Stihl MS 362 C-M Support Question
Stihl MS 362 C-M Support Question
Find answers below for this question about Stihl MS 362 C-M.Need a Stihl MS 362 C-M manual? We have 1 online manual for this item!
Question posted by Travintrxas on November 20th, 2015
Stihl Hs 54c Gas Powered Hedge Trimmers Runs Great Until You Turn It Sideways
My STIHL HS- 56 -C starts and runs like a champ but when you tip it sideways or nose down it will start to bog down and you have to level it up and it clear up and runs great again I would appreciate any help with this little hiccup tha
Current Answers
Answer #1: Posted by TommyKervz on November 20th, 2015 3:54 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,783
Member since:
January 10th, 2013 Points: 17,776,783
This can occur when the trimmer head is not bumped often enough and it becomes too short for centrifugal force to advance the line. When advancing trimmer line be sure to do so at wide open throttle. Please see your local authorized STIHL servicing Dealer for further assistance.
Answer #2: Posted by smmyb123 on February 2nd, 2016 5:57 PM
smmyb123
Member since:
January 30th, 2016 Points: 1,510
Member since:
January 30th, 2016 Points: 1,510
Related Stihl MS 362 C-M Manual Pages
Product Instruction Manual - Page 5
...STIHL chain saws. Be sure that are fatigued. Use your power tool without the instruction manual.
Safe use of a chain saw involves
1 the operator
2 the power tool
3 the use this power...the influence of any power tool can be dangerous.
Have your power tool run unattended. When it ... parts of Federal Regulations 1910.266. Warning!
MS 362
3
To reduce the risk of injury to ...
Product Instruction Manual - Page 6
... disease are recommended for those persons using power tools on some pacemakers. MS 362 A dull chain will increase cutting time,.... Chain saw chain sharp. Most STIHL power tools are mentioned as high vibration levels and long periods of vibrations created...parts of the above shoulder level. English
These conditions reduce the hand's ability to help protect your legs from contact...
Product Instruction Manual - Page 7
...MS 362
5
THE POWER TOOL
For illustrations and definitions of doubt, have it is an extremely flammable fuel. Do not continue operating this power... power ...help to hear warnings (shouts, alarms, etc.) is subjected to cool before transporting the power...your power tool...STIHL recommends that
Warning! Note that the controls and safety devices are authorized. It may escape from escaping gas...
Product Instruction Manual - Page 8
...If your cap still does not tighten properly, it will go (approx. 1/4 turn ).
In order to the closed position (with open space)
Base of cap ...MS 362
Warning! Misaligned, damaged or broken cap
N If the cap does not drop fully into the tank opening , the cap is fixed and any spilled fuel before starting your machine.
If the grip does not lie completely flush with this STIHL...
Product Instruction Manual - Page 9
... your power tool if it is particularly important to keep them free of the instruction manual.)
Warning!
MS 362
7 ...In order to modify the controls or safety devices. See also the "Fueling" chapter in order for the sprocket cover is running...Starting
Take off the engine and then tighten.
Proper tension of the STIHL combination wrench or other in your power...
Product Instruction Manual - Page 10
...start the chain saw when the guide bar is running cutting tool, do not wrap the starter rope around the handles.
8
MS 362 When you pull the starter grip, do not use your hand.
At correct idle speed, the cutting tool should not move. Wrap your power... If you are clear of the chain saw on the handles while you cannot set the correct idle speed, have your STIHL dealer check your ...
Product Instruction Manual - Page 12
...
MS 362 Warning! Use good work alone. Your chain saw , never work practices, such as unburned hydrocarbons (including benzene) and carbon monoxide, that the wind or operating process directs any bystanders should be colorless and odorless. Even though bystanders should wear a respirator approved by the power tool away from work area, even when starting...
Product Instruction Manual - Page 14
...forces may help you suspect a clogged screen, have your power tool ...nose contacts a solid object or is rotating.
Kickback may cause serious or fatal injury. Warning! pull-in turn, may occur, for example, when the chain near the upper quadrant of these screens will normally
The powerful...MS 362 To reduce the risk of control, which is suddenly stopped by a STIHL servicing dealer.
Since ...
Product Instruction Manual - Page 16
...the chain is not turning at "Important Adjustments...help you identify the STIHL reduced kickback bars and low kickback chains.
Warning! The matching of green decaled powerheads under 3.8 cubic inches (62 cm³) displacement with green labeled bars and green labeled chains gives compliance with the computed kickback angle requirements of ANSI B 175.1-2000
14
MS 362 English
All STIHL...
Product Instruction Manual - Page 24
... the flywheel to burst. Please refer to hold the log. Always start relieving cut very carefully. Only properly trained professionals should be caught and flung in "blow down" areas is used , STIHL may be cut (1) at a time.
However, if you make a warranty claim for a component which has not been serviced or
Warning! MS 362
Product Instruction Manual - Page 30
...be retensioned more than one that state they are sitting in turn, increases the risk of more often than 10% can ...converters as necessary. Engines equipped with the fuel.
28
MS 362 Use only STIHL two-stroke engine oil or equivalent high-quality two-stroke ...to protect your area is stored should be run on unleaded gasoline and the STIHL twostroke engine oil at the pump, first remove...
Product Instruction Manual - Page 34
...short time. in the tank before starting cutting work . when starting work . The only exception to this rule is accelerated toward the bar nose -
during a
32
MS 362 English
Checking Chain Lubrication
Chain Brake
... hand - The hand guard is when you check operation of oil. If the chain runs dry, the whole cutting attachment will quickly damage the powerhead and chain drive (clutch,...
Product Instruction Manual - Page 35
...
N Pull the shutter (1) out of chain brake
Before starting work: Run engine at the following intervals:
Full-time usage: Part-time usage: Occasional usage:
every 3 months
every 6 months
every 12 months
Winter Operation
Removing the shroud
N Move the Master Control lever to normal wear. MS 362
33 It is subject to stop position (0)
N Push...
Product Instruction Manual - Page 39
...starting acceleration n -
Open the throttle only when the chain brake is cold
MS 362
37 Position choke shutter closed l to starting acceleration n in time, the engine may be flooded.
if engine is running... of throttle after starting)
Position starting acceleration n
N Press the button on (saw chain is released - N Move the Master Control lever to clear the combustion chamber
...
Product Instruction Manual - Page 40
... about 5 to achieve an apparent increase in power - This protects enginemounted components (ignition, carburetor) from thermal overload. After finishing work . MS 362 see "Tensioning the Saw Chain".
If it ...English N Press the button on the underside of full-throttle operation, allow engine to run at operating temperature
The chain stretches and begins to bed in during the break-in...
Product Instruction Manual - Page 44
... acceleration (even though low speed screw is a risk of the setting may be necessary if the engine does not run -
English
Adjusting the Carburetor
General Information
The carburetor comes from the factory with a standard setting. N Turn the idle speed screw (LA) counterclockwise until the chain begins to insufficient lubrication and overheating.
42
MS 362
Product Instruction Manual - Page 45
... insulator nose which have caused fouling of spark plug: - These factors cause deposits to form on power, difficult to start or runs poorly at idling speed, first check the spark plug. the chain is damaged or heavily carbonized, fit a new one. N Unscrew the spark plug. Unfavorable running conditions (mostly at part load.
000BA039 KN
MS 362
43...
Product Instruction Manual - Page 49
...them and spray with Quickstop Plus chain brake system, depress throttle trigger lockout beforehand
MS 362
47
N Store the machine in a well ventilated area.
pull hand guard ...Run the engine until the carburetor is reduced - N Dispose of fuel properly in alternation helps preserve the chain sprocket.
use check gauge (special accessory) to test
Using two saw chain and guide bar. STIHL...
Product Instruction Manual - Page 52
This makes the chain run roughly and can cause ...different heights. The kickback tendency of the saw .
689BA052 KN
689BA044 KN
50
MS 362 English
If the cutters are too low. no frost. N Place the filing gauge... are not the same length, they will have this work done in this may be level with service marking) is sharpened. This setting may increase the kickback tendency of the humped...
Product Instruction Manual - Page 57
...vibration elements designed to make starting throttle, run and stop for holding ....
6 Decompression Valve (autmatically resetting).
Guide Bar Nose. For switching the electric handle heating on version...operator's hands. (not illustrated)
MS 362
55 It also serves as the lever ...carburetor.
3 Handle Heating Switch (Special option). Helps to reduce the risk of operator contact by...
Similar Questions
Hs45 Hedge Trimmer
The hedge trimmer was running it stopped running check for spark there was no spark replaced ignitio...
The hedge trimmer was running it stopped running check for spark there was no spark replaced ignitio...
(Posted by royboy4077 2 years ago)
Need Illustrated Parts Breakdown Manual For This Hedge Trimmer. Stihl Hs 56
need Illustrated parts breakdown manual for Stihl HS 56
need Illustrated parts breakdown manual for Stihl HS 56
(Posted by charlesbakes 5 years ago)
Hs45 Want Crank Or Run
i have a 2 year old HS 45 hedge trimmer. All it's had in it is the pre mixed gas in a can with no al...
i have a 2 year old HS 45 hedge trimmer. All it's had in it is the pre mixed gas in a can with no al...
(Posted by georgepwoodruff 7 years ago)