Sharp UP-820F Support Question
Sharp UP-820F Support Question
Find answers below for this question about Sharp UP-820F.Need a Sharp UP-820F manual? We have 1 online manual for this item!
Question posted by dianewhitehead on July 25th, 2012
Its Showing No Paper However Paper In.
The till is showing no paper however paper in and also the buttons don't work.
Current Answers
Related Sharp UP-820F Manual Pages
UP-810F | UP-820F Operation Manual - Page 10
List of paper jams ...272 Removing a paper jam (UP-810F) ...273 Removing a paper jam (UP-820F) ...273 Cleaning the Print Head (UP-810F)...274 Cleaning the Print Head (UP-820F)...275 Removing the Till and the Drawer...276 Operating the Drawer by Hand...276 Before Calling for Service ...277
16. Loading Dynamic UPC to the Main UPC...
UP-810F | UP-820F Operation Manual - Page 12
...POS terminal UP-810F may result in the "Operator Maintenance" chapter. Printer cover
To open the printer cover, lift up .
Cutter open lever If a paper jam occurs, pull the cutter unit open while pushing the cutter open lever
Paper...care of printers offered by the green lever on the right. Then remove the paper jam inside the printer. This may be lifted by the market. For specific...
UP-810F | UP-820F Operation Manual - Page 13
...
The POS terminal UP-820F may result in damage to the printer and print head.
- 11 - Printer cover
Your POS terminal is shipped with the head in the down the print head release lever before you need to the "Removing a paper jam" section in printer is approximately 5 million lines. For specific instructions related to...
UP-810F | UP-820F Operation Manual - Page 16
If you
- 14 - Standard keyboard layout
UP-810F
UP-820F
NOTE
• All the keys except the receipt and journal paper feed keys ( and want to change the layout, consult your authorized SHARP dealer.
• Keyboard layout is subject to change without notice.
) can be re-positioned.
UP-810F | UP-820F Operation Manual - Page 17
...in key
CASH TIP
Cash tip key
CHARGE TIP
Charge tip key
TIP PAID
Tip paid key
EAT IN 1
... Deposit refund key RECEIPT
Receipt paper feed key
JOURNAL
Journal paper feed ...DEPT #
Dept. TAX5 SHIFT
Tax 2 thru 5 shift keys
RA RA2 Received-on-account 1 and 2 keys
DEPOSIT
Deposit key
PO PO2 Paid-out 1 and 2 keys
DEPOSIT RF
- 15 - Direct price lookup keys
89
123
1 ... 99 Department keys...
UP-810F | UP-820F Operation Manual - Page 22
...( )
: appears when the used memory is 90%.
Sentinel mark (X)
: Appears when the cash in drawer. The sentinel server is 80%. Numeric key data area Shows numeric data by numeric key entry.
• Screen example 2 (PGM mode)
Information area 2... Appears when an item is selected on the main display area or registered. : Shows "REFUND", "RETURN" or the like when the corresponding key is 95%.
UP-810F | UP-820F Operation Manual - Page 28
... Time
Sales total Cash amount tendered Change due
NOTE The above receipt sample was printed out by the receipt printer of the UP-810F. Built-in Printer Sample Receipt
UP-820F
Date Consecutive no .... Item entry
Machine no .
All other receipt samples in this POS terminal. 4 Receipts This chapter describes the part...
UP-810F | UP-820F Operation Manual - Page 29
... make an entry beyond a programmed amount entry limit: Check to save paper using the receipt On/Off function. To enable receipt printing, touch
"RCP...POS terminal will go into an error state accompanied by
press
the
key.
To disable
receipt
printing,
press
the
FUNC MENU1
key
and
then
touch
the
RCP ON/OFF
key
to
set
the
function
to section "Installing and Removing the Paper...
UP-810F | UP-820F Operation Manual - Page 58
... the amount tendered by using the
CH 1
thru
CH 9
key
when PGM2-mode programming your POS terminal has been preset programmed for amount tender
compulsory in cash or check, and press the corresponding key. Your POS terminal will show the amount of a deficit. Positive/Negative code checking function
The Positive/Negative code checking function...
UP-810F | UP-820F Operation Manual - Page 91
...can take these reports in the X1/Z1 mode. • X2 and Z2 reports show daily sales information.
It does not affect the POS terminal's memory.
• Use the resetting function (Z) when you need to take...values in the "Data to be entered" column in drawer (CID) and sales total for department sales, cash in the table (shown later). 5. How to take an OPXZ, X1/Z1 or X2/Z2 report
...
UP-810F | UP-820F Operation Manual - Page 118
...(Z report) It is possible to take the resetting report of the journal data in the electronic paper. Operation: Select the reading operation "E.JOURNAL" in X1/Z1 or OPXZ mode.
No. (Consecutive.../Z1, and X2/Z2 modes into the electronic journal file.
• Reporting (X report)
The POS terminal reports the journal data (same as normal journal formats) in the Reporting (X report) paragraph can...
UP-810F | UP-820F Operation Manual - Page 268
..." in the "up position
Printing position
- 266 -
Cautions in handling the printer
• If your POS terminal is in this chapter, install a new paper roll properly, then press the CL key. Any key entries will appear on the display. When the print head is heated to the normal state ...
UP-810F | UP-820F Operation Manual - Page 269
... in any of the following conditions:
Exposure to high humidity and temperature. In the case of the UP-820F Printing position
Head-up position
Cautions in handling the recording paper (thermal paper)
• Use only paper as specified by friction (scratching etc.) Contact with glue, thinner or a freshly copied blueprint. Exposure to develop color...
UP-810F | UP-820F Operation Manual - Page 270
... specified could cause paper jamming, resulting in a POS terminal malfunction.
Cut off approximately one revolution (approx. 25 cm long).
(How to set the paper roll)
(How to deterioration of the heat-sensitive color development component of the paper surface.
Paper specification
Paper width:
UP-810F: 3.13 ± 0.02 in. (79.5 ± 0.5 mm)
UP-820F: 2.26 ±...
UP-810F | UP-820F Operation Manual - Page 271
...Insert the end of the paper into the paper chute as shown on the
right. Wind the paper around the spool shaft two...Printing position
- 269 - Set the paper correctly in the paper take-up
spool. (Press the key to feed paper more if required.)
7. Insert the ...paper into the paper chute as illustrated right in the paper roll
location (receipt side) of the paper into the slit in the journal paper...
UP-810F | UP-820F Operation Manual - Page 272
... until it comes out of the UP-810F
- 270 - Manual installing of a paper roll (UP-810F/UP-820F)
When you to lift up spool as described on the right (journal paper).
5. Correctly place the new paper roll in the receipt/journal paper
roll holder.
3. Pull the print head release lever toward you want to its...
UP-810F | UP-820F Operation Manual - Page 274
... is short, always cut if off the receipt after printing is finished. Prevention of paper jams
Keep the following points in mind to pull the receipt paper after the printing
Pull the receipt paper obliquely upward from above illustrations show the receipt printer of its side. You hear the cutter sound when printing is...
UP-810F | UP-820F Operation Manual - Page 277
....
7.
Reset the paper roll(s) correctly by following the step in printer of the UP-820F.
- 275 - Clean the print head with a tool or anything hard which may be paper dust adhering to its...Pull up the print head release lever to the cutter open tab
6. The above illsutration shows the built-in
"Installing a paper roll".
10. Make sure the
metal part is getting dark or faint, there may...
UP-810F | UP-820F Operation Manual - Page 279
... take-up . (UP-820F) Printing is illuminated, but the whole machine rejects any option yourself. 1. Remote coin case model ER-55CC2 or ER-75CC3 4. Is the AC power cord plug disconnected or loosely connected to the POS terminal? Is the terminal set properly to the "REG" mode? Is there a paper jam?
16 List...
UP-810F | UP-820F Operation Manual - Page 280
Quality Cash drawer Accessories
UP-810F
UP-820F
14.1 (W)* X17.6 (D) X14.7 (H) in. (358(W)* X 447(D) X 374(H) mm) ...177; 0.5 mm)
3.15 in battery
Keyboard Display
Customer display Printer Type
Printing speed Printing capacity Other functions
Paper Width roll
Max. 17 Specifications
Model External dimensions
Weight Power source Power consumption
Operating temperature Electronics Built-in ....
Similar Questions
Sharp Cash Registers Pos Er-a750
two cash registers the master reads ram error the second register blank screan key boards do nothing...
two cash registers the master reads ram error the second register blank screan key boards do nothing...
(Posted by Dearl001 8 years ago)
10 Of Our Up-820f Reg. Says Ram Error. Been In Our Whse. Unused For 2 Years Or S
(Posted by jeffmurphy 8 years ago)
Thermal Cash Register Paper Rolls
were do you buy paper rolls for a cash register size 1 3/4 thermal paper?
were do you buy paper rolls for a cash register size 1 3/4 thermal paper?
(Posted by nena9003 10 years ago)
Why Does My Sharp Xe-a106 Cash Register Say P And I Can't Push Any Buttons
(Posted by crius1znStephen 10 years ago)
Problem
When you receive a message that states system closed entry inhibited what does this mean and how do ...
When you receive a message that states system closed entry inhibited what does this mean and how do ...
(Posted by lorieannecross 12 years ago)