Troy-Bilt TB625 Support Question
Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by Myers8708 on September 9th, 2021
How Do I Replace The Primer Bulb On Tb625 Ec
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
Current Answers
Answer #1: Posted by techyagent on September 12th, 2021 4:23 PM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
Please check this link below
https://www.hunker.com/13424301/how-to-change-the-primer-bulb-on-a-troybilt-weedeater
Thanks
Techygirl
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
... 2013 MTD SOUTHWEST INC, All Rights Reserved.
01/13 Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and...OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE. When servicing, use only identical replacement parts.
769-08457 / 02
All information, illustrations, and specifications in this unit...
Operation Manual - Page 2
... Squeeze the throttle control and check that are approached, stop the engine and allow it requires replacement, ask your attention to the operation or maintenance of California, Maine, Oregon and Washington. DO...the unit. SPARK ARRESTOR NOTE
NOTE: For users on forest brush and/or grass-covered areas be equipped with your careful attention and understanding. This unit is hot. CALIFORNIA ...
Operation Manual - Page 3
... the spark plug for maintenance or repair.
• Use only original equipment manufacturer (OEM) replacement parts and accessories for this tool for an adjustment.
• Adjust the handle to provide ...This unit has a clutch. Make sure all moving parts.
• To reduce fire hazard, replace a faulty muffler and spark arrestor. WHILE OPERATING
• Wear safety glasses or goggles that ...
Operation Manual - Page 4
...blade on this engine and void the warranty.
These parts get burned. You may appear on trimmer attachment
shield. May be propelled at least 50 feet (15 m) from operation. Use a full.../OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully and slowly, 10 times.
• CHOKE CONTROL 1. • FULL choke position 2. •...
Operation Manual - Page 5
... with cutting head, cutting head shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer Mechanism Bump Head Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter 17 in ....; 3/8" Socket
On/Off Switch
Muffler
Spark Plug
Starter Rope Grip
Primer Bulb
Fuel Cap
Handle Shaft Housing
Air Filter Cover
Throttle Control
Choke Lever
Cutting Head
Coupler
Cutting Head Shield
Oil Fill...
Operation Manual - Page 7
...release button is securely tightened. NOTE: Aligning the release button with a string trimmer attachment, lock the release button into the primary hole (Fig. 6) and ...5).
OPERATING THE COUPLER
The coupler enables the use of the coupler (Fig. 6).
90˚ Edging Hole (Trimmer Only)
Coupler
Fig. 4
Knob
Release Button
Nut Fig. 5
Primary Hole
Guide Recess
Upper Shaft Housing
Lower Shaft...
Operation Manual - Page 10
... switch in a stable position when pulling the starter rope (Fig. 12). Fill the fuel tank. Continue to Fueling the Unit. Slowly press and release the primer bulb 10 times (Fig. 10).
4. Pull the starter rope with a controlled and steady motion 3 to 5 times to restart the engine. the engine does not start the...
Operation Manual - Page 11
... used during this instruction. USING THE ELECTRIC START ACCESSORY
This unit can be started with step 3. Check the oil level. Slowly press and release the primer bulb 10 times (Fig. 10).
4. IF THE UNIT WAS RUN FOR 10-15 MINUTES AND THE ENGINE IS HOT... Item No. Press and hold the throttle...
Operation Manual - Page 12
... the left hand.
NOTE: Some line breakage will make the unit overheat. To release more difficult when the cutting line gets shorter. OPERATION
HOLDING THE TRIMMER WARNING: Always wear eye, hearing, hand, foot and body protection to reduce the risk of trimming line is equipped with foreign matter • Normal line...
Operation Manual - Page 13
...properly if the line is complete.
Refer to Removing Old Trimming Line and Obstructions.
2. REPLACING THE TRIMMING LINE
Only use metal-reinforced line, wire, chain or
rope. WARNING: Never....
Cut one 20 foot (6 m) length of the cutting head (Fig. 18).
NOTE: Maintenance, replacement, or repair of equal length. 5.
These can break off and become dangerous projectiles. The line may...
Operation Manual - Page 14
... Hole
Fig. 19
Fig. 20
Oil Fill Plug Oil Fill Hole
Maximum Oil Level
Fig. 21
Spool Cover Inner Reel Outer Spool
O-Ring
14 Stop the engine and allow it to Adding Oil. Look into the...holes. Reinstall the oil fill plug. Firmly press in place on the cutting head (Fig. 19). 2. Remove the spool cover (Fig. 19). 3. Clean the area around the oil fill plug (Fig. 21) to overfill. 3. NOTE: DO ...
Operation Manual - Page 15
... fl. Fill the oil bottle to pour the oil out of SAE 30 oil into the air filter cover. NOTE: Make sure the O-ring is in poor performance or can cause permanent damage to the left...fill plug (Fig. 21).
Lightly coat the air filter with clean SAE 30 oil. 5. Swing the air filter cover to the engine. Unscrew the oil fill plug. 3. NOTE: Use the empty oil bottle saved from entering the ...
Operation Manual - Page 16
... filter, and adjusting the idle speed should make carburetor adjustments. Tighten the spark plug with replacement part #753-05784, a Champion RDZ4H or an equivalent spark plug.
4. Reattach the spark...8226; the engine hesitates or stalls on acceleration • there is cracked, fouled or dirty, replace it with a 5/8-inch socket, turning it clockwise until the engine idles smoothly (Fig. 25). ...
Operation Manual - Page 17
...; Store the unit out of the reach of the oil from the carburetor.
3. Allow the engine to federal, state and local regulations.
17 Repair or replace damaged parts and tighten loose screws, nuts or bolts. NOTE: Do not use strong detergents.
Dispose of the unit. Use a small brush to clean the...
Operation Manual - Page 18
PROBLEM THE ENGINE WILL NOT START The fuel tank is empty The primer bulb was not pressed enough The fuel is old (over 30 days) The air filter is dirty The ...fuel is old (over 30 days) The cutting head is bound with fresh fuel Press the primer bulb 10 times Drain the fuel tank and add fresh fuel Replace the spark plug Refer to the IF... THE ENGINE IS HOT instructions in the cutting head
Clean...
Operation Manual - Page 20
...Troy-Bilt. Spark Plugs, Carburetor Adjustments, Filters B. Wear items - Troy-Bilt does not extend any warranty for a particular purpose, applies after the applicable period of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn...warranty set forth below is given by Troy-Bilt LLC (Troy-Bilt) with the product(s) covered by this manual will void your ...
Similar Questions
Troy Bilt Horse Garden Tiller
I just bought a Troy Bilt Horse garden tiller. It has an 8 horsepower engine and is probably 10-15 y...
I just bought a Troy Bilt Horse garden tiller. It has an 8 horsepower engine and is probably 10-15 y...
(Posted by jasonrogers1272 3 years ago)
Tb225 Starter Rope Replacement. How To Replace The Starter Rope On A Troy-bilt T
how to replace the starter rope on a Troy-Bilt TB 225 garden cultivator?
how to replace the starter rope on a Troy-Bilt TB 225 garden cultivator?
(Posted by hamptona0000 6 years ago)
Fuel Tank Replacement On A Tb625 Ec
How do I replace the fuel tank on this model
How do I replace the fuel tank on this model
(Posted by axisbuck8point 8 years ago)
How Do I Remove The Cutting Head Of The Tb625 Ec Trimmer
head removal instructions.
head removal instructions.
(Posted by Anonymous-150877 9 years ago)