Troy-Bilt TB30 Support Question
Troy-Bilt TB30 Support Question
Find answers below for this question about Troy-Bilt TB30.Need a Troy-Bilt TB30 manual? We have 1 online manual for this item!
Question posted by jimshoe523789 on September 8th, 2015
Safety Switch Locations
The engine won't start so I'm checking the safety switches. Also, where are specific ground wires that are connected to the frame located. That's about, other than that I have no idea why it won't start.
Current Answers
Answer #1: Posted by Odin on September 8th, 2015 12:44 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,660
Member since:
April 10th, 2010 Points: 41,236,660
Consider the suggestions at http://www.repairclinic.com/RepairHelp/How-To-Fix-A-Lawn-Mower/79---/Lawn-mower-won-t-start. Good luck!
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Troy-Bilt TB30 Manual Pages
Operation Manual - Page 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Lawn Tractor - 26J Mini-Rider
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Printed In USA
TROY-BILT LLC, P.O.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS...
Operation Manual - Page 2
... specifications for various models. If you have any other persons who will be applicable to operating the equipment. This information will operate the machine, carefully follow the recommended safety practices at the time of the machine are observed from the operating position
The engine manufacturer is relative to ensure your new equipment, please locate...
Operation Manual - Page 3
... not followed,
could result in movable parts. Engine Exhaust, some of its
proper place.
11....toward the operator.
3. Do not operate the mower
anyone . future and regular reference and for
...wire, bones, toys, and other reproductive harm. Remove all controls and their proper operation.
Failure to observe the following safety instructions could endanger the personal safety...
Operation Manual - Page 4
...of riding mower-related
injuries.... Contact your safety, use on...- backing to start engine.
1.
Disengage blade(s), set parking
brake, stop engine and wait ... stability. the ground.
27.
Do... hanging tree branches, wires, door openings etc.,...slopes slow and gradual. Check overhead clearances carefully before ...starting or stopping on wet grass.
loaded dump cart, lawn...
Operation Manual - Page 5
...Replace gasoline cap and tighten securely. Wait 5 minutes before starting .
h. Children 14 and over should read and understand the... on towed equipment.
4. a. If this manual and on mower). f. Allow engine to cool at all times until fueling is not alert to... minutes before filling.
Disconnect the spark plug wire and ground against the engine to cool at the hitch point.
2....
Operation Manual - Page 6
.... According to complete stop the engine, disconnect the spark plug wire(s) and ground against the engine. Environmental Protection Agency (EPA), ...engine governor settings or over-speed the engine. Maintain or replace safety and instruction labels, as required.
5. After striking a foreign object, stop within the this time frame, your model.
7. For safety protection, frequently check...
Operation Manual - Page 7
...on this machine on the machine before attempting to assemble and operate
DANGER- HOT SURFACE Engine parts, especially the muffler, become extremely hot during operation. Symbol
Description
READ THE OPERATOR... on a slope greater than 12 degrees. WARNING- Safety Symbols
This page depicts and describes safety symbols that may pick up and throw and objects which can cause serious personal...
Operation Manual - Page 10
...; One Seat Assembly
• One Steering Wheel/Shaft Assembly • One Rear Engine Cover
• One Rear Hitch Plate
• One Oil Drain Sleeve
• One Riding Mower Operator's Manual
• One Steering Pedestal Cap
• One Engine Operator's Manual
• One Hardware Pack
• One Discharge Chute Assembly • One Mulch Plug...
Operation Manual - Page 12
... the seat. The small tab on the deck lip area will not start without either the mulch plug or deck chute installed.
1. Installing The Deck Chute
WARNING! The engine will fit through the holes on the bottom of mulch plug is depressing the safety switch located on the mowing deck and retain for later installation.
2. 6.
Operation Manual - Page 13
...located on the rear engine cover mounting bracket. Figure 3-10
3.
Installing the Hitch Plate
1. Position the hitch plate, packed with the loose parts, with the two hex screws previously removed.
Install the rear engine cover by the NEGATIVE (Black) wire. CAUTION: When attaching battery cables, always connect the POSITIVE (Red) wire... plate mounting hardware located on the rear ...
Operation Manual - Page 15
...
Fuel Level Indicator Ignition Switch Module
Throttle/Choke Lever
4
Speed Control & Parking Brake Lever
Shift Lever Fuel Fill Cap
Cup Holder
Deck Lift Lever
Oil Fill Cap
PTO (Blade Engage) Lever
Figure 4-1
Lawn Tractor controls and features are illustrated in personal injury.
15 Failure to comply with all safety rules and instructions in...
Operation Manual - Page 16
... engine, turn clockwise to both Safety Interlock Switches and Starting The Engine in the Operation section of this manual for detailed starting instructions.
Controls & Features To start the engine. Never leave a running board. IMPORTANT: Prior to operating the tractor, refer to the START position.
Activating the choke control closes the choke plate on the left side of the lawn...
Operation Manual - Page 17
... (PTO OFF) position when starting the engine. When a desired speed has...located on checking and adding oil to this tractor. It has three positions, FORWARD, NEUTRAL and REVERSE. Use this window to engage.
Refer to the Set-up section in the notch best suited for instructions on the right side of the tractor's steering console, allows you to regulate the ground...lawn tractor.
Operation Manual - Page 18
...Refer to the Assembly & Set-Up section of this unit with a safety interlock system for longer than 12 degrees.
After the engine starts, release the key. Use low speed. • Do not operate machine... and oil fill-up and down into the ignition switch module.
2.
Operation
5
WARNING
Avoid Serious Injury or Death • Know location and function of all the way forward into the ...
Operation Manual - Page 19
... backing up to a stop the engine, disconnect the spark plug wire and ground against the engine. IMPORTANT: Do NOT use the ...move the speed control lever out of the key switch module. The lawn tractor is not recommended. Release clutch-brake pedal... change the direction of the key switch module allows the tractor to prevent unintended starting.
WARNING! Release clutch-brake pedal slowly...
Operation Manual - Page 20
...it may be in the disengaged (OFF) position when starting the engine, when traveling in reverse with the discharge thrown towards the...materials toward the operator.
• Do not mow at high ground speed, especially if a mulch kit or grass collector is ...give a better appearance to the lawn.
• Do not cut .
• Do NOT attempt to Safety Interlock Switches in operation. Engaging the PTO...
Operation Manual - Page 24
...conditions.
Never store lawn tractor with treated fuel and run the engine until all fuel in safe location.
• Reconnect the fuel line and run the engine for approved disposal...store next to keep the engine running until it starts to falter, then use a pressure washer or garden hose to clean your local authorities for 2-3 minutes to the engine with a stabilizer to ...
Operation Manual - Page 28
... (i.e. WARNING! Jump Starting
WARNING! Connect the second cable (negative -) to expose its underside. car, truck), do not touch, and ignitions are off an explosive gas while charging. Charging
WARNING! Replace immediately if damaged. It is not automatic, charge for replacement. Never jump start the vehicle's engine when jump starting your tractor's wiring harness located just above the...
Operation Manual - Page 30
...Mower will not mulch grass
1. Cutting blade loose or unbalanced. 2.
Crank engine...3. Connect wire to...start
Cause
1. PTO/Blade engaged
2. Fuel tank empty, or stale fuel
Engine runs erratic
4. Engine flooded 8. Spark plug wires loose. 3.
Dirty air cleaner. Uneven tire pressure. Place the throttle control in FAST (rabbit) position.
2. Replace fuse(s)
7. Check...
Operation Manual - Page 37
...use of export distribution. To locate the dealer in the following...This limited warranty gives you specific legal rights, and you....com.
Attachments - Check your warranty as mentioned...substitute or replacement lawn care services or ... warranty.
g. Alteration of safety features of the product sold...replace a warranted product. The engine or component parts thereof. KITCHENER...
Similar Questions
Troy Built Riding Mower Turn Key And It Clicks Starter Motor Not Seized ?do
Mower tb30 b Turn key and clicks starter not siezed
Mower tb30 b Turn key and clicks starter not siezed
(Posted by rusthumphrey 1 year ago)
Won't Start. We Have Rear Bagger We Installed And Think It Could Be Safety Swi
how do we install rear bagger to engage safety switch
how do we install rear bagger to engage safety switch
(Posted by Lmcgeown 2 years ago)
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
Where Is The Chute Safety Switch Located And How Can I Reset? Is There A Way To
bypass this switch?
bypass this switch?
(Posted by rreyes42 8 years ago)
Lawn Mower
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
What kind of oil do I use in my troy bilt 140cc 110b push behind mower is it ok to use 10w30
(Posted by sgilbert491974 9 years ago)