Panamax M4315-PRO Support Question
Panamax M4315-PRO Support Question
Find answers below for this question about Panamax M4315-PRO.Need a Panamax M4315-PRO manual? We have 3 online manuals for this item!
Question posted by mrxiongchris on November 9th, 2022
Panamax M4315-pro Defective Part
had troubleshoot and found the defective part, where can I find, order the small pcb that was attached behind the front control pcb.
Current Answers
Answer #1: Posted by SonuKumar on November 9th, 2022 7:21 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,617,800
Member since:
May 9th, 2021 Points: 16,617,800
https://www.panamax.com/contact-us/
please fill the form
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Panamax M4315-PRO Manual Pages
Datasheet - Page 1
From Anywhere, 24/7.
www.panamax.com M4315-PRO & M4320-PRO
PROFESSIONAL HOME THEATER Power Management with Interactive Control and Real Time Monitoring
M4315-PRO
and
M4320-PRO
DEDICATED 15 AMP OR 20 AMP COMPONENTS
FEATURES:
M4315-PRO (15 Amp)
• Eight Fully Controllable/Programmable Outlets via BlueBOLT™ or RS-232C. • Linear Filtration with Four Isolated Outlet Banks &#...
Datasheet - Page 2
... other features are registered US trademarks of Panamax.
BlueBOLT™ The serial port allows communication between the M4315-PRO & an automation, control, or web browser. Phone Jack Protection circuit for the M4315-PRO & M4320-PRO. BlueB LT Why roll a truck when you can
™
reboot from anywhere at anytime! Online Remote Power Management for Home Theater Systems
PROVIDES...
Manual - Page 1
...Power Cord • AVM & Protect-or-Disconnect Circuitry
Important: You will need the BlueBOLT-CV1's unique MAC address and challenge key (provided on the 2 labels attached to the Quick Start Guide and the other is included in the M4315-PRO...
15 A
Power Management with Control System Interactive Functionality.
• 15 Amp Capacity M4315-PRO • 8 Individually Controllable Rear Panel ...
Manual - Page 2
...™ is included, providing secure, hosted IP system control and monitoring for shelf mounting.
3. RS-232 Card (Included not installed)
RS232
2. Introduction
Thank you for purchasing a Panamax M4315-PRO Power Management with cup washers for rack mounting.
® 2010 Panamax LLC, 1690 Corporate Circle, Petaluma, CA 94954 • www.panamax.com • 707-283-5900 • Fax...
Manual - Page 3
... & Under Voltage Protection (AVM): Panamax's patented power monitoring circuitry constantly monitors the AC line voltage for custom applications. The M4315-PRO will need to be plugged into the Switched Outlet Banks to control complex A/V systems from 0 Hz to damaging spikes and surges.
This feature provides an ON/OFF trigger for this power signal will meet the...
Manual - Page 4
...exit from being walked on , unless the circuit breaker is displayed. Protect the power cord from the apparatus . 11. Only use this apparatus to OFF (the ...panel brightness control, and press to OFF.
Important Safety Instructions
1. Keep these instructions. 2. WARNING: Do not use attachments/accessories specified by ---. Contains Always On Receptacles. Disconnect M4315-PRO from ...
Manual - Page 5
... sec)→7(on)→(20 sec)→8 (on)
DC TRIGGER OFF: 8(off)→(20 sec)→7(off)→(30 sec)→5(off)
PROFILE 4 (P4)
NETWORK + CONTROL DELAYS OUTLET SEQUENCING (profile P4, by outlet #s):
With switching on and off BREAKER or holding both REBOOT buttons. Start up : 1→(10 sec)→2→...
Manual - Page 6
... 3
BANK 2
BANK 1
4.
5.
6.
7.
1.
BlueBOLT-CV1
DC TRIGGER
O
U
IN
T
TELCO
1.
2. Power inlet: M4315-PRO (120 Vac/15 A, IEC 320 C14) do not remove steel retention clip. OUTLET 5
OUTLET 4
OUTLET 3
OUTLET...1 CATV / SAT 1 CATV / SAT 2
FILTER BANK 2
FILTER BANK 1
LAN CAT 5e
9.
8. Ground lug: connect to Panamax MOD-series signal protection module
grounding busses with 14 AWG (
Manual - Page 7
...your web browser. example www.panamax.com.
Power on M4315-PRO. (Note: adding a device to create an account and/or take control of your browser is operated through protection port on M4315-PRO. T 6
OUTLET 5
FILTER BANK 3
Step 3.
Connect network Ethernet cable from the M4315-PRO back to 60 seconds), please follow the on-screen troubleshooting guide.
Also confirm an...
Manual - Page 9
... the M4315-PRO and the
controller hardware:
1.1.1 COMMAND: A message sent to be applied in the form of this pin. Some commands require a parameter to the M4315-PRO unit from the command
with your M4315-PRO via direct connection using thumbscrews. Response strings start with an exclamation point (!, 21h, 33d). M4315-PRO transmits data on this Panamax M4315-PRO component...
Manual - Page 10
...To clear triggers the NONE command must be controlled by this trigger. TRIGIN
= Trigger on outlet 2) Immediately switches outlet to the M4315-PRO unit. Note: Responses are valid, and no...GREEN MODE
3.1 REBOOT 1
3.1.1 Command:
3.1.2 Action
3.1.3 Response:
!REBOOT_1
Power cycle the outlets controlled by this trigger Has the same effect as if someone pressed the reboot ...
Manual - Page 11
...
FEEDBACK = ON LINEFEED = ON PROFILE = 1
3.11.3 Response:
$FACTORY SETTINGS RESTORED
3.12 SET PROFILE Sets all responses will be sent to the controller every time the status of an input (i.e. outlet) or power state (i.e. When ON, each response. trigger), output (i.e. overvoltage) changes. and turn on delay to 5 sec. triggers, delays, feedback mode, & linefeed...
Manual - Page 12
...
4.0 IDENTIFY Request that the unit identify itself.
4.0.1 Query:
?ID
4.0.2 Response:
$PANAMAX $MAX 4315-PRO $FIRMWARE: revision
4.1 FAULT STATUS Request the on/off status of the outlets and output... = status $OUTLET7 = status $OUTLET8 = status
status = { ON, OFF }
4.4 POWER STATUS Request the status of the input voltage.
4.4.1 Query: ?POWERSTAT
4.4.2 Response: if input...
Manual - Page 13
..., a message will be sent
indicating the status of the indicator.
5.7.2 Message: $BREAKER = status
5.7.3 Condition: When a wire fault is detected a message will be sent to the controller.
5.2.2 Message
For BUTTON_1 press:
$BUTTON_1 = TRIGGERED
For BUTTON_2 press:
$BUTTON_2 = TRIGGERED
If input trigger is switched ON: $TRIGIN = ON
If trigger input is switched OFF...
Manual - Page 14
...Specifications subject to change due to comply with the instructions, may also email info@Panamax.com. If this equipment does cause harmful interference to provide reasonable protection against damage...not expressly approved by one or more of the problem.
M4315-PRO Specifications
AC Power Line Voltage 120V, 60Hz Isolated Banks 4 Voltage Regulation No Total Outlets 9 Outlets...
Quick Start Guide - Page 1
Quick Start Guide HOME THEATER POWER MANAGEMENT
M4315-PRO & M4320-PRO
Guía de inicio rápido • Guide de démarrage rapide
MODEL: M4315-PRO (15 AMP)
M4315-PRO
REBOOT 1
REBOOT 2
1
2
...panamax.com / Products / A/V Components / M4315-PRO or M4320-PRO / Manual
Important: You will need the BlueBOLT-CV1's unique MAC Address and Challenge Key (provided on the 2 labels attached...
Quick Start Guide - Page 2
... then 50, and terminated by an external control (through the COMMUNICATIONS CARD). Do not install ...power-up to 2 minutes for DHCP to assign the address, or for the BlueBOLT-CV1 card to this guide, the box should contain the following:
VOLTS
15 A
M4315-PRO
BlueB LT
1 M4315-PRO or M4320-PRO unit
2 Four #10-24x½" Philips pan
head screws with a protective earthing connection. www.panamax...
Quick Start Guide - Page 3
...
FILTER BANK 3
3-B
1.
2.
3-A
3.
1. OUTLET 4
OUTLET 3
OUTLET 2
OUTLET 1
BlueBOLT-CV1
9. M4320-PRO (120 Vac/20 A, IEC 320 C20) do not remove steel retention clip. REAR PANEL FEATURE OVERVIEW
OUTLET 8
OUTLET 7
AC INLET
OUTLET 8
OUTLET 7
OUTLET 6
OUTLET 5
FILTER BANK 4
M4320-PRO
GROUND FILTER BANK 4 -
Power inlet: M4315-PRO (120 Vac/15 A, IEC 320 C14) do not remove steel...
Quick Start Guide - Page 8
G 5/10 Quick Start Guide HOME THEATER POWER MANAGEMENT
M4315-PRO & M4320-PRO
Guía de inicio rápido • Guide de démarrage rapide
MODEL: M4315-PRO (15 AMP)
M4315-PRO
REBOOT 1
REBOOT 2
1
2
OUTLET STATUS
3
4
5
6
7
8...;tes en ligne à:
www.panamax.com / Products / A/V Components / M4315-PRO or M4320-PRO / Manual
1690 Corporate Circle, Petaluma CA 94954 • www...
Similar Questions
Have A Panamax Good Power In No Power Out
so bought a Panamax m5400-pm plugged into wall the power in reads 123v plugged items into it read no...
so bought a Panamax m5400-pm plugged into wall the power in reads 123v plugged items into it read no...
(Posted by Anonymous-167668 3 years ago)
Panamax M5300-pm Reading 123 Volts 0 Amps Not Powering Anything Plugged In.
Was playing ps4, have owned the unit for years no issues, shut everything off wont power anything ba...
Was playing ps4, have owned the unit for years no issues, shut everything off wont power anything ba...
(Posted by wht2hab 3 years ago)
Power
I just bought the unit and plugged everything in according to the directions. Once i powered the uni...
I just bought the unit and plugged everything in according to the directions. Once i powered the uni...
(Posted by andy33566 7 years ago)
Briefly Lost Power & Now Has 2 Orange Lights Displayed
What Should I Do?
(Posted by Vickisofie10 11 years ago)
Panamax Miw-power-pro-pfp 50volt Ground Leakage
Hi, im installing a Panamax MIW-POWER-PRO-PFP and have connected the neutral wire(white) and the hot...
Hi, im installing a Panamax MIW-POWER-PRO-PFP and have connected the neutral wire(white) and the hot...
(Posted by mozzer24 12 years ago)