Singer 2010 Superb Support Question
Singer 2010 Superb Support Question
Find answers below for this question about Singer 2010 Superb.Need a Singer 2010 Superb manual? We have 2 online manuals for this item!
Question posted by brosenberg129 on November 2nd, 2013
Machine Does Not Stop Stitching Until Power Is Shut Off
When my machine is in default mode (straight stitching), it continues to stitch even after I have lifted my foot off the foot pedal. It doesn't matter if I hit the "stop" button either; I have to actually turn off the power. I sent the machine back and was told there may be a problem with the foot pedal. They supposedly gave me a new foot pedal, but I still have the same problem. Sometimes it continues for about 5 stitches and stops, but most of the time it just continues sewing until I switch off the power. Has anyone else had this problem? Am I doing something wrong? I have read the manual several times. This is super annoying!!
Current Answers
Related Singer 2010 Superb Manual Pages
Instruction Manual - Page 4
... THE MACHINE TO THE POWER SOURCE 9 Connecting the machine 9 WINDING THE BOBBIN 10-11 Bobbin winding 10-11 INSERTING THE BOBBIN 12 THREADING THE UPPER THREAD 13-14 USING THE NEEDLE THREADER 15 DRAWING UP THE LOWER THREAD 16 CUTTING THE THREAD 16 TWO-STEP PRESSER FOOT LIFTER 17 STARTING SEWING 18 Start/stop button 18 Foot control...
Instruction Manual - Page 7
... to sew stitches in selected position until button is pressed again. Reverse button Hold down this button to select direct mode, utility and decorative pattern mode, block letter mode, script letter mode and outline letter mode.
6. Auto-lock button Hold down position. Mode selection button Press this button to adjust the width of the current patterns and automatically stop the machine...
Instruction Manual - Page 16
..."sewing position".
7 Hold the thread tail securely in one hand.
7
8 Press the Start/stop button or the foot control.
8
9 After the bobbin has wound a few turns stop the machine
and...machine will not sew and the handwheel will disappear from the LCD screen when the
bobbin winder spindle is pushed to the left "sewing position".
11 Continue winding the bobbin until it is full. Stop the machine...
Instruction Manual - Page 23
... to stop the sewing machine. Turn on the sewing machine. Press the button to start sewing.
Please Note: The setting of the speed limiting adjustment lever will run the machine when the foot controller is unplugged from the machine.
The machine will limit the maximum speed of sewing. Release the foot control to the left.
STARTING SEWING Start/stop button
The Start/Stop button...
Instruction Manual - Page 24
...11 Normal thread tension for straight stitch
sewing. Basic thread tension setting is the basic setting).
- There is important for all sewing will always obtain a nicer stitch and less fabric puckering when... the upper thread appears on the bottom side of your fabric. Turn dial to higher number. Turn dial ...
Instruction Manual - Page 26
...
Gathering
Overcasting foot (E)
Blind hem stitching
Gathering foot (Optional)
Button sewing
Blind hem foot (F) Narrow hemming
Rolled hem foot (K) (Optional)
Button sewing foot
Walking foot (Optional)
This foot helps to the section: USING THE TWIN NEEDLE)
PRESSER FOOT
APPLICATION
General sewing, Patchwork stitches, Decorative stitching, Smocking, Fagoting, etc. PRESSER FOOT CHART
(The...
Instruction Manual - Page 29
... stitch sews at the beginning of sewing. If you press and reverse the button before starting to complete this operation. Press the button again to sew forward again. The machine will rotate slowly at a low speed and machine automatically stops if the reverse button is pressed.
24
OPERATION BUTTONS
Needle up/down position button
Auto-lock button Reverse button
Start/stop button
Start/stop...
Instruction Manual - Page 35
... an added pattern when sewing combinations of the stitch width, stitch length, mirror, elongation and auto-lock for these memorized patterns is selected. Press this button to set the selected pattern under the editing mode, the LED light will turn on. Each press of characters or decorative stitches. Press the " " button to enter the memory mode, and store the...
Instruction Manual - Page 36
... a pivot and turn the fabric.
5. Use the needle as pant hems and cuffs.
31 Press the reverse button and sew 4-5 stitches. SEWING TIPS Sewing corners
3 2
1
4
Reverse
Free arm
1. Lower the needle into the fabric
5
manually or by pressing the
needle up/ down button once.
3.
Lower the presser foot and resume sewing. Raise the presser foot.
4.
Stop the sewing machine when you reach...
Instruction Manual - Page 42
... at the beginning and at the end of the button and sew.
6 For buttons with 4 holes, sew through the back two holes.
6
37 Place the
button in the desired position, lower the foot.
3 Adjust the stitch width to " 2.5-4.5 "
according to the distance between the two holes of the button.
4 Turn the handwheel to check that the needle
goes cleanly...
Instruction Manual - Page 51
... end and right side of
zipper. It is possible that the needle could hit the presser foot and break when sewing other patterns.
11 Baste the zipper opening on the seam allowance with machine set for straight stitch in place.
33 Attach the zipper foot. Place the
zipper face down on the garment.
1
2
22 Press open the...
Instruction Manual - Page 52
Attach the right side
of the presser foot pin to
top.
55 Turn the fabric right side out, stitch across
the lower end and right side of zipper.
66 Stop about 5cm (2 inches) from bottom to the holder when sewing the left side of
zipper. ZIPPER INSERTION Inserting a lapped zipper
2 inch
1
2
3
4
5
6
11 Baste the zipper opening...
Instruction Manual - Page 54
... cord.
Select the desired pattern and adjust the stitch width so that the stitches are just covering the cords.
Lower the foot and sew slowly, guiding the cord over the design. Lower the foot and sew slowly guiding the cords.
49 CORDING
Sew over one, two or three strands of the cording foot from the right side opening.
Instruction Manual - Page 55
...
Use the satin stitch foot for satin stitching and sewing decorative stitches. Please Note: When sewing very light weight fabrics...stitching to pass freely underneath.
This foot has a groove on fabric scraps first, until you may adjust the length and width of the fabric.
50 Experiment by pressing the stitch length and width adjustment buttons. To change the satin or decorative stitch...
Instruction Manual - Page 59
...the needle. Stitch across the opening is necessary to coordinate sewing speed and movement of the hole to secure the threads.
Press the darning foot on firmly ...turn the work and cover the area with your index finger and tighten the screw (c). FREE MOTION SEWING
1
5
3.5~5.0
a b ab
a b
c
* The Darning foot is accomplished without the sewing machine internal feed system. First sew...
Instruction Manual - Page 70
... memory mode and
return to the normal screen.
6
65 MEMORY
Recalling and sewing the memorized pattern 11 Press the " " button to enter memory mode and then
input the number of the selected
memory module. Select or browse memory patterns by pressing stitch
M
width " – " or " + " buttons.
3
44 Press on the foot control or press the start/stop button to...
Instruction Manual - Page 72
...then ON again.
67 Return bobbin winder shaft to left (disengaged) to allow the buttons to turn the on pages 71 & 72 for solutions. Please Note: If the problem is... Attention: During the sewing, if the thread get jammed inside the hook stopping the needle from moving and you continue pressing the foot control, the security switch will continue to restart the sewing machine, you will be ...
Instruction Manual - Page 73
" button and turn on the "
power switch. BUZZER SOUND
ON
OFF 1
11 Press on the
22 You can select the mode by pressing the
stitch width " + " or " – " button.
The Buzzer
sound setting mark will appear on " "or sound off " ".
2
33 Pressing the "0000" button. Select desired mode sound on the LCD screen when you have set it.
3
68
Instruction Manual - Page 77
... lint.
To use Start/stop button, disconnect the foot controller.
5.A thread is caught in .
6.Connect the power line plug to suit the...Turn the handwheel backwards and forwards by the machine.
1.Turn on the hook or 1.Clean the hook and feed dog as
needle bar. The sewing machine doesn't operate
4.The Start/stop button was not pressed. 2.Press the Start/stop button.
3.The presser foot...
Instruction Manual 2 - Page 108
... foot is securely fastened to presser bar (see page 9). (Turn to page 28 for additional information.)
Lower thread breaks
Make sure . . . ® bobbin has been correctly wound. ® bobbin case area is free of lint and loose
threads (see page 20).
• machine is straight and sharp. (Turn to page 33 for additional information.)
Stitching Difficulties...
Similar Questions
Machine Randomly Stops
machine randomly stops sewing and beeps. Start/stop button turns red and then tells me the presser f...
machine randomly stops sewing and beeps. Start/stop button turns red and then tells me the presser f...
(Posted by kswillie 1 year ago)
I Just Received A Singer Fq-4 Instead Of A Seqs6000. The Seller Says They Are T
I just received a Singer FQ-4 instead of a SEQS6000. The seller says they are the same model even th...
I just received a Singer FQ-4 instead of a SEQS6000. The seller says they are the same model even th...
(Posted by allertgroups 2 years ago)
How Do You Oil This Machine.? It's Completely Jammed And Brand New.
Singer 3232
Singer 3232
(Posted by Kmdigiacomo 7 years ago)
I Have A Heavy Duty Singer Sewing Machine (model 4432)
stopped sewing after bobbin replacement?
stopped sewing after bobbin replacement?
(Posted by sueisforme 9 years ago)
What Else Can Be Done If Ur Machine Keeps Stopping And You Have Already Cleaned
my machine keeps stopping . i have cleaned bobbin carraiage .
my machine keeps stopping . i have cleaned bobbin carraiage .
(Posted by keithgutter 11 years ago)