Stihl MS 171 Support Question
Stihl MS 171 Support Question
Find answers below for this question about Stihl MS 171.Need a Stihl MS 171 manual? We have 2 online manuals for this item!
Question posted by lipto56 on September 14th, 2022
Stihl Ms171 Starts Fine But Bogs When You Give It Throttle
if I choke it with my thumb over the carb it will Rev up.
Current Answers
Answer #1: Posted by hzplj9 on September 14th, 2022 12:31 PM
hzplj9
Member since:
June 25th, 2012 Points: 4,875,670
Member since:
June 25th, 2012 Points: 4,875,670
This article refers to a weed eater but the rules still apply to the carb on a chainsaw.
https://www.hunker.com/13404548/how-to-adjust-the-carburetor-on-a-weed-eater
Try it and see if it helps.
Answer #2: Posted by SonuKumar on September 14th, 2022 8:16 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,651,140
Member since:
May 9th, 2021 Points: 16,651,140
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Stihl MS 171 Manual Pages
Product Instruction Manual - Page 3
...31
Filling Chain Oil Tank
31
Checking Chain Lubrication
32
Chain Brake
32
Winter Operation
33
Starting / Stopping the Engine
34
Operating Instructions
38
Taking Care of personal injury. Contents
English... use may cause serious or even fatal injury.
{
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
1
© ANDREAS STIHL AG & Co. To receive maximum performance and satisfaction from your...
Product Instruction Manual - Page 8
Check for tightness. Toolless cap with the raised positioning
6
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
Left: Right:
Base of fuel spillage and fire from handling, ..., twist the cap clockwise, closing it to get fuel on your authorized STIHL dealer for repair.
001BA227 KN
001BA226 KN
001BA220 KN
To do not start or run the engine until the leak is upright at least 10 feet ...
Product Instruction Manual - Page 9
... and properly control your Instruction Manual for additional information. Warning!
STIHL Oilomatic chain, guide bar and sprocket must match each other similar...and operation before starting, particularly the throttle trigger, throttle trigger lockout, stop switch and cutting tool. it is extremely important.
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
7
Before Starting
Take off the...
Product Instruction Manual - Page 10
... blip the throttle trigger, which will be fast enough for starting your chain saw... around the handles.
8
MS 171, MS 181, MS 181 C, MS 211, MS 211 C With your right...start .
During Operation
Holding and Controlling the Power Tool
Always hold the unit firmly with both hands on the handles while you cannot set the correct idle speed, have your STIHL dealer check your fingers and thumbs...
Product Instruction Manual - Page 12
...starting. Your chain saw when reaching the end of the cutting attachment whenever the engine is clear of a cut or kerf, go out of EPA / OSHA / NIOSH and occupational and trade associations with a properly sharpened chain (which produces wood chips rather than fine... encountered.
10
MS 171, MS 181, MS 181 C, MS 211, MS 211 C This includes wood dust, especially from hardwoods, but also from...
Product Instruction Manual - Page 13
.... Do not operate your power tool using the starting throttle lock, as to whether the antivibration elements should always...throttle is depressed for more than a few seconds when the chain is pinched in overheating and damage to slip continuously. MS 171, MS 181, MS 181 C, MS 211, MS...of fire and burn injury.
Never modify your STIHL servicing dealer only.
Warning! When sawing, make ...
Product Instruction Manual - Page 18
...to pinch the top of the guide bar nose at full throttle.
7. Use extreme caution when cutting small size brush and ...cut limbs with the nose of the guide bar contact any STIHL chain saw control. Hold the chain saw chain properly. Never... cut because the chain can pinch.
16
MS 171, MS 181, MS 181 C, MS 211, MS 211 C Pull-in the wood.
Warning! Always start a cut more than one log at a...
Product Instruction Manual - Page 23
...to the tree at an angle.
Bucking
Bucking is an extreme danger of kickback at full throttle, insert the guide bar in the illustration. With the saw at this point.
Seek the ... There is cutting a log into sections.
001BA033 KN
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
21 Always keep to the side of a professional. When the tree starts to fall completely, set the saw aside and pull ...
Product Instruction Manual - Page 24
...of pinching!
Always start relieving cut (1)...When cutting small logs, place log through "V"-shaped supports on saw . MS 171, MS 181, MS 181 C, MS 211, MS 211 C Make sure the log will not roll downhill.
Never permit... and systems may deny coverage.
001BA151 KN
Warning!
2
Use only identical STIHL replacement parts for rolling logs. Shattered wood should work performed by any nonroad...
Product Instruction Manual - Page 26
The drive link gauge (2) of the saw chains and chain sprockets.
start at the bar nose.
143BA003 KN
001BA186 KN
24
MS 171, MS 181, MS 181 C, MS 211, MS 211 C The cutting attachment that comes standard is the only manufacturer in the ...
001BA185 KN
533BA001 KN
Disengage the chain brake.
English
Cutting Attachment
STIHL is designed to protect your hands from the sharp cutters.
Product Instruction Manual - Page 35
...MS 211 only: When the cover plate is very cold, start...If your STIHL servicing ...throttle for Easy2Start models)
2
2
1
N Place the cover plate (1) in position and secure it has been properly maintained and the hand guard has not been modified in either the winter or summer positions. Accelerate up to avoid engine running problems and overheating. MS 171, MS 181, MS 181 C, MS 211, MS...
Product Instruction Manual - Page 36
.... even if the bulb is already filled with Easy2Start
This machine is extremely simple and easy to choke closed (l)
- English
Starting / Stopping the Engine
Versions with fuel:
34
MS 171, MS 181, MS 181 C, MS 211, MS 211 C after starting throttle position (n). the ignition is warm, i.e. Starting throttle n - this position is used to the machine
- now set the Master Control lever...
Product Instruction Manual - Page 38
... pull the throttle trigger at ...Choke shutter closed (l) -
Set Master Control lever (3) to its full length - or -
Guide it might otherwise break. N Hold and start the saw. Bystanders must be a delay of the saw. N Press down the handle while cranking. English
Versions with Easy2Start
The Easy2Start stores the energy required to start your saw as described.
36
MS 171, MS 181, MS...
Product Instruction Manual - Page 39
... Master Control lever from the choke shutter closed position (l) to the starting throttle position (n ). N Move the Master Control lever to the stop position (0). see "Spark Plug". N Crank the engine several times with the chain brake engaged (chain locked) will quickly damage the clutch and chain brake.
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
37 When the...
Product Instruction Manual - Page 44
...engine oil in the gasoline), a dirty air filter and unfavorable running conditions, e.g. operating at part throttle etc.) affect the condition of the approved range.
A
N Clean dirty spark plug.
N Unscrew the spark plug.
42
MS 171, MS 181, MS 181 C, MS 211, MS 211 C no further than stop. see "Specifications". N Check electrode gap (A) and
readjust if necessary - Spark...
Product Instruction Manual - Page 62
...STIHL Incorporated may deny you retain all scheduled maintenance.
Original STIHL parts can be hoses, and connectors and other emission-related assemblies. Your emission control system includes parts such as a
60
MS 171, MS 181, MS 181 C, MS 211, MS...covering maintenance on your small offroad equipment engine, but STIHL Incorporated cannot deny warranty solely for the performance of sale...
User Guide - Page 23
... oil, chips, fine particles of abrasion, etc.) and smoothing of the friction surfaces of the brake band and clutch drum impair the coefficient of the chain braking time, i.e. Start the engine
- the...braking time is open the throttle wide for a brief period (max. 3 seconds) -
Remove and inspect the cover (1), service or replace if necessary.
22
MS 171, MS 181, MS 211 the chain must ...
User Guide - Page 79
...
2
firmly.
: Coat the diaphragm (1) with fuel and fit it so that it matches the contour of fatigue, i.e. Check that the shoulder (arrow) points towards the throttle shutter.
78
MS 171, MS 181, MS 211
User Guide - Page 83
... shaft a little and pull out the throttle shutter (1).
3 1
533RA346 TG
533RA349 TG
1 2
: Remove the screw (arrow).
1
- Remove the torsion spring (1). : Remove the E-clip (arrow).
533RA345 TG
533RA347 TG
- Close the choke shutter (2) and center it moderately.
- Reassemble all other parts in the reverse sequence.
82
MS 171, MS 181, MS 211 Relieve tension of movement.
: Remove...
User Guide - Page 85
...spring.
: Push the lever (1), shoulder (arrow) first, onto the throttle shaft.
533RA359 TG
1
2 : The torsion spring on the choke
shaft must be possible to lift
lever (2) far enough for lever ...(1).
533RA361 TG
1
: Turn the lever (1) clockwise until its leg locates on the throttle shaft.
84
MS 171, MS 181, MS 211 it in the carburetor body.
- Coat screw with the small hole in the ...
Similar Questions
Fs 250 Trimmer Starting Problem
trimmer was running cut out.starts bogs out.did the carb repair kit and changed the exhaust.does the...
trimmer was running cut out.starts bogs out.did the carb repair kit and changed the exhaust.does the...
(Posted by celiaseep1 6 years ago)
Stihl Hs 54c Gas Powered Hedge Trimmers Runs Great Until You Turn It Sideways
My STIHL HS- 56 -C starts and runs like a champ but when you tip it sideways or nose down it will st...
My STIHL HS- 56 -C starts and runs like a champ but when you tip it sideways or nose down it will st...
(Posted by Travintrxas 8 years ago)
Trigger Won't Engage?
Hello. Starts fine and idles but when I squeeze the trigger, nothing happens. It's like it's not con...
Hello. Starts fine and idles but when I squeeze the trigger, nothing happens. It's like it's not con...
(Posted by newyorkyankees 9 years ago)