Troy-Bilt TB6044 XP Support Question
Troy-Bilt TB6044 XP Support Question
Find answers below for this question about Troy-Bilt TB6044 XP.Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!
Question posted by woodssrjoe74 on August 8th, 2022
Where Do The Fuel Lines Go On The Primer Bulb?
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Troy-Bilt TB6044 XP Manual Pages
Operation Manual - Page 1
Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB6044 XP
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20
SAVE THESE INSTRUCTIONS
SERVICE
DO NOT RETURN THIS UNIT ...
Operation Manual - Page 2
...covered areas be equipped with loose or damaged parts.
• Only use the trimming line described in place and secure. Check with the controls and proper use . Failure to ...m) radius, at a minimum. Check for later use metal-reinforced line, wire, chain or rope. These can explode if ignited.
Always loosen the fuel tank cap slowly to relieve any bystanders. Operate this manual. SAFETY...
Operation Manual - Page 3
...boots, gloves and a long sleeve shirt. Do not operate the unit with both trimming lines extended and the proper line installed. These are marked as such. Keep the engine and muffler free from operation,... them often and use or damage. Use of children. • Never douse or squirt the unit with fuel in the tank, inside a building where
fumes may reach an open flame (pilot lights, etc.) or...
Operation Manual - Page 4
... operating this product. Use a full face shield when needed.
• UNLEADED FUEL Always use clean, fresh unleaded fuel.
• OIL Refer to operator's manual for complete safety, assembly, operating ...do not touch the line cutting blade.
4 SYMBOL MEANING
• ON/OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully and slowly...
Operation Manual - Page 5
...
Air Filter Cover
Throttle Control
Starter Rope Grip
Primer Bulb
Fuel Cap
Cold Weather Start Lever
Cutting Head
Coupler
Cutting Head Shield
Oil Fill Plug
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, ...head shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer Mechanism Bump Head Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter 18 in . (0.635 mm) Spark Plug...
Operation Manual - Page 8
... cause premature engine wear and failure. Failure to use clean oil of API (American Petroleum Institute) service class SJ. Change the oil according to the fuel tank. Unscrew the top of oil. 1. Pour the entire bottle into the oil fill hole (Fig. 7). NOTE: Never add oil directly to the Maintenance Schedule...
Operation Manual - Page 9
... to the instructions on the fuel tank
and fill the tank. Reinstall the fuel cap. 6. Using Fuel Additives Use a fuel additive, such as ethanol, methanol or MTBE (ether). Wipe up . 2. WARNING: Add fuel in a clean, well ventilated outdoor
area. Remove the fuel cap. 3. Definition of Blended Fuels Today's fuels are often a blend of fuel, according to avoid injury
from...
Operation Manual - Page 10
...to the Open position (Fig. 10).
6.
Fig. 8
Throttle Control
Fig. 9
Primer Bulb
Open
Closed
Cold Weather Start Lever
STOPPING INSTRUCTIONS
1. Crouch in the starting the unit....IF...
Fill the fuel tank.
the engine stops while the throttle control is visible.
4. If fuel cannot be lethal in the primer bulb, press and release the primer bulb until
the engine comes...
Operation Manual - Page 11
Refer to idle. 2. Refer to the Closed position (Fig. 10). DO NOT squeeze the throttle control. The unit may be seen in the primer bulb, press and release the primer bulb until fuel is in the starting procedure with step 4. IF THE ENGINE IS HOT...
In cold weather (below 40°F), move the cold weather start...
Operation Manual - Page 12
...Fig. 13). • Hold the shaft grip with foreign matter • Normal line fatigue • Attempting to cut the line to the ground (Fig. 15).
This improves the unit's
cutting efficiency and throws...HOLDING THE TRIMMER
WARNING: Always wear eye, hearing, hand, foot and
body protection to release line in tall grass may lead to serious personal injury or damage to the ground so that the...
Operation Manual - Page 13
...for the emissions control devices, such as the spark arrestor, muffler, carburetor, etc. Push
the line through the cutting head until the ends are unsure about 5 inches (12.7 cm) protrude from ...Specifications section. These can break off and become dangerous projectiles.
Insert the new trimming line into the entry eyelet (Fig. 16).
MAINTENANCE
WARNING: To prevent serious injury, ...
Operation Manual - Page 14
Remove any old trimming line and/or obstructions from entering the oil fill hole. 2. CHECKING THE OIL LEVEL
WARNING: OVERFILLING ...;
Add oil to overfill. 3. NOTE: Make sure the O-ring is level (Fig. 19). Removing Old Trimming Line and Obstructions If necessary, remove any old trimming line and/or obstructions. 4. Use a clean cloth to cool. 2. Set the unit on the outer
spool (Fig....
Operation Manual - Page 15
... of oil. Push the air filter cover back onto the air filter housing. Fig. 21
Fill Line
Fig. 22
Hole
Air Filter Housing
Tab
Air Filter Cover
Air Filter
Fig. 23
Cover Screw
15... Tip the unit vertically to cool before cleaning or maintaining the unit. oz (60 ml) fill line indicated on the air filter cover into
a container (Fig. 21).
Wash the air filter in the air ...
Operation Manual - Page 16
...5/8-inch socket, turning it with a 5/8-inch socket, turning counterclockwise. If, after checking the fuel and cleaning the air filter, the engine still will not idle • the engine hesitates ...mm) (Fig. 25).
5. NOTE: If using a torque wrench, torque to cool. Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. Remove the spark plug...
Operation Manual - Page 17
...always stop
the engine and allow it to run until it stalls.
Remove the fuel cap, tip the unit and drain the fuel into the cylinder. Start the engine and allow it to cool before storing. ...for more than 30 days. NOTE: Do not use strong detergents. Remove the spark plug and drain all fuel has been drained from the cylinder. 2. Wipe off any loose or damaged parts. Change the oil. Dispose...
Operation Manual - Page 18
...is in the closed position
SOLUTION
Fill the fuel tank with fresh fuel Press the primer bulb 10 times or until fuel is visible Drain the fuel tank and add fresh fuel Replace the spark plug Move the cold ...head is dirty The line is welded The line is twisted
Not enough line is extended
Stop the engine and clean the cutting head Refill the cutting head with new line Rewind the line Clean the inner ...
Operation Manual - Page 20
...is limited to ninety (90) days from state to state. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars,
Cultivator Tines... design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily...
Parts Diagram - Page 1
REPLACEMENT PARTS - MODEL TB6044 XP
4-CYCLE TRIMMER
PPN 41ADZ6PC766
46... 746-05053
769-08524 / 01
Description Top Housing Assembly Air Purge Primer Top Cover Gasket Screw Starter Housing Assembly Screw Electric Start Adapter O-Ring...Screw Aircleaner Assembly Screw Screw Carburetor Assembly O-Ring Aircleaner Spacer Screw Fuel Tank Assembly Fuel Tank Pad Lead Wire Thottle Cable
Item 27 28 29 30...
Parts Diagram - Page 2
MODEL TB6044 XP
4-CYCLE GAS TRIMMER
PPN 41ADZ6PC766
Item Part No.
REPLACEMENT PARTS - Description
1 753-06887 Throttle Housing Assembly (includes 2 - 5)
2 791-182405 Switch Assembly
3 753-05171 Throttle Lock-...
Similar Questions
How To Replace Primer Bulb Lines On Tb675ec With A Two Port Primer
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
(Posted by dsnyder488 8 months ago)
My Tb6044xp Primer Bulb Has 3 Nipples, Not Two. I Am Looking For A Fuel Linev D
I am looking for a diagram for the fuel lines. I was given this TB6044XP with no fuel lines. I have ...
I am looking for a diagram for the fuel lines. I was given this TB6044XP with no fuel lines. I have ...
(Posted by dchila22 2 years ago)
How Do I Replace The Primer Bulb On Tb625 Ec
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
(Posted by Myers8708 2 years ago)
Fuel Lines For Tb6044xp
I think I have fuel lines going to the wrong nipples on the primer bulb. It is a three nipple bulb. ...
I think I have fuel lines going to the wrong nipples on the primer bulb. It is a three nipple bulb. ...
(Posted by memeishere 3 years ago)