Bank 2

If the Bank 2 power light on your Panamax power conditioner is not on, there may be several possible causes. Here are a few troubleshooting steps you can try:

1. Check the power source: Ensure that the power outlet that the Panamax unit is connected to is functioning properly. Try plugging in another device to confirm that power is available.
2. Check the power cord: Ensure that the power cord is firmly connected to the Panamax unit and the power outlet. Also, check that the cord is not damaged or frayed. If the cord is damaged, replace it with a new one.
3. Check the circuit breaker: Check to see if the circuit breaker on the back of the Panamax unit has tripped. If it has, reset the breaker and try turning on the power again.
4. Check the bank switch: Make sure that the bank switch for Bank 2 is turned on. The switch is located on the front of the Panamax unit, near the Bank 2 outlets.
5. Check the load: Ensure that the devices connected to Bank 2 are not drawing too much power. The Panamax unit has a maximum load capacity, and if it is exceeded, the unit will shut off power to the outlets to prevent damage.

If none of these steps resolves the issue, there may be a problem with the Panamax unit itself. In this case, you may need to contact Panamax customer support for further assistance.

---

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!