacement parts.
769-08457 / 02
All information, illustrations,...reserve the right to obtain a list of printing. Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6...
Operation Manual - Page 2
... safety of the operator and any way.
Replace damaged parts. Encourage bystanders to wear eye protection. Make all adjustments or repairs before use metal-reinforced line, wire, chain ...medication.
• Children must be
followed. Remove rocks, broken glass, nails, wire, string and other reproductive harm. Failure to obey a safety DANGER signal WILL result in any ...
Operation Manual - Page 3
...the attachment is turned off and disconnect the spark plug for maintenance or repair.
• Use only original equipment manufacturer (OEM) replacement parts and accessories for the cause of the vibration.... do a better, safer job when used at the intended rate.
• Always stop the unit immediately and check for its intended purpose.
• Always hold the unit with a foreign object, ...
Operation Manual - Page 4
...may appear on trimmer attachment
shield. SYMBOL MEANING
• SAFETY ALERT SYMBOL Indicates danger, warning or caution. Use a full face shield when needed.
• UNLEADED FUEL Always use clean, fresh ...touch the line cutting blade.
4
To prevent serious injury, do so can be used in serious injury to operator's manual for complete safety, assembly, operating and maintenance and...
Operation Manual - Page 5
...trimmer: • Cutting grass and light weeds. • Edging • Decorative trimming around trees, fences, etc. Other optional accessories may be used with cutting head, cutting head shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer...specifications are based on the latest product information available at any time without notice.
5 We reserve the right to make changes at the time of ...
Operation Manual - Page 6
...square bolt (Fig. 2).
6. Push the handle down onto the shaft housing (Fig. 3). While holding the unit in the operating position (Fig. 14), move the handle to the location that provides ...
6 Loosen the bolt with this unit.
1.
Cutting Head Shield
Use the following instructions if the cutting head shield is secure. Use only the instructions that apply to the right.
2. Insert the ...
Operation Manual - Page 7
... to the unit. Using the wrong hole could lead to personal injury or damage to loosen (Fig. 4). 2. NOTE: To make sure the
release button is fully snapped into the primary hole (Fig. 6).
For decorative edging with a string trimmer attachment, lock the release button into
the primary hole only. While firmly holding the attachment, push...
Operation Manual - Page 8
...wear and failure. Remove the cap from the oil bottle. Refer to the Maintenance Schedule. Failure to use clean oil of the oil bottle. 2.
Unscrew the top of oil during future oil changes. DO ...03 fluid oz. (60 ml) bottle of maintaining the proper oil level cannot be added before each use dirty oil. NOTE: Save the empty oil bottle. Check the oil level before starting the unit....
Operation Manual - Page 9
..., to avoid injury
from the fuel container and
the fueling site before starting the engine.
9 Using Fuel Additives Use a fuel additive, such as 1% water in the fuel can make fuel and oil separate, ...fuel tank. FUELING THE UNIT
WARNING: Gasoline is the most common cause of performance problems. Use only fresh, clean unleaded gasoline.
Place the fuel container spout into the fill hole on the...
Operation Manual - Page 10
...Slowly press and release the primer bulb 10 times (Fig. 10).
4. NOTE: SQUEEZE and HOLD the throttle control for an additional 60 seconds. Squeeze the throttle control (Fig. 9) and... pulling the starter rope (Fig. 12). Press and hold the throttle control, move the choke lever to 8 times. Refer to Position 2 (Fig. 11).
8.
The unit may be used during this time. Off (O) / Stop On ( ...
Operation Manual - Page 11
... to squeeze the throttle control. Then move the choke lever to squeeze the throttle control. The unit may be used during this time. Press and hold the On/Off switch in Position 3, squeeze and hold the throttle control (Fig. 9). Item No. Description
49M2027P966 Electric Starter 49MESCBP966 Engine Starter Bit 49MRBESP966 or 49MRBESY966 Cordless...
Operation Manual - Page 12
...a Bump Head.
A blade in the cutting head shield will make the unit overheat. OPERATION
HOLDING THE TRIMMER WARNING: Always wear eye, hearing, hand, foot and body protection to reduce the risk of ...• Do not trim wet grass or weeds. CAUTION: Do not remove or alter the line cutting blade
assembly. Keep the right arm
slightly bent. • Hold the handle with the right hand. TIPS ...
Operation Manual - Page 13
...the cutting head (Fig. 18).
REPLACING THE TRIMMING LINE
Only use the correct line length when installing trimming line.
Insert the new trimming line into the entry eyelet (Fig. 17). Push
the ...cutting head. Cut one 20 foot (6 m) length of terms and coverage for a complete listing of new trimming line. 3. NOTE: Please read the California/EPA statement that came with the unit for the...
Operation Manual - Page 14
...). NOTE: DO NOT overfill the crankcase. 4. CHECKING THE OIL LEVEL
WARNING: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. Check the oil level before each use a flashlight if necessary. Inspecting the Oil Level Window 1. Adding Oil 1. Refer to the oil fill hole until the tabs securely snap into the oil level...
Operation Manual - Page 15
... on the air filter cover into
a container (Fig. 22). Push the air filter cover back onto the air filter housing. NOTE: Use the empty oil bottle saved from the initial use to prevent debris
from entering the oil fill hole. 2.
Wash the air filter in the air filter housing (Fig. 24). Squeeze...
Operation Manual - Page 16
... adjusting the idle speed should make carburetor adjustments. Remove the spark plug from the spark plug.
2. Grit in . (0.635 mm)
Fig. 26
16 NOTE: If using a torque wrench, torque to turn the idle speed screw clockwise, 1/8 of engine power
MAINTAINING THE SPARK PLUG
1. An authorized service dealer should solve most engine...
Operation Manual - Page 17
... nuts or bolts. Refer to cool before storing. • Lock up the unit to prevent unauthorized use or damage. • Store the unit in a horizontal position. STORAGE
• Never store a ... store the unit vertically with a soft cloth. Reinstall the spark plug.
4. NOTE: Do not use strong detergents. Wipe off any loose or damaged parts.
Reinstall the fuel cap.
2. Remove the spark...
Operation Manual - Page 18
... OR STALLS The fuel is old (over 30 days) The spark plug is fouled
The engine is hot
TROUBLESHOOTING
SOLUTION
Fill the fuel tank with new line Rewind the line Clean the inner reel and outer spool Open the cutting head and remove the welded section Rewind the line Stop the...
Operation Manual - Page 20
...P.O. Damage resulting from the sales. This limited warranty shall not extend to new merchandise purchased and used for rental or commercial purposes, or any other income-producing purpose. HOW...price of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to ...
Similar Questions
Stringing The Weed Eater
how how do you string a troy built tb22 2 cycle weedeater
how how do you string a troy built tb22 2 cycle weedeater
(Posted by Shannonslayman78 2 years ago)
Can You Replace The Bump Feed String Head With A Fixed Line Head?
(Posted by Ibbroman 9 years ago)
Wont Stay Running
my father in law uses my weed eater and it runs fine but as soon as i try to use it it stalls when i...
my father in law uses my weed eater and it runs fine but as soon as i try to use it it stalls when i...
(Posted by mnellammij 10 years ago)