Troy-Bilt TB625 Support Question
Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by Anonymous-172522 on September 30th, 2022
Fuel Tank
How do you remove the fuel tank on a troy built TB625EC leaf blower
Current Answers
Answer #1: Posted by Odin on September 30th, 2022 8:45 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by Technoprince123 on September 30th, 2022 11:01 AM
Technoprince123
Member since:
February 8th, 2021 Points: 1,205,190
Member since:
February 8th, 2021 Points: 1,205,190
Please response if this answer is acceptable and solw your problem thanks
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
.... Copyright© 2013 MTD SOUTHWEST INC, All Rights Reserved.
01/13 Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20
SAVE THESE INSTRUCTIONS...
Operation Manual - Page 2
... them outside a 50-foot (15 m) radius, at a minimum. Check for proper accident prevention measures. Take the following precautions:
• Store fuel only in order to others . Never remove the fuel tank cap or add fuel when the engine is factory equipped with the controls and proper use the trimming line described in serious injury to...
Operation Manual - Page 3
...any other debris that meet current ANSI Z87.1 standards and are available from debris. Carefully remove vegetation and other liquid. Inspect the unit for the cause of trouble. Wear a ...unit to an authorized service dealer for its intended purpose.
• Always hold the unit with fuel in the tank, inside a building where
fumes may reach an open flame (pilot lights, etc.) or sparks...
Operation Manual - Page 4
...to operator's manual for the proper type of oil.
• DO NOT USE E85 FUEL IN THIS UNIT
WARNING: It has been proven that may get extremely hot from operation...& INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that fuel containing
greater than 10% ethanol will likely damage this product.
Wear eye protection meeting current ...
Operation Manual - Page 5
...plug Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) Approximate Unit Weight (No fuel, with this unit. Shaft Grip
ASSEMBLY TOOLS REQUIRED: • 3/8" Socket
...On/Off Switch
Muffler
Spark Plug
Starter Rope Grip
Primer Bulb
Fuel Cap
Handle Shaft Housing
Air Filter Cover
Throttle Control
Choke Lever
Cutting Head
Coupler...
Operation Manual - Page 6
... the cutting head shield with this unit.
1. Push the handle down onto the shaft housing (Fig. 3). Use only the instructions that provides the best grip. Remove the wing nut and washer from the end of the shaft grip (Fig. 3).
4. Insert the square bolt into the slot on the mount bracket (Fig...
Operation Manual - Page 7
... counterclockwise to tighten (Fig. 4). Turn the knob clockwise to loosen (Fig. 4). 2.
Removing the Attachment
1. WARNING: Before using any attachment, read and
understand the manual that came with... the attachment. Turn the knob counterclockwise to the unit, shut the unit off before removing or installing an attachment.
WARNING: To avoid serious personal injury and
damage to loosen...
Operation Manual - Page 8
... is in the crankcase. Refer to the fuel tank. Wipe up any oil that may have spilled. 7. Funnel Spout Oil Fill Plug
Fig. 7
O-Ring Oil Fill Hole
Fig. 8
8
Remove the paper seal. Set the unit on ...and failure. Change the oil according to measure the
correct amount of the oil bottle. 2. Remove the cap from the oil bottle. This unit has a four- Oil must be overemphasized. Failure...
Operation Manual - Page 9
... the engine dry before filling the fuel tank.
Definition of Blended Fuels Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol or MTBE (ether). Ignited
vapors may have spilled. 5. Do not smoke while filling the tank. WARNING: Remove the fuel cap slowly to the unit's fuel tank. WARNING: Add fuel in place. NOTE: Do not overfill...
Operation Manual - Page 10
.... Squeeze the throttle control (Fig. 9) and pull the starter rope with step 3. Continue to Fueling the Unit.
the engine does not start after a few attempts, move the choke lever to Position ...a controlled and steady motion 5 times (Fig. 12).
7. Check the oil level. Fill the fuel tank. Refer to squeeze the throttle control. Crouch in a confined area. Continue to Checking the Oil ...
Operation Manual - Page 11
...Level.
2. Continue to Position 2 (Fig. 11).
9. Move the choke lever to squeeze the throttle control. Remove the electric start . Run the electric start accessory in the ON ( I ) position at all times (Fig...to Position 2, and run the unit for 2-5 minutes, or as needed . Fill the fuel tank. Run the electric start accessory in the OFF (O) position until the unit starts.
10....
Operation Manual - Page 12
...
Fig. 15
Bump Knob
Fig. 16 Line release
becomes more line, lightly tap the bump knob on bare ground or hard soil. CAUTION: Do not remove or alter the line cutting blade
assembly. This may stall the engine. TIPS FOR BEST TRIMMING RESULTS • Keep the cutting head parallel to the...
Operation Manual - Page 13
... devices and system may not release properly if the line is too long.
If necessary, remove any seasonal tune-up.
Installing New Trimming Line
1. Turn the bump knob counterclockwise to overheat...Plug. Insert the new trimming line into the entry eyelet (Fig. 17). Refer to Removing Old Trimming Line and Obstructions.
2. MAINTENANCE
WARNING: To prevent serious injury, never perform
...
Operation Manual - Page 14
...Check the oil level before each use a flashlight if necessary. Unscrew the oil fill plug. 3.
Remove the spool cover (Fig. 19). 3. The oil level should hang over the edge so that ... cutting head shield should fill the window approximately halfway (Fig. 21). Look into the holes.
Remove any old trimming line and/or obstructions. 4. Align the tabs on the spool cover with the...
Operation Manual - Page 15
...is not covered by the product warranty. Rinse the air filter
thoroughly and allow it to spread and remove excess oil. 6. Squeeze the air filter to dry. 4. Swing the air filter cover to prevent ... on the oil fill plug (Fig. 21). Allow ample time for complete drainage. Cleaning the Air Filter
1. Remove the air filter from the air filter housing (Fig. 24).
2. NOTE: Dispose of the bottle (Fig. ...
Operation Manual - Page 16
...Grasp the spark plug boot firmly and pull it clockwise until the engine idles smoothly (Fig. 25). 3. Remove the spark plug from the spark plug.
2. NOTE: If using a torque wrench, torque to a ... and Stopping. 2.
NOTE: Careless adjustments can seriously damage the unit. If, after checking the fuel and cleaning the air filter, the engine still will not idle • the engine hesitates or...
Operation Manual - Page 17
...8226; Allow the engine to cool before cleaning or maintaining the unit. Long-term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into the cylinder. Start the engine and allow it to cool before storing. • ... it for any loose or damaged parts.
Short-term Storage (1-2 weeks)
1. Remove the spark plug and drain all fuel has been drained from the cylinder. 2.
Operation Manual - Page 18
...fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug
Stop the engine and clean the cutting head Refill the cutting head with new line Rewind the line Clean the inner reel and outer spool Open the cutting head and remove...
SOLUTION
Fill the fuel tank with fresh fuel Press the primer bulb 10 times Drain the fuel tank and add fresh fuel Replace the spark plug...
Operation Manual - Page 20
... purpose. To locate the dealer in your warranty as mentioned above, given by Troy-Bilt for whom it was purchased as identified. Troy-Bilt reserves the right to modify any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for products sold...
Similar Questions
Different Fuel Tank Than Is Shown In You Tube
My TB2BP EC has some different installion than the one shown on the video. It appears I have to remo...
My TB2BP EC has some different installion than the one shown on the video. It appears I have to remo...
(Posted by e2551 1 year ago)
Size Of Driver To Remove Bottom Cover, Troy Squall 2100
cant rell what size is needed to remove bottom cover
cant rell what size is needed to remove bottom cover
(Posted by fishcourt308 7 years ago)
Fuel Tank Replacement On A Tb625 Ec
How do I replace the fuel tank on this model
How do I replace the fuel tank on this model
(Posted by axisbuck8point 8 years ago)
How Do Reinstall The Pull Clutch Unit On This Type Troy Built Unit Tb625
Ho
Ho
(Posted by costel36 9 years ago)
How To Remove Full String Head From Tb625ec
I need to remove the complete string head, how do I do it?
I need to remove the complete string head, how do I do it?
(Posted by denniscmalinowski 9 years ago)