Sanyo mpr-214f Support Question
Sanyo mpr-214f Support Question
Find answers below for this question about Sanyo mpr-214f - Commercial Solutions Refrigerator.Need a Sanyo mpr-214f manual? We have 1 online manual for this item!
Question posted by neretinyuriy on November 22nd, 2019
How To Reset E06
How to reset E06 if we don't have a remote sensor?
Current Answers
Related Sanyo mpr-214f Manual Pages
Instruction Manual - Page 1
INSTRUCTION MANUAL
Pharmaceutical Refrigerator with Freezer
MPR-214F
Instruction Manual - Page 2
... SANYO Electric Biomedical Co., Ltd. Please contact SANYO if any point in any inaccuracies. Note:
1. CONTENTS
PRECAUTIONS FOR SAFE OPERATION CAUTIONS FOR USAGE ENVIRONMENTAL CONDITIONS REFRIGERATOR COMPONENTS INSTALLAITON START-UP OF UNIT OPERATING INSTRUCTIONS ALARMS AND SAFETY FUNCTIONS SETTING OF ALARM RESUME TIME DEFROSTING MAINTENANCE AUTOMATIC TEMPERATURE RECORDER INSTALLATION OF...
Instruction Manual - Page 7
...minutes. CAUTIONS FOR USAGE
• If the unit is unplugged or the power to the unit is refrigerated by following the procedure on page 19 "Defrosting" when the freezer is completely sealed up . This ... be lead through the access port on the outside of door gasket.
• In the refrigerator compartment, put the items into the chamber in the rear of freezer. It is recommended to...
Instruction Manual - Page 11
... displayed on the shelves. The right side lock is for the right upper and lower doors and left upper and lower doors. 9. Remote alarm terminal (rear): This is for refrigerator): Place the material on this vent is installed inside the enclosure. Shelf (for the left side lock is used to alarm the...
Instruction Manual - Page 12
...error code.
7. See "Key lock operation" on page 15.
5. Refrigerator indicator (REFRIGERATOR): This indicator is lit when the refrigerator is flashed during alarm condition. Numerical value shift key ( ): Pressing... can be set mode causes the changeable digits to change. "ON-OFF" of refrigerator or freezer and each setting is accepted.
4. Temperature display: This indicator shows the...
Instruction Manual - Page 13
...leakage or electric shock. WARNING
Never install the unit in a location subjected to corrosion.
12 Heat can cause inefficient refrigeration.
4.
This precaution will result in water spillage or injury from heat generating sources Avoid installing the unit near heat-...ventilation. Do not install the unit under water pipes or steam pipes. Deterioration of the refrigeration capacity.
3.
Instruction Manual - Page 15
... freezer temperature can be set temperature of
the temperature display flashes. The current refrigerator or freezer temperature is not
changed. The current set temperature is
SET
displayed and... after operation
----- FREEZ.
Note:
If no load at the factory so that the refrigerator temperature is 4oC and the freezer temperature is set mode, the display mode returns
automatically...
Instruction Manual - Page 16
...- REF.
Pressing the key shifts up the figure of the temperature display. The current refrigerator or freezer temperature is finished.
Pressing the key leads blink of the first digit of the...This unit incorporates a key lock feature which can be set any time when the current refrigerator or freezer temperature is displayed. Note:
Key lock can inhibit the tampering using digit ...
Instruction Manual - Page 17
...for high temperature alarm setting and table 5 shows low temperature
alarm setting for freezer and refrigerator. alarm Set temp. -5oC Set temp. -10oC
Table 4
Operation
Key operated
Indication ...temperature alarm setting at which the alarm will be activated are effective for refrigerator.
OPERATING INSTRUCTIONS
Alarm temperature setting
The high temperature and low temperature at the...
Instruction Manual - Page 18
... to 4 (F04).
17
The current set key. The value is stored in memory and
SET
the current refrigerator temperature
is displayed.
2
Press and hold the numerical value shift key for about 5 seconds.
The current refrigerator temperature is displayed.
Pressing the key shifts up the figure
of the temperature
display flashes.
5
Set to...
Instruction Manual - Page 19
...sensor goes Open (E05) or short circuit (E06). Alarm lamp flashes. are or significant degradation of power supply plug from the
----- Note:
The alarm can be
silenced. exceeds 28oC.
• Refrigerator... for refrigerator, E07 and chamber temp. Operation by pressing the alarm buzzer stop key (BUZZER), but the remote alarm cannot be canceled by the defrost sensor. Reset at about...
Instruction Manual - Page 21
... stable inside the chamber, the refrigeration compressor is occurred during the forced defrost cycle. When the frost is initiated by the defrost sensor. Set the freezer temperature to another...Temporarily move all of the freezer to -00. Note: The freezer does not automatically reset to the desired temperature, place the original contents back in the freezer. During "off ...
Instruction Manual - Page 22
... eliminate the moisture. • Never pour water onto or into the unit.
Replacement of lamp
Follow the procedure below at the upper front side of refrigerator chamber. (Fig. 1)
1. If some of them are completely sealed. To remove the lamp cover, hold the both sides of the cover with a dry cloth to...
Instruction Manual - Page 23
... to an instruction manual included with the recorder MPR-S30
MPR-S30 MPR-S7
Access port for refrigerator
Access port for freezer
Port for taking out the recorder sensor
Recorder (MTR-0620LH) & recorder fixture (MPR-S30) or Recorder (MTR-4014LH) & recorder fixture (MPR-S30) or Recorder (MTR-G3504) & recorder fixture (MPR-S7)
Left side view
WARING
Always disconnect...
Instruction Manual - Page 24
... when bending the capillary tube. ɾDo not bend the tube of 30 mm from the edge of the refrigerator by using the 2 screws as an accessory. (Fig. 4)
5. Fig. 4 23 Attach the fixture to...as shown in the port. Fig. 1
Fig. 2
3. Fix the recorder sensor to the attachment hole on the caps for refrigerator and take out the thermal insulation in Fig. 2. INSTALLATION OF TEMPERATURE RECORDER
...
Instruction Manual - Page 26
... the port.
Fig. 9
25
Pass the recorder sensor to avoid the crush of the tube when bending the capillary tube.
ɾDo not bend the tube of 30 mm from the edge of the refrigerator by using the large clips enclosed with the recorder fitting (MPR-S30: optional component). (Fig. 9)
6. Clip
ɾDo...
Instruction Manual - Page 30
... pass the lead wire as shown in the port. Replace the cap on the left side of the refrigerator by using the clips enclosed with the recorder fitting (MPR-S7: optional component). (Fig. 20)
Fig. 20
29 Fix the recorder sensor to the attachment hole on the port for taking out the recorder...
Instruction Manual - Page 31
... time. 2. The containers of the unit should be closed . 8. The door is removed automatically by refrigerator contents. 2. There is a power failure, the fuse is blown, or the circuit breaker is not ... match set value.
There is to the power supply or capacity of no refrigeration or poor refrigeration, transfer the stored items to prevent accidents such as suffocation.
30 The ambient...
Instruction Manual - Page 32
... W327 x D250 (mm) Max. alarm, Low temp. SPECIFICATIONS
Name
Pharmaceutical Refrigerator with Freezer
Model
MPR-214F
External dimensions
W540 x D557 (+ 45)* x H1794 (mm)
Internal dimensions
W455 x D466 x H917 (mm) (Refrigerator) W420 x D342 x H267 (mm) (Freezer)
Effective capacity
176 L (Refrigerator), 39 L (Freezer)
Exterior
Zinc galvanized steel, Polyester resin baked finish...
Instruction Manual - Page 34
...;Yes ˘Yes ˘Yes
˘No ˘No ˘No ˘No
3. Date : Signature : Address, Division : Telephone :
Product name:
Model:
Serial number:
Pharmaceutical Refrigerator with Freezer
MPR-214F
Please decontaminate the unit yourself before servicing. Hand over this form to the service engineer to keep for safe repair/maintenance of the unit...
Similar Questions
What Does Error E07 Mean On Sanyo Mpr-214f?
What Does Error E07 mean on Sanyo MPR-214F?
What Does Error E07 mean on Sanyo MPR-214F?
(Posted by taniastewart 9 years ago)
Alarm E7
IHAVE A SANYO MPR-214F FRIDGE GIVING E7 ALARM WHICH COULD BECIRCULATION FANPROLBEM. SET TEMPERATURE ...
IHAVE A SANYO MPR-214F FRIDGE GIVING E7 ALARM WHICH COULD BECIRCULATION FANPROLBEM. SET TEMPERATURE ...
(Posted by melverd 11 years ago)
What Is Mfg Accuracy On Mpr-214f?
(Posted by ThomasGollery 13 years ago)