Sanyo mpr-214f Support Question
Find answers below for this question about Sanyo mpr-214f - Commercial Solutions Refrigerator.Need a Sanyo mpr-214f manual? We have 1 online manual for this item!
Question posted by sandmhk2 on August 1st, 2012
Sanyo Mpr-214f
is Sanyo mpr-214f is suitable for blood bag unit?
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Sanyo mpr-214f Manual Pages
Instruction Manual - Page 2
... FOR SAFE OPERATION CAUTIONS FOR USAGE ENVIRONMENTAL CONDITIONS REFRIGERATOR COMPONENTS INSTALLAITON START-UP OF UNIT OPERATING INSTRUCTIONS ALARMS AND SAFETY FUNCTIONS SETTING OF ALARM RESUME TIME DEFROSTING MAINTENANCE AUTOMATIC TEMPERATURE RECORDER INSTALLATION OF TEMPERATURE RECORDER TROUBLESHOOTING DISPOSAL OF UNIT SPECIFICATIONS PERFORMANCE SAFETY CHECK SHEET
P. 2 P. 6 P. 8 P. 9 P. 12 P. 13...
Instruction Manual - Page 7
... port on the outside of door gasket.
• In the refrigerator compartment, put the items into the chamber in the rear of the unit. Corrosion may lead to allow air circulation. Never use a knife... two minutes after door opening. This protects the compressor.
• This inner cabinet is refrigerated by following the procedure on the floor of the cabinet. Too much stock will result in...
Instruction Manual - Page 11
... lock the door. Do not insert anything into the cabinet. 10. Always put on the glass in the refrigerator. 7. Refer to adjust the height and level the unit for the left side lock is displayed on the refrigerator floor. 14. Fan is open to the direct air flow can sometimes condense on the...
Instruction Manual - Page 12
... this key in the setting mode causes the numerical value to move. Refrigerator indicator (REFRIGERATOR): This indicator is lit when the refrigerator is flashed. Alarm lamp (ALARM): This lamp is open.
11 Refer... This lamp is lit when the door is flashed during alarm condition. "ON-OFF" of refrigerator or freezer and each setting is activated by pressing this key in the key lock mode.
6....
Instruction Manual - Page 13
... subjected to direct sunlight may lead to high humidity
WARNING
Do not use the unit outdoors. Heat can cause inefficient refrigeration.
4. A location with a sturdy and level floor Install the unit on a sturdy floor to rain water. Do not install the unit under water pipes or steam pipes. A location with the following conditions:
1. Deterioration of...
Instruction Manual - Page 15
... up the figure
of
the first digit. Note: The unit is set mode, the display mode returns
automatically to or lower than 3ˆ. The value is stored in the table. Perform key operation in the sequence indicated in memory and
SET
the current refrigerator temperature
is not
changed.
In this case, the...
Instruction Manual - Page 16
...refrigerator or freezer temperature is displayed. ture display flashes.
3
Set to 1 with the numerical value shift key.
3 Press the set value is finished. OPERATING INSTRUCTIONS
Key lock operation
This unit...00 by pressing display select key. The first digit of the current digit.
The current refrigerator or freezer temperature is
displayed. Display L 0 L 1
Mode Key lock OFF Key lock...
Instruction Manual - Page 17
... setting
The high temperature and low temperature at the factory is as follows:
Refrigerator Freezer
High temp. The following shows the outline of the current digit.
6... Set temp. -10oC
Table 4
Operation
Key operated
Indication after operation
1
----- The current refrigerator temperature is displayed
SET
and the first digit of flashed
digit.
The current set the first...
Instruction Manual - Page 18
The value is stored in memory and
SET
the current refrigerator temperature
is displayed.
2
Press and hold the numerical value shift key ...numerical value shift key. (Note 1)
4 Press the set key. Note 2: For the freezer, set key. The current refrigerator temperature is displayed. Pressing the key leads the change of the temperature display blinks.
3
Set the first digit to 4...
Instruction Manual - Page 19
...protector
Low temperature alarm
Over-cool protector
Power failure alarm
Situation
Indication
• Refrigerator
If the chamber temperature exceeds the set temperature or drops to 0oC Alarm lamp....
Buzzer
Safety operation
Intermittent tone Remote alarm is lit.
ALARMS AND SAFETY FUNCTIONS
This unit has the alarm and safety functions shown in the
case of 2
-----
or lower....
Instruction Manual - Page 21
...during the forced defrost cycle. Temporarily move all of defrost methods are adopted for the refrigerator, which has accumulated on the evaporator is displayed alternately on the digital temperature display.... No temperature alarm is complete, normal operation resumes. During "off . When the unit is operating under a forced defrost cycle, the current chamber temperature and "dF" is ...
Instruction Manual - Page 22
...15W (for 220V, 230V, 240V) 4. Replacement of lamp
Follow the procedure below at the upper front side of refrigerator chamber. (Fig. 1)
1. To remove the lamp cover, hold the both sides of the cover with a ...from the socket by turning it toward. (Fig. 2) 3. Then wipe the cabinet or accessories unit with flexure and push it to counterclockwise. (Fig. 3)
Caution: Take care not to injure the...
Instruction Manual - Page 23
...of front panel
Recorder for refrigerator ʢMTR-0620LHʣ
Recorder fixture Fixture enclosed with the recorder MPR-S30
MPR-S30 MPR-S7
Access port for refrigerator
Access port for freezer
Port...fixture (MPR-S30) or Recorder (MTR-4014LH) & recorder fixture (MPR-S30) or Recorder (MTR-G3504) & recorder fixture (MPR-S7)
Left side view
WARING
Always disconnect the power supply to the unit before...
Instruction Manual - Page 24
... using the 2 screws as shown in the port. Remove 2 (outside and inside ) covering the access port for refrigerator and take out the thermal insulation in Fig. 2. Fig. 3
4. Remove the caps (both outside ) of 4...capillary tube. ɾDo not bend the tube of 30 mm from the edge of the refrigerator by using the large clips provided as shown in the figure below.
Attach the fixture to the...
Instruction Manual - Page 25
Attach the temperature recorder (MTR-0620LH) to the recorder fixture (MPR-S30: optional component) by pushing the shaft on the panel cover for mounting space of temperature recorder. Remove a cap for taking out the recorder sensor ...
Instruction Manual - Page 26
... tube when bending the capillary tube.
ɾDo not bend the tube of 30 mm from the edge of the refrigerator by using the large clips enclosed with the recorder fitting (MPR-S30: optional component). (Fig. 9)
6. Arrange the capillary tube so that it cannot contact the shelf.
Fig. 9
25 Then replace the...
Instruction Manual - Page 30
...: optional component). (Fig. 9)
Clip
Fig. 19 7.
Note: Make a cut on the left side of the refrigerator by using the clips enclosed with the recorder fitting (MPR-S7: optional component). (Fig. 20)
Fig. 20
29 Then replace the thermal insulation and caps (both outside and inside ) covering the access port for access ...
Instruction Manual - Page 32
... of projected area.
31 SPECIFICATIONS
Name
Pharmaceutical Refrigerator with Freezer
Model
MPR-214F
External dimensions
W540 x D557 (+ 45)* x H1794 (mm)
Internal dimensions
W455 x D466 x H917 (mm) (Refrigerator) W420 x D342 x H267 (mm) (Freezer)
Effective capacity
176 L (Refrigerator), 39 L (Freezer)
Exterior
Zinc galvanized steel, Polyester resin...
Instruction Manual - Page 34
...Contamination of installation:
33 Date : Signature : Address, Division : Telephone :
Product name:
Model:
Serial number:
Pharmaceutical Refrigerator with Freezer
MPR-214F
Please decontaminate the unit yourself before servicing.
Refrigerator contents : Risk of infection: Risk of the unit
a) The unit is safe to work on
˘Yes ˘No
b) There is some danger (see below)
˘...
Similar Questions
What Does Error E07 Mean On Sanyo Mpr-214f?
What Does Error E07 mean on Sanyo MPR-214F?
What Does Error E07 mean on Sanyo MPR-214F?
(Posted by taniastewart 9 years ago)
Alarm E7
IHAVE A SANYO MPR-214F FRIDGE GIVING E7 ALARM WHICH COULD BECIRCULATION FANPROLBEM. SET TEMPERATURE ...
IHAVE A SANYO MPR-214F FRIDGE GIVING E7 ALARM WHICH COULD BECIRCULATION FANPROLBEM. SET TEMPERATURE ...
(Posted by melverd 11 years ago)
What Is Mfg Accuracy On Mpr-214f?
(Posted by ThomasGollery 13 years ago)
How Do You Set The Temperature On This Fridge Mpr-213f?
(Posted by dnielsen 13 years ago)