Onkyo M-504 Support Question
Onkyo M-504 Support Question
Find answers below for this question about Onkyo M-504.Need a Onkyo M-504 manual? We have 1 online manual for this item!
Question posted by corealignjak on December 24th, 2021
I Need My M-504 Repaired. Any Recommendations?
Amp lights up and powers on but no sound
Current Answers
Answer #1: Posted by SonuKumar on December 25th, 2021 7:52 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://www.manualslib.com/manual/302391/Onkyo-M-504.html#manual
https://elektrotanya.com/onkyo_m-504_sm.pdf/download.html
try to reset the product.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Onkyo M-504 Manual Pages
Owner Manual - Page 1
Copy the serial number and model number onto your warranty card and keep it in Sound
504
Stereo Power Amplifier
Instruction Manual
"WARNING" "TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE."
01%TKVO.
• ...
Owner Manual - Page 2
... situated so that may impede the flow of uninsulated "dangerous voltage" within an equilateral triangle is intended to alert the user to a power supply only of an appliance is recommended by the manufacturer.
7. The appliance does not appear to rain; All other appliances (including amplifiers) that may damage the finish or remove...
Owner Manual - Page 4
... with the speaker leads or the power cord. It goes out again if the protection circuits are not recommended because the resulting higher speaker lead impedance will adversely affect sound quality. The left channel terminals at... capacity.
• As the M-504 is very high, so be the same length and as short as possible.
• Be careful not to plug it lights. If you wish to listen to...
Owner Manual - Page 5
...
1.4•4 OE RISQUE OE DOC FLECTROA•uom
Right speaker
n 4 4
OOOOOOO
Caution: • Do not plug in the pow-
AC outlet (Maximum
O
output 100 W)
AC power supply cord
Left speaker
0O
O er cord until all other connections have been completed and checked.
Owner Manual - Page 6
...failure occurs in the amplifier resulting in the appearance of hum, howling and other components.
- 6- Note that there is plugged into the socket. This is activated...504 is a DC amplifier incorporating a Super Servo system, DC voltage is designed to make sure that when the power cord is always no sound from affecting sound quality, this is an input signal from the power cord and power...
Owner Manual - Page 7
... distortion:
Intermodulation distortion:
Frequency response: Input sensitivity: Input impedance: Damping factor: S/N ratio: Outputs:
Inputs: Power supply: Dimensions:
Weight:
165 watts per channel, into 8 ohms at 1 kHz, 0.003% THD
0.003% at rated power 0.003% at 1 watt output
0.003% at rated power 0.003% at 1 watt output +0, - 1.5 dB at 1Hz - 100 kHz 1V 20 kohms 140...
Similar Questions
Onkyo Pr-sc885 Hdni Board.
i need a new or refurbished HDMI board for my Onkyo PR-SC885. I believe the part number is .1B170514...
i need a new or refurbished HDMI board for my Onkyo PR-SC885. I believe the part number is .1B170514...
(Posted by forqii 7 months ago)
Have 5 Speakers And 5 Small Cinema Speakers,1 Bose Center But Only Have 2 Wires?
Good morningWhat is the recommendation to use all the speakers with wires? Or the best custom setup ...
Good morningWhat is the recommendation to use all the speakers with wires? Or the best custom setup ...
(Posted by ballerg44 2 years ago)
No Video Output On Power Up. Why?
When I power on my system, there is no video output on the first try(ONKYO logo does not display and...
When I power on my system, there is no video output on the first try(ONKYO logo does not display and...
(Posted by mitchpatenaude 8 years ago)
Onkyo M-504 Powers On But No Sound
Powers on but protection/servo light/relay kicks off so there is no sound, cant find anything burnt ...
Powers on but protection/servo light/relay kicks off so there is no sound, cant find anything burnt ...
(Posted by lifesguru 11 years ago)
Part Missing On Amplifier M-504
I have a Onkyo M-504 since more than 25 years and recently lost the cap on top of the "Power" on/off...
I have a Onkyo M-504 since more than 25 years and recently lost the cap on top of the "Power" on/off...
(Posted by eugeneviskovic 11 years ago)