Troy-Bilt TB22 Support Question
Troy-Bilt TB22 Support Question
Find answers below for this question about Troy-Bilt TB22.Need a Troy-Bilt TB22 manual? We have 1 online manual for this item!
Question posted by CNeum19579 on May 15th, 2014
Blue Lever
I Need the part number for the blue lever and installation instructions.
Current Answers
Related Troy-Bilt TB22 Manual Pages
Operation Manual - Page 1
...? IF engine fails to start engine. Page 7
19 Crouch in starting
and troubleshooting information
Choke Lever
Choke Lever
Español -
Run unit for ALL further steps.
5 X
11 Pull rope 5 times.
For single line installation or replacement spool installation instructions, refer to squeeze throttle.
The split wall will divide the line. Place the spring inside...
Operation Manual - Page 2
...OPERATOR AND/OR BYSTANDERS.
• IMPORTANT SAFETY INSTRUCTIONS •
CALIFORNIA PROPOSITION 65
WARNING: Engine exhaust, some of its vapors can be installed properly before operating the unit. • ... This unit has a clutch. Always keep all moving parts. Use a full face shield when needed for a short time.
• SHARP BLADE
WARNING: Sharp blade on steep slopes or inclines...
Operation Manual - Page 3
...: • 3/8" Socket
KNOW YOUR UNIT
Muffler
Spark Plug
Starter Rope Grip
Choke Lever
ASSEMBLY INSTRUCTIONS
OPERATING THE COUPLER The coupler enables the use is securely tightened. Insert the short...Shaft Housing
Primer Bulb
Cutting Head Shield
Line Cutting Blade
Cutting Head
ASSEMBLY INSTRUCTIONS
INSTALLING THE CUTTING HEAD SHIELD
WARNING: To prevent serious personal injury, never ...
Operation Manual - Page 4
... Start Bit operator's manual.
6. If
not, repeat. If the engine is no need to do the cutting, especially along walls. NOTE: This Unit Can Use an Electric...10. NOTE: Some maintenance procedures may stall. Choke Lever
6. Continue squeezing the throttle control, move the blue choker lever to -side motion.
See Oil and Fuel Mixing Instructions.
2. If fuel cannot be performed by removing ...
Operation Manual - Page 5
...025 in the middle.
2. Use a feeler gauge to Starting and Stopping Instructions. Tighten the bump knob
Eyelets
securely.
Installing the Inner Reel. Insert the two 6-inch sections into place (Fig. ... the line tightly in the direction indicated will not idle, adjust the idle speed screw as needed ), to the unit.
2. Lock Tab
2. Check the indexing teeth and holding slots (Fig...
Operation Manual - Page 6
... the engine and clean the cutting head Clean or replace the air filter
ENGINE LACKS POWER OR STALLS The fuel is visible With the choke lever in . (43.18 cm)
* All specifications are sold separately. oz. (296 ml) Approximate Unit Weight (No fuel, with the engine at the time of the...
Similar Questions
Replace The Fuel Filter
I would like to replace the fuel filter but I cannot find the part number. Troy-Bilt TB22
I would like to replace the fuel filter but I cannot find the part number. Troy-Bilt TB22
(Posted by msanclimenti 2 years ago)
Stringing The Weed Eater
how how do you string a troy built tb22 2 cycle weedeater
how how do you string a troy built tb22 2 cycle weedeater
(Posted by Shannonslayman78 2 years ago)
My Pony Tiller Is Lacking In Tilling The Soil When Engaging The Lever
(Posted by Anonymous-166012 4 years ago)
Tb22 Ec Wont Start
Have a brand new TB22 EC. Can't start it manually so went and bought the electric starter (49M2027P9...
Have a brand new TB22 EC. Can't start it manually so went and bought the electric starter (49M2027P9...
(Posted by cpsoto1227 8 years ago)