Home » Troy-Bilt » Lawn & Garden » Troy-Bilt TB625

Troy-Bilt TB625 Support Question

Find answers below for this question about Troy-Bilt TB625.
Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by ginac566 on May 1st, 2018

Spark Plug Gap Set

what should the spark plug for. my tb625 ec troy built weed eater be gapped at?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on May 1st, 2018 10:42 AM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

Spark Plug Gap: 020"

Answer #2: Posted by ginac566 on May 3rd, 2018 1:05 AM

ginac566

Member since:
May 1st, 2018

Points: 50

100
points

The operator's manual has .025 listed as the correct gap set.

Related Troy-Bilt TB625 Manual Pages

Operation Manual - Page 1

....troybilt.com (U.S.) or www.troybilt.ca (Canada). Copyright© 2013 MTD SOUTHWEST INC, All Rights Reserved. 01/13 Operator's Manual Electric Start Capable 4-Cycle Trimmer TB625 EC TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17...

Operation Manual - Page 2

...to attract your LOCAL SERVICE DEALER to liability or a fine. Be familiar with a spark arrestor, maintained in containers specifically designed and approved for the storage of ignition for the...in a clean, well-ventilated outdoor area where there are still at a minimum. Check with a spark arrestor. If it returns automatically to relieve any danger. Please keep them outside a 50-foot (...

Operation Manual - Page 3

... best grip. • Make sure the attachment is turned off and disconnect the spark plug for maintenance or repair. • Use only original equipment manufacturer (OEM) replacement parts... 3 Keep a firm grip on the unit: 1. Carefully remove vegetation and other users. Disconnect the spark plug wire. • Secure the unit while transporting. • Never store the unit with a foreign...

Operation Manual - Page 5

... and light weeds. • Edging • Decorative trimming around trees, fences, etc. Shaft Grip ASSEMBLY TOOLS REQUIRED: • 3/8" Socket On/Off Switch Muffler Spark Plug Starter Rope ... Plug Line Cutting Blade SPECIFICATIONS* Engine Type Air-Cooled, 4-Cycle Displacement 30 cc (1.83 cu. in.) Spark Plug Gap 0.025 in. (0.635 mm) Spark Plug Champion® RDZ4H or equivalent plug...

Operation Manual - Page 8

...the oil bottle. Funnel Spout Oil Fill Plug Fig. 7 O-Ring Oil Fill Hole Fig. 8 8 Check the oil level ...before starting the unit. Unscrew the oil fill plug (Fig. 8). 5. OIL AND FUEL USING THE RIGHT OIL Use a.... Wipe up any oil that may have spilled. 7. Reinstall the oil fill plug. Use the bottle to the fuel tank. Failure to use dirty oil. Remove...

Operation Manual - Page 9

... little as 1% water in place. Add 0.8 oz. (23 ml) of fuel additive per gallon of fuel, according to inhibit corrosion and minimize gum deposits. Keep sparks and open flames at least 30 ft. (9.1 m) from the fuel container and the fueling site before filling the fuel tank. Remove the fuel cap. 3. NOTE...

Operation Manual - Page 12

... not remove or alter the line cutting blade assembly. NOTE: Some line breakage will occur from the operator. • Do not trim wet grass or weeds. NOTE: Do not rest the cutting head on bare ground or hard soil. NOTE: Always keep the trimming line fully extended. Keep the left hand...

Operation Manual - Page 13

...These procedures should also be performed by an authorized service dealer. • Check the spark plug condition and gap. If you are of trimming line may not release properly if the line is ...To prevent serious injury, never perform maintenance or repairs while the unit is running. Disconnect the spark plug wire to Changing the Oil. • Have the rocker arm clearance checked by an MTD ...

Operation Manual - Page 14

... the oil level before each use a flashlight if necessary. Set the unit on the oil fill plug (Fig. 21). Unscrew the oil fill plug. 3. Tab Hole Fig. 19 Fig. 20 Oil Fill Plug Oil Fill Hole Maximum Oil Level Fig. 21 Spool Cover ...LEVEL WARNING: OVERFILLING THE CRANKCASE MAY CAUSE SERIOUS PERSONAL INJURY. Reinstall the oil fill plug. Look into the holes. Clean the area around the oil fill...

Operation Manual - Page 15

...air filter cover. Tighten the cover screw to spread and remove excess oil. 6. Unscrew the oil fill plug. 3. Wipe up any oil that may have spilled. 5. MAINTAINING THE AIR FILTER WARNING: To avoid serious...THE OIL Change the oil while the engine is still warm. Clean the area around the oil fill plug (Fig. 21) to prevent debris from the initial use to federal, state and local regulations. 4. ...

Operation Manual - Page 16

...IDLE SPEED WARNING: The cutting head may spin during idle speed adjustments. Remove the spark plug from the spark plug. 2. NOTE: If using a torque wrench, torque to turn the idle speed...spark plug electrodes. Use a feeler gauge to Starting and Stopping. 2. Do not over tighten. 6. NOTE: Careless adjustments can seriously damage the unit. Start the engine. Refer to set the air gap...

Operation Manual - Page 17

... the outside of old fuel according to federal, state and local regulations. 17 Remove the spark plug and drain all fuel has been drained from the cylinder. 2. Refer to cool. Short-term Storage (1-2 ...and allow it to distribute the oil. Wipe off any loose or damaged parts. Remove the spark plug and put 5 drops of the oil from the carburetor. 3. STORAGE • Never store a fueled...

Operation Manual - Page 18

...air filter Drain the fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug Stop the engine and clean the cutting head Refill the cutting head with new line Rewind the ...fresh fuel Press the primer bulb 10 times Drain the fuel tank and add fresh fuel Replace the spark plug Refer to the IF... THE ENGINE IS HOT instructions in the Starting and Stopping section THE ENGINE ...

Operation Manual - Page 20

...set forth in the United States, its option, repair or replace, free of charge, any part found to be defective in Canada, or write to P.O. Damage resulting from state to state. Spark Plugs, Carburetor Adjustments, Filters B. Troy.... Troy-Bilt reserves the right to change or improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care...