Pyle PLR38I Support Question
Pyle PLR38I Support Question
Find answers below for this question about Pyle PLR38I.Need a Pyle PLR38I manual? We have 1 online manual for this item!
Question posted by theycallmeboss on December 21st, 2012
Stations Only Go Up To 90.0
my radio stations start at 76.0 and go up as high as 90.0
how can i fix this so that it is the standard 87.7-107.9
Current Answers
Related Pyle PLR38I Manual Pages
PLR38I Manual 1 - Page 1
PLR38I INSTRUCTION MANUAL
MULTIFUNCTION CAR AUDIO SYSTEM WITH AM/FM DIGITAL PLL TUNING RADIO MMC/SD USB/IPOD PLAYER
Remarks: Any information subject to change without further notice
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com
PLR38I Manual 1 - Page 2
...
10 3
9 67
4
1. The control mode of the problems persist after check list has been made, consult your nearest service dealer. VOLUME UP/DOWN KNOB (turn)& AUDIO MODE SELECTOR (push) In normal mode, use this knob to increase or decrease the volume level. To access the various sound parameters push the knob...
PLR38I Manual 1 - Page 3
...audio. Please note: AUX IN Mode can only be selected if it is pressed again.Then press the CLK button and hold for more than 1 second until the real time flashes on the display.Then you are used to store the presets for radio stations... front control panel from the unit chassis. RADIO REPEAT These buttons are having problems with a different station ,repeat the process and the new setting ...
PLR38I Manual 1 - Page 4
...haf second and the tuner will stop at the next strong station available.
Press again to step up or down the radio dial in the current folder automatically. STOP Pressing STOP will enter... pdfFactory trial version http://www.pdffactory.com To pause playback, press this button to cycle between the five radio bands: FM1 > FM2 > FM3 > AM1 > AM2
9&10.
8.BAND Press briefly, repeatedly to...
PLR38I Manual 1 - Page 5
... is compatible with FinePrint pdfFactory trial version http://www.pdffactory.com USB port Insert USB drive in the docking drawer . Press PLAY/PAUSE to the PLR38I-IPOD, but you .
However, you can be able to control the iPod playback this slot for you will not be displayed and controlled by the...
PLR38I Manual 1 - Page 6
... that the iPod function is present, check the System Settings to begin playback. If the PLR38I-IPOD does not recognize that an iPod is enabled.
1.PLAY/PAUSE Press to make sure ... or fast Forward. Please install the appropriate dock adaptor as described below. Is iPod Enabled in the PLR38I-IPOD.
Press again to resume playback.
2.RPT (Repeat Play Mode) Press this button for your iPod...
PLR38I Manual 1 - Page 7
...4GB/8GB (2nd generation)
iPod Touch 8GB/16GB (1st generation)
iPod Nano (5th generation)
iPod Nano
iPod video
iPod Nano
1GB/2GB/4GB 30GB and iphone
4GB/8GB
iPod
(1st generation) (5th generation) (3rd generation)... the AUX input on top edge of faceplate
4.Insert your iPod to play music through the PLR38I-IPOD. Press PLAY/PAUSE to select AUX IN and use the headphone out jack on the iPod...
PLR38I Manual 1 - Page 8
...
2
3
3.MUTE Press this button to silence the audio.Press again to restore the previous audio volume level.
4
5
6
7
8
5
9
10
4.RDM Press this button for playback of an AM station may result from the current frequency and check the signal...cancel.
5.AMS In Radio mode, press this button to play each selected band. iPod charging
The PLR38I-IPOD circuitry is implemented in the PLR38-IPOD....
PLR38I Manual 1 - Page 9
...-
-
5m m n ut
da sh boa rd at the next strong station available. In this button briefly to step up or down the radio dial in order to select either USB or SD modes.
Press and hold...the button repeatedly to cycle through the 5 audio input sources in single step increments.
8&9.TUNE/SEEK & I>I (Skip back/skip forward, fast back/fast forward) In radio mode, Press this mode the tuner will ...
PLR38I Manual 1 - Page 10
Specifications
Supply voltage Current consumption Power Output Audio Signal Output Characteristics
: 12V DC(11V-15V)
: 10A
: 4 X 25 Watts
: 2ch line out
: (1)Frequency Response: 20Hz-20KHz
(2) S/N Ratio:
50 dB(JIS)
Frequency Coverage: IF Sensitivity (S/N = 30dB) :
(USA) FM 87.5 to 107.9Mhz 10.7Mhz 20dBu
Frequency Coverage: IF Sensitivity (S/N = 20dB) :
AM 530 to 1710Khz 450Khz
45dBu...
PLR38I Manual 1 - Page 11
....
- Clock Format (12-hour or 24-hour) Press DOWN ARROW to Radio Frequency selection mode. BAND NAME
AMERICA 1 AMERICA 2 AMERICA 3 EUROPE MIDEAST AUST(AUSTRALIA) RUSSIA
FREQUENCY RANGE
FM:87.5-107.9MHz FM:87.5-108MHz FM:87.5-107.9MHz FM:87.5-108 MHz FM:87.5-108 MHz FM:87.5-108 MHz FM:65.0-108MHz
AM:530-1710kHz AM:520-1620kHz...
Similar Questions
No Sound From Hdmi
I Have A Samsung 6 Series Tv, Plug Mdmi Cable Into Arc On Tv, Plug Hdmi Into Hdmi 1 Or 2 On A Pt589b...
I Have A Samsung 6 Series Tv, Plug Mdmi Cable Into Arc On Tv, Plug Hdmi Into Hdmi 1 Or 2 On A Pt589b...
(Posted by brianwervey 3 years ago)
I'm Trying To Hook Up My Bose Cinema Trip I Speakers To The Subwoofer Output.
doesn't work unless I put white cable in subwoofer and red into red speaker port then only one speak...
doesn't work unless I put white cable in subwoofer and red into red speaker port then only one speak...
(Posted by cmjdennis 3 years ago)
Pairing
i try to pair this with my phone but the screen on the Pyle switches from "BLUE" to "CALL" without p...
i try to pair this with my phone but the screen on the Pyle switches from "BLUE" to "CALL" without p...
(Posted by aurorabds 4 years ago)
Support Question
How do you change the radio station on the actual FM Transmitter so it wont be staticky?
How do you change the radio station on the actual FM Transmitter so it wont be staticky?
(Posted by torilynn13 6 years ago)
No Am Radio Reception.
I have no AM radio reception. I installed the stereo in a 1997 Pontiac Bonneville SE.
I have no AM radio reception. I installed the stereo in a 1997 Pontiac Bonneville SE.
(Posted by kadavis418 8 years ago)